Labelling isotopic, using bases

In order to ensure the activity of compost inoculum, inert material which works as soil texture is mixed into compost inoculum. The carbon dioxide evolved from the test vessel is determined by using gravimetric analysis of carbon dioxide absorbent. The method which consists of a closed system to capture evolved carbon dioxide, is available to determine the ultimate aerobic biodegradability of plastic materials under controlled composting conditions in a laboratory-scale test. The valuable information of degradation on the molecular structure of copolymers can frequently be obtained by means of isotopic labelling studies based on this test method of a closed system. 

An important breakthrough in HTS ee assays came from the group of Reetz in late 1990, with the introduction of mass spectroscopy (MS)-based procedures [90]. These methods use special asymmetrically isotope-labeled compounds. Enzymatic transformations of these compounds usually lead to two pseudoenantiomeric compounds whose relative concentration can be estimated using MS techniques. 

A dual isotope labeling technique [85] has been used to measure membrane permeability in plant cells, based on the selective permeabiHty of the membranes of living cells to tritiated water and carbon-14 labeled mannitol. Kieran [29] showed that the results of the dual isotope labeling and Evan s Blue staining methods correlated well as indicators of cell viability however, the latter was preferable in terms of reagent cost and ease of analysis. 

Characterization of various types of damage to DNA by oxygen-derived species can be achieved by the technique of gas chromatography-mass spectrometry (GC-MS), which may be applied to DNA itself or to DNA-protein complexes such as chromatin (Dizdaroglu, 1991). For GC-MS, the DNA or chromatin is hydrolysed (usually by heating with formic acid) and the products are converted to volatile derivatives, which are separated by gas chromatography and conclusively identified by the structural evidence provided by a mass spectrometer. Stable isotope-labelled bases may be used as internal standards... 

Exchange reactions between bulk and adsorbed substances can be studied by on-line mass spectroscopy and isotope labeling. In this section the results on the interaction of methanol and carbon monoxide in solution with adsorbed methanol and carbon monoxide on platinum are reported [72], A flow cell for on-line MS measurements (Fig. 1.2) was used. 13C-labeled methanol was absorbed until the Pt surface became saturated. After solution exchange with base electrolyte a potential scan was applied. Parallel to the current-potential curve the mass intensity-potential for 13C02 was monitored. Both curves are given in Fig. 3.1a,b. A second scan was always taken to check the absence of bulk substances. 

It is also important to note that matrix-related effects, either signal enhancement or more commonly signal suppression, can have a pronounced effect on quantitative measurements. Based on these observations, the use of isotope-labeled standards is helpful to achieve accurate analytical measurement data on the diastereoisomers. Several methods found in the open literature include use of both 13C-labeled and d18-labeled surrogates as recovery and/or instrument standards [118],... 

FIGURE 15.3 Outline of experimental protocol used for ICAT differential protein expression profiling. Protein mixtures from two cell populations are labeled with light or heavy isotopic versions of a cleavable ICAT reagent. Labeled proteins are combined, subject to multidimensional separation by SCX, RP, and avidin affinity chromatography, then analyzed by tandem MS for peptide and protein identification. Based on the relative ratio of the two isotopically labeled peptides, a relative abundance of protein expression can be determined. 

Isotope fractionation between the vapor phase and the dissolved aqueous phase has been studied only for toluene and trichloroethylene (carbon only [545, 690]). Fractionation associated with adsorption has been quantified only for toluene in regard to sample extraction using a poly(dimethylsilo-xane)-coated solid-phase microextraction fiber [373] and qualified for benzene, toluene, and ethylbenzene based on high-pressure liquid chromatography analyses of isotopically labeled and unlabeled compounds (carbon and hydrogen [692]). Isotope fractionation associated with the reductive dechlorination of chlorinated ethylenes by zero-valent iron and zinc has been... 

---