Kinetic theory effects

We will almost always treat the case of a dilute gas, and almost always consider the approximation that the gas particles obey classical, Flarniltonian mechanics. The effects of quantirm properties and/or of higher densities will be briefly commented upon. A number of books have been devoted to the kinetic theory of gases. Flere we note that some... 

The current frontiers for the subject of non-equilibrium thennodynamics are rich and active. Two areas dommate interest non-linear effects and molecular bioenergetics. The linearization step used in the near equilibrium regime is inappropriate far from equilibrium. Progress with a microscopic kinetic theory [38] for non-linear fluctuation phenomena has been made. Carefiil experiments [39] confinn this theory. Non-equilibrium long range correlations play an important role in some of the light scattering effects in fluids in far from equilibrium states [38, 39]. 

Many additional refinements have been made, primarily to take into account more aspects of the microscopic solvent structure, within the framework of diffiision models of bimolecular chemical reactions that encompass also many-body and dynamic effects, such as, for example, treatments based on kinetic theory [35]. One should keep in mind, however, that in many cases die practical value of these advanced theoretical models for a quantitative analysis or prediction of reaction rate data in solution may be limited. 

During the nineteenth century the growth of thermodynamics and the development of the kinetic theory marked the beginning of an era in which the physical sciences were given a quantitative foundation. In the laboratory, extensive researches were carried out to determine the effects of pressure and temperature on the rates of chemical reactions and to measure the physical properties of matter. Work on the critical properties of carbon dioxide and on the continuity of state by van der Waals provided the stimulus for accurate measurements on the compressibiUty of gases and Hquids at what, in 1885, was a surprisingly high pressure of 300 MPa (- 3,000 atmor 43,500 psi). This pressure was not exceeded until about 1912. 

In contrast molecular interaction kinetic studies can explain and predict changes that are brought about by modifying the composition of either or both phases and, thus, could be used to optimize separations from basic retention data. Interaction kinetics can also take into account molecular association, either between components or with themselves, and contained in one or both the phases. Nevertheless, to use volume fraction data to predict retention, values for the distribution coefficients of each solute between the pure phases themselves are required. At this time, the interaction kinetic theory is as useless as thermodynamics for predicting specific distribution coefficients and absolute values for retention. Nevertheless, it does provide a rational basis on which to explain the effect of mixed solvents on solute retention. 

We now carry the argument over to transition state theory. Suppose that in the transition state the bond has been completely broken then the foregoing argument applies. No real transition state will exist with the bond completely broken—this does not occur until the product state—so we are considering a limiting case. With this realization of the very approximate nature of the argument, we make estimates of the maximum kinetic isotope effect. We write the Arrhenius equation for the R-H and R-D reactions... 

A more rigorous theory of kinetic isotope effects begins with the transition state equation k = (kTlh)K. Writing this for and ito leads to... 

There is a restriction on this simple model for the C0-N02 reaction. According to the kinetic theory of gases, for a reaction mixture at 700 K and concentrations of 0.10 M, every CO molecule should collide with about 109 N02 molecules in one second. If every collision were effective, the reaction should be over in a fraction of a second. In reality, this does not happen under these conditions, the half-life is about 10 s. This implies that not every CO-N02 collision leads to reaction. 

When mass transfer rates are very high, limitations may be placed on the rate at which a component may be transferred, by virtue of the limited frequency with which the molecules collide with the surface. For a gas, the collision rate can be calculated from the kinetic theory and allowance must then be made for the fact that only a fraction of these molecules may be absorbed, with the rest being reflected. Thus, when even a pure gas is brought suddenly into contact with a fresh solvent, the initial mass transfer rate may be controlled by the rate at which gas molecules can reach the surface, although the resistance to transfer rapidly builds up in the liquid phase to a level where this effect can be neglected. The point is well illustrated in Example 10.4. 

Solvolytic experiments specifically designed to test Bartell s theory were carried out by Karabatsos et al. (1967), who were primarily interested in an assessment of the relative contributions of hyperconjugation and non-bonded interactions to secondary kinetic isotope effects. Model calculations of the (steric) isotope effect in the reaction 2- 3 were performed, as well as that in the solvolyses of acetyl chloride... 

In addition to the magnetic differences between the deuteron and proton, however, their mass difference may also cause observable effects. A well known example is found in the theory of chemical reactions, where the so called kinetic isotope effects (KIE s) are an important source of information about reaction mechanisms. Also in the field of ESR, such effects may arise, although these have been much less studied than the KIE s. 

Transition state theory has been useful in providing a rationale for the so-called kinetic isotope effect. The kinetic isotope effect is used by enzy-mologists to probe various aspects of mechanism. Importantly, measured kinetic isotope effects have also been used to monitor if non-classical behaviour is a feature of enzyme-catalysed hydrogen transfer reactions. The kinetic isotope effect arises because of the differential reactivity of, for example, a C-H (protium), a C-D (deuterium) and a C-T (tritium) bond. 

The only (to the best of our knowledge) theoretical treatment of hydrogen transfer by tunnelling to explicitly recognise the role of protein dynamics, and relate this in turn to the observed kinetic isotope effect, was described by Bruno and Bialek. This approach has been termed vibration-ally enhanced ground state tunnelling theory. A key feature of this theory... 

Clearly, then, the chemical and physical properties of liquid interfaces represent a significant interdisciplinary research area for a broad range of investigators, such as those who have contributed to this book. The chapters are organized into three parts. The first deals with the chemical and physical structure of oil-water interfaces and membrane surfaces. Eighteen chapters present discussion of interfacial potentials, ion solvation, electrostatic instabilities in double layers, theory of adsorption, nonlinear optics, interfacial kinetics, microstructure effects, ultramicroelectrode techniques, catalysis, and extraction. 

Conventional bulk measurements of adsorption are performed by determining the amount of gas adsorbed at equilibrium as a function of pressure, at a constant temperature [23-25], These bulk adsorption isotherms are commonly analyzed using a kinetic theory for multilayer adsorption developed in 1938 by Brunauer, Emmett and Teller (the BET Theory) [23]. BET adsorption isotherms are a common material science technique for surface area analysis of porous solids, and also permit calculation of adsorption energy and fractional surface coverage. While more advanced analysis methods, such as Density Functional Theory, have been developed in recent years, BET remains a mainstay of material science, and is the recommended method for the experimental measurement of pore surface area. This is largely due to the clear physical meaning of its principal assumptions, and its ability to handle the primary effects of adsorbate-adsorbate and adsorbate-substrate interactions. 

As a first approximation, we can introduce wall collisions by simply introducing separate effectiveness parameters for molecule-molecule and molecule-wall collisions, in which fV3il can be described through kinetic theory as... 

This result is identical to that obtained in elementary kinetic theory. There is, in effect a contribution of RT to the energy per mole for each of the three directions in space. Furthermore, this result allows the identification /J = 1 fkTy as suggested earlier. 

---