Impulse products

IMPULSE PRODUCTION BY INJECTING FUEL-RICH COMBUSTION PRODUCTS 331... 

Oxidizers. The characteristics of the oxidizer affect the baUistic and mechanical properties of a composite propellant as well as the processibihty. Oxidizers are selected to provide the best combination of available oxygen, high density, low heat of formation, and maximum gas volume in reaction with binders. Increases in oxidizer content increase the density, the adiabatic flame temperature, and the specific impulse of a propellant up to a maximum. The most commonly used inorganic oxidizer in both composite and nitroceUulose-based rocket propellant is ammonium perchlorate. The primary combustion products of an ammonium perchlorate propellant and a polymeric binder containing C, H, and O are CO2, H2, O2, and HCl. Ammonium nitrate has been used in slow burning propellants, and where a smokeless exhaust is requited. Nitramines such as RDX and HMX have also been used where maximum energy is essential. 

Aluminum-containing propellants deflver less than the calculated impulse because of two-phase flow losses in the nozzle caused by aluminum oxide particles. Combustion of the aluminum must occur in the residence time in the chamber to meet impulse expectations. As the residence time increases, the unbumed metal decreases, and the specific impulse increases. The soHd reaction products also show a velocity lag during nozzle expansion, and may fail to attain thermal equiUbrium with the gas exhaust. An overall efficiency loss of 5 to 8% from theoretical may result from these phenomena. However, these losses are more than offset by the increase in energy produced by metal oxidation (85—87). 

Mode of Action. DDT and its analogues specifically affect the peripheral sense organs of insects and produce violent trains of afferent impulses that result in hyperactivity, convulsions, and paralysis. Death results from metaboHc exhaustion and the production of an endogenous neurotoxin. The very high lipophilic nature of these compounds faciUtates absorption through the insect cuticle and penetration to the nerve tissue. The specific site of action is thought to be the sodium channels of the axon, through inhibition of Ca " ATPase. 

To change an object s speed it is necessai y to exert a net force on it for some duration of time. The product of the force and the length of time it is applied is called the impulse and is the same as the change of momentum. Any increase in speed is directly projiortional to the impiulse and inversely proportional to its mass ... 

There are a number of basic forms of energy loads or impingement on products to which plastics react in a manner different from other materials. These dynamic stresses include loading due to impact, impulse, puncture, frictional, hydrostatic, and erosion. They have a difference in response and degree of response to other forms of stress. Analyzing these differences provides... 

In addition, it should exhibit a fairly high hysteresis level that would have the effect of dissipating the sharp mechanical impulse loads as heat. The material will develop heat due to the stress under cyclical load. Materials used are the elastomeric plastics used in the products or as a coating on products. 

The specific hiats of NPN product gases (primarily carbon monoxide and carbon dioxide) arising from combustion are Cp 0.346cal/g/° and Cv 0.252cal/g/° at 300°K. The specific impulse of these gases (calc at 400psi) is 155 lbs/thrust/lb/sec... 

The ratio of rocket thrust to propellant mass flow, commonly called the specific impulse (/9p) of the propellant, represents a measure of the force developed per unit mass flow of propellant. From Eq. (2), it is apparent that high propellant-flame temperatures and low molecular-weight combustion products are required to produce high 7sp. 

The field of modified electrodes spans a wide area of novel and promising research. The work dted in this article covers fundamental experimental aspects of electrochemistry such as the rate of electron transfer reactions and charge propagation within threedimensional arrays of redox centers and the distances over which electrons can be transferred in outer sphere redox reactions. Questions of polymer chemistry such as the study of permeability of membranes and the diffusion of ions and neutrals in solvent swollen polymers are accessible by new experimental techniques. There is hope of new solutions of macroscopic as well as microscopic electrochemical phenomena the selective and kinetically facile production of substances at square meters of modified electrodes and the detection of trace levels of substances in wastes or in biological material. Technical applications of electronic devices based on molecular chemistry, even those that mimic biological systems of impulse transmission appear feasible and the construction of organic polymer batteries and color displays is close to industrial use. 

Fig. 4.1 Hypothetical model of pathogenesis of pain in DSP. (1) Injury of peripheral nerve fibers due to multifocal inflammation and secreted macrophage activation products results in abnormal spontaneous activity of neighboring uninjured nociceptive fibers ( peripheral sensitization ). (2) Furthermore, the aberrant inflammatory response in DRG leads to alterations in neuronal sodium and calcium channel expression and ectopic impulse generation. (3) This results in central remodeling within the dorsal horn due to A-fiber sprouting and synaptic formation with pain fibers in lamina 11, and maintenance of neuropathic pain ( central sensitization ). Reproduced with permission from (Keswani et al. 2002)...

---