Ionizing radiation types

Main Ionizing Radiation Types and Their Interaction with Matter... 

The theory of radiation-induced grafting has received extensive treatment. The direct effect of ionizing radiation in material is to produce active radical sites. A material s sensitivity to radiation ionization is reflected in its G value, which represents the number of radicals in a specific type (e.g., peroxy or allyl) produced in the material per 100 eV of energy absorbed. For example, the G value of poly(vinyl chloride) is 10-15, of PE is 6-8, and of polystyrene is 1.5-3. Regarding monomers, the G value of methyl methacrylate is 11.5, of acrylonitrile is 5.6, and of styrene is >0.69. 

Relative Biological Effectiveness (RBE)—The RBE is a factor used to compare the biological effectiveness of absorbed radiation doses (i.e., rad) due to different types of ionizing radiation. More specifically, it is the experimentally determined ratio of an absorbed dose of a radiation in question to the absorbed dose of a reference radiation (typically 60Co gamma rays or 200 keV x rays) required to produce an identical biological effect in a particular experimental organism or tissue (see Quality Factor). 

The numerical combination of protons and neutrons in most nuclides is such that the nucleus is quantum mechanically stable and the atom is said to be stable, i.e., not radioactive however, if there are too few or too many neutrons, the nucleus is unstable and the atom is said to be radioactive. Unstable nuclides undergo radioactive transformation, a process in which a neutron or proton converts into the other and a beta particle is emitted, or else an alpha particle is emitted. Each type of decay is typically accompanied by the emission of gamma rays. These unstable atoms are called radionuclides their emissions are called ionizing radiation and the whole property is called radioactivity. Transformation or decay results in the formation of new nuclides some of which may themselves be radionuclides, while others are stable nuclides. This series of transformations is called the decay chain of the radionuclide. The first radionuclide in the chain is called the parent the subsequent products of the transformation are called progeny, daughters, or decay products. 

One can see by the complexity of these types of manufacturing procedures that much care and attention to detail must be maintained by the manufacturer. This sterile manufacturing procedure must then be validated to prove that no more than 3 containers in a lot of 3000 containers (0.1%) are nonsterile. Ultimately, it is the manufacturer s responsibility to ensure the safety and efficacy of the manufacturing process and the absence of any adverse effect on the product, such as the possible formation of substances toxic to the eye, an ever-present possibility with gas sterilization or when using ionizing radiation. For ophthalmic products sterilized by terminal sterilization (sterilization in the final sealed container, e.g., steam under pressure), the sterilization cycle must be validated to ensure sterility at a probability of 106 or greater. 

Hultqvist, B., Studies on naturally occurring ionizing radiations with special reference to radiation doses in Swedish houses of various types, Kungl. Svenska Vetenskapsakademins handlingar, Ser 4, Band 6, Nr 3, Stockholm, Sweden (1956). 

Smirnova and coworkers studied the influence of various types of ionizing radiations on the physiomechanical characteristics of a statistical polymer of butadiene and acrylonitrile137. Although the polymer is a statistical polymer, the nature of its thermo-mechanical curve indicates a block nature of the polymeric basis of the rubber there is a... 

Radiation weighting factors for various types of ionizing radiations... 

---