Mossbauer spectroscopy isomer shifts

A unique situation is encountered if Fe-M6ssbauer spectroscopy is applied for the study of spin-state transitions in iron complexes. The half-life of the excited state of the Fe nucleus involved in the Mossbauer experiment is tj/2 = 0.977 X 10 s which is related to the decay constant k by tj/2 = ln2/fe. The lifetime t = l//c is therefore = 1.410 x 10 s which value is just at the centre of the range estimated for the spin-state lifetime Tl = I/Zclh- Thus both the situations discussed above are expected to appear under suitable conditions in the Mossbauer spectra. The quantity of importance is here the nuclear Larmor precession frequency co . If the spin-state lifetime Tl = 1/feLH is long relative to the nuclear precession time l/co , i.e. Tl > l/o) , individual and sharp resonance lines for the two spin states are observed. On the other hand, if the spin-state lifetime is short and thus < l/o) , averaged spectra with intermediate values of quadrupole splitting A q and isomer shift 5 are found. For the intermediate case where Tl 1/cl , broadened and asymmetric resonance lines are obtained. These may be the subject of a lineshape analysis that will eventually produce values of rate constants for the dynamic spin-state inter-conversion process. The rate constants extracted from the spectra will be necessarily of the order of 10 -10 s"F... 

For a comparison of experimental Mossbauer isomer shifts, the values have to be referenced to a common standard. According to (4.23), the results of a measurement depend on the type of source material, for example, Co diffused into rhodium, palladium, platinum, or other metals. For Fe Mossbauer spectroscopy, the spectrometer is usually calibrated by using the known absorption spectrum of metallic iron (a-phase). Therefore, Fe isomer shifts are commonly reported relative to the centroid of the magnetically split spectrum of a-iron (Sect. 3.1.3). Conversion factors for sodium nitroprusside dihydrate, Na2[Fe(CN)5N0]-2H20, or sodium ferrocyanide, Na4[Fe(CN)]6, which have also been used as reference materials, are found in Table 3.1. Reference materials for other isotopes are given in Table 1.3 of [18] in Chap. 1. 

From the applications of Ni Mossbauer spectroscopy in solid-state research, it is clear that (1) information from isomer shift studies is generally not very reliable because of the smallness of the observed isomer shifts and the necessity of SOD shift corrections which turn out to be difficult, and (2) useful information about magnetic properties and site symmetry is obtained from spectra reflecting magnetic and/or quadrupolar interactions. 

Two other publications on Ir (73 keV) Mossbauer spectroscopy of complex compounds of iridium have been reported by Williams et al. [291,292]. In their first article [291], they have shown that the additive model suggested by Bancroft [293] does not account satisfactorily for the partial isomer shift and partial quadrupole splitting in Ir(lll) complexes. Their second article [292] deals with four-coordinate formally lr(l) complexes. They observed, like other authors on similar low-valent iridium compounds [284], only small differences in the isomer shifts, which they attributed to the interaction between the metal-ligand bonds leading to compensation effects. Their interpretation is supported by changes in the NMR data of the phosphine ligands and in the frequency of the carbonyl stretching vibration. 

We have learned from the preceding chapters that the chemical and physical state of a Mossbauer atom in any kind of solid material can be characterized by way of the hyperfine interactions which manifest themselves in the Mossbauer spectrum by the isomer shift and, where relevant, electric quadrupole and/or magnetic dipole splitting of the resonance lines. On the basis of all the parameters obtainable from a Mossbauer spectrum, it is, in most cases, possible to identify unambiguously one or more chemical species of a given Mossbauer atom occurring in the same material. This - usually called phase analysis by Mossbauer spectroscopy - is nondestructive and widely used in various kinds of physicochemical smdies, for example, the studies of... 

Mossbauer spectroscopy is particularly suitable to study ST since (1) the spectral parameters associated with the HS and LS states of iron(II) clearly differ and (2) the time-scale of the technique ( 10 s) allows the detection of the separate spin states in the course of the transition. Typically, Mossbauer spectra of HS iron(II) show relatively high quadrupole splitting (AEq 2-3 mm s ) and isomer shift (3 1 mm s ), while for LS iron(II), these parameters are generally smaller (AEq < 1 mm s 3 < 0.5 mm s ). Among the early applications of Mossbauer spectroscopy to study ST phenomena in iron(II) complexes is the work of Dezsi et al. [7] on [Fe (phen)2(NCS)2] (phen = 1,10-phenanthroline) as a function of temperature (Fig. 8.2). The transition from the HS ( 12) state (quadrupole doublet of outer two lines with AEq 3 mm s ) to the LS CAi) state (quadrupole... 

Although in most of the above reports structural information is based on X-ray data, Au Mossbauer spectroscopy has also been successfully employed for the investigation of two-, three-, and four-coordination in gold(I) complexes.2551 An increase in coordination numbers leads to a decrease in the isomer shift (IS) by 1-2mm s 1 (three-coordination) or 2-4mm s 1 (four-coordination) relative to two-coordination. For the same ligands, the quadrupole splitting (QS) for three-coordinated complexes is expected to be very similar to that for the two-coordinate derivatives, while that for complexes with Td symmetry should be zero. 

The oxidation state of the central iron ions in the neutral species [FeL], as well as their monocation and dicationic oxidation products, [Fe(L )]+ and [Fe(L )]2+, are amenable to direct measurement by Mossbauer spectroscopy where the isomer shift gives direct information for the dn electron configuration, provided that the coordination number and the nature of the donor atoms are invariant. Frozen acetonitrile solutions of the above 57Fe enriched species have been investigated by this technique (147). 

The Mossbauer spectroscopy cell used in this investigation has been described in detail elsewhere (9). The Mossbauer spectroscopy instruments and the fitting routine used are also described elsewhere (9). All isomer shifts are reported relative to metallic iron at room temperature. 

Mossbauer Spectroscopy. Figure 1 shows room temperature Mossbauer emission spectra of two of the unsupported Co-Mo catalysts which we have studied in the present investigation. It is observed that the MES spectra of the two catalysts are quite different. For the catalyst with the low Co/Mo ratio (0.0625), a quadrupole doublet with an isomer shift of 6=0.33 mm/s and a quadrupole splitting of AE =1.12 mm/s are observed (spectrum a). These parameters are very similar to those observed previously for the Co-Mo-S phase in other catalysts (6-9). Furthermore, the spectrum of an unsupported catalyst with Co/Mo = 0.15 is found to be essentially identical to spectrum (a). The MES spectrum (b) of the catalyst with Co/Mo =... 

In the following section, we describe the case of adsorption of a Sn complex onto a palladium oxide suspension. In an alkaline medium (a basic PdO hydrosol), chlorides in the SnCL complex are substituted in the coordination sphere of tin(IV) by hydroxo anions, which are in excess, yielding the stannate Sn(OH)g complex. The Sn Mossbauer spectroscopy spectrum of a bimetallic sol (frozen in liquid nitrogen) is compared with a true stannic solution. At the same tin concentration, it shows the changes in the Sn environment due to adsorption onto the PdO surface (Fig. 13.27). The isomer shift S is found to be close to zero for the stannate solution and increases when contacted with the PdO suspension, indicating a modification of the coordination sphere of tin. The increase in 5 can be correlated to an increase in the core level electronic density of tin. The quadrupole splitting A, is related to a modification of the symmetry of the close environment of tin, due to adsorption of Sn(OH)g complexes onto the PdO colloidal nanoparticles. 

---