Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Initiation control

Vector of indices for the components (I = 1, N) integer initialization control variable (KEY =... [Pg.295]

Fig. 15.2. Initiation-controlled high-cycle fatigue - Basquin s Law. Fig. 15.2. Initiation-controlled high-cycle fatigue - Basquin s Law.
Fig. 15.4. Initiation-controlled low-cycle fatigue - the Coffin-Manson Law... Fig. 15.4. Initiation-controlled low-cycle fatigue - the Coffin-Manson Law...
Fig. 15.5. Goodman s Rule - the effect of a tensile mean stress on initiation-controlled fatigue. Fig. 15.5. Goodman s Rule - the effect of a tensile mean stress on initiation-controlled fatigue.
Anderson, G. D., Initial Controller Settings to Use at Plant Startup, Chemical Engineering, July 11, 1983, p. 113. [Pg.327]

G. D. Anderson s article recommends initial controller settings for those control loops set on automatic rather than manual for a plant startup. For liquid level, the settings depend upon whether the sensor is a displacer type or differential pressure type, or a surge tank (or other surge) is installed in the process ... [Pg.327]

Equation (l) shows the rate of polymerization is controlled by the radical concentration and as described by Equation (2) the rate of generation of free radicals is controlled by the initiation rate. In addition. Equation (3) shows this rate of generation is controlled by the initiator and initiator concentration. Further, the rate of initiation controls the rate of propagation which controls the rate of generation of heat. This combined with the heat transfer controls the reaction temperature and the value of the various reaction rate constants of the kinetic mechanism. Through these events it becomes obvious that the initiator is a prime control variable in the tubular polymerization reaction system. [Pg.226]

Production of Malonyl-CoA Is the Initial Controlling Step in Fatty Acid Synthesis... [Pg.173]

Patients with complicated typhoid fever (i.e., metastatic foci, ileal perforation, etc.) should receive parenteral therapy with ciprofloxacin 400 mg twice daily or ceftriaxone 2000 mg once daily. Antimicrobial therapy can be completed with an oral agent after initial control of the symptoms of typhoid fever. In persons with AIDS and a first episode of Salmonella bacteremia, a longer duration of antibiotic therapy (1-2 weeks of parenteral therapy followed by 4 weeks of oral fluoroquinolone) is recommended to prevent relapse of bacteremia. [Pg.1120]

Initial control may require doses higher than those needed in maintenance. [Pg.631]

Chain-end initiation, 23 372 Chain-end initiator control, 20 303 Chain fluorosilicates, 12 636-637 Chain growth... [Pg.163]

Principles to Govern the Treatment of Germany in the Initial Control Period," No. 848, The Conference of Berlin (The Potsdam Conference), 1945, Foreign Relations of the United States, Diplomatic Papers, Volume II, United States Government Printing Office Washington, DC, 1960, pp 750-53,... [Pg.51]

Tab. 9.3 Specific surface modifications and SAM systems of particles or planar substrates for the surface-initiated controlled radical polymerization (CRSIP) of vinyl monomers. [Pg.424]

An initial controlled study of venlafaxine, a SNRI, indicated that it is as effective as sertraline for overall PTSD symptoms at a mean dose of approximately 225mg/day. [Pg.172]

Reduce dosage Reduce dosage as soon as initial control of symptoms is achieved. Maintenance dosage may be as low as % of the initial daily dosage. Do not exceed recommended dosage. Clinical improvement of acute diarrhea is usually observed within 48 hours. If clinical improvement of chronic diarrhea is not seen within 10 days after a maximum daily dose of 20 mg, symptoms are unlikely to be controlled by further use. [Pg.1417]


See other pages where Initiation control is mentioned: [Pg.290]    [Pg.293]    [Pg.299]    [Pg.303]    [Pg.310]    [Pg.319]    [Pg.326]    [Pg.330]    [Pg.334]    [Pg.721]    [Pg.246]    [Pg.330]    [Pg.276]    [Pg.192]    [Pg.204]    [Pg.232]    [Pg.1]    [Pg.150]    [Pg.115]    [Pg.639]    [Pg.110]    [Pg.308]    [Pg.314]    [Pg.172]    [Pg.126]    [Pg.401]    [Pg.63]    [Pg.181]    [Pg.199]    [Pg.328]    [Pg.108]    [Pg.116]    [Pg.133]    [Pg.87]   
See also in sourсe #XX -- [ Pg.225 ]




SEARCH



Block copolymers controlled initiation, scheme

Catalyst (Initiator) Site Control

Change Control Initiation

Control plan initial

Controlled initiation

Copolymer sequential, controlled initiation

Diffusion controlled reactions with initially separated reactants

Graft copolymers controlled initiation, scheme

Initial state control

Initiation conditions control

Initiator site control

Macromers, controlled initiation

Organotellurium compounds as initiators for controlled living radical polymerization

Surface-initiated controlled radical polymerization

Temperature control radical initiators

Topological Control from a Combination of Initiator and Postpolymerization Modification

© 2024 chempedia.info