Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Hydroxyl reaction with formate

Regarding the degradation of PBDEs by white-rot fungi, the first evidence of their ability to degrade a PBDE compound corresponds to a study published by Hundt et al. [27], which studied the degradation of 4-bromo-BDE by Trametes versicolor. The degradation occurs initially by hydroxylation reaction with the possible formation of three different isomers of hydroxy-diphenyl ether followed... [Pg.247]

Some conclusions on the reaction mechanism may be drawn from the rate constants obtained. It was shown for hydroxyl reactions with saturated compounds (propane, for example) that the main reaction of OH was the hydrogen atom abstraction in the formation of water. This is an accepted point of view. However, another route is possible for reactions with unsaturated hydrocarbons, i.e., addition at the double bond. This is the case for the H atom with saturated compounds H reacts by abstraction, and with unsaturated ones by addition. [Pg.59]

This scheme of interrelated primary photochemical and subsequent radical reactions is comphcated by the back reaction of hydrogen atoms and hydroxyl radicals with formation of water (Fig. 7-16, reaction 2) or the dimerization of the latter with formation of hydrogen peroxide (Fig. 7-16, reaction 3). Furthermore, hydroxyl radicals are scavenged by hydroperoxyl radicals with formation of oxygen and water (Fig. 7-16, reaction 5) or by hydrogen peroxide to yield hydroperoxyl radicals and water (Fig. 7-16, reaction 4). In addition, hydroxymethyl radicals (HOCH ) formed by reaction 1 (Fig. 7-16) are able to dimerize with formation of 1,2-ethane-diole (Fig. 7-16, reaction 7) or they disproportionate to yield methanol and formaldehyde (Fig. 7-16, reaction 8). [Pg.212]

Partially hydroxylated silica clusters are able to interact at long distances by dipole-dipole interactions, followed by attraction. At short distances, reaction may occure without any chemical reaction barrier of ordinary siloxane bonds, if silica particles contain one-coordinated oxygen and/or three-coordinated silicon atoms at their surfaces. In any other cases, without a coverage of chemically active groups, silica particles are able to interact by surface hydroxyl groups with formation of H- onds (Figs. 5(3) and 5(4)). [Pg.733]

With aldehydes, primary alcohols readily form acetals, RCH(OR )2. Acetone also forms acetals (often called ketals), (CH2)2C(OR)2, in an exothermic reaction, but the equiUbrium concentration is small at ambient temperature. However, the methyl acetal of acetone, 2,2-dimethoxypropane [77-76-9] was once made commercially by reaction with methanol at low temperature for use as a gasoline additive (5). Isopropenyl methyl ether [116-11-OJ, useful as a hydroxyl blocking agent in urethane and epoxy polymer chemistry (6), is obtained in good yield by thermal pyrolysis of 2,2-dimethoxypropane. With other primary, secondary, and tertiary alcohols, the equiUbrium is progressively less favorable to the formation of ketals, in that order. However, acetals of acetone with other primary and secondary alcohols, and of other ketones, can be made from 2,2-dimethoxypropane by transacetalation procedures (7,8). Because they hydroly2e extensively, ketals of primary and especially secondary alcohols are effective water scavengers. [Pg.94]

The primary and secondary alcohol functionahties have different reactivities, as exemplified by the slower reaction rate for secondary hydroxyls in the formation of esters from acids and alcohols (8). 1,2-Propylene glycol undergoes most of the typical alcohol reactions, such as reaction with a free acid, acyl hahde, or acid anhydride to form an ester reaction with alkaU metal hydroxide to form metal salts and reaction with aldehydes or ketones to form acetals and ketals (9,10). The most important commercial appHcation of propylene glycol is in the manufacture of polyesters by reaction with a dibasic or polybasic acid. [Pg.366]

The resihency and dyeabihty of poly(vinyl alcohol) fibers is improved by a process incorporating -hydroxybenzaldehyde to provide a site for the formation of a stable Mannich base. Hydroxyl groups on the fiber are converted to acetal groups by -hydroxybenzaldehyde. Subsequent reaction with formaldehyde and ammonia or an alkylamine is rapid and forms a stable Mannich base that is attached to the polymer backbone (94). [Pg.508]

Sahcyhc acid can be converted to sahcyloyl chloride [1441 -87-8] hy reaction with thionyl chloride in boiling ben2ene. The formation of acyl haUde may also extend to reaction with the phenoHc hydroxyl. The reaction with phosphoms tri- and pentachlorides is not restricted to the formation of the acid chloride. Further interaction of the phosphoms haUde and the phenoHc hydroxyl results in the formation of the phosphoric or phosphorous esters. [Pg.284]

These products are characterized in terms of moles of substitution (MS) rather than DS. MS is used because the reaction of an ethylene oxide or propylene oxide molecule with ceUulose leads to the formation of a new hydroxyl group with which another alkylene oxide molecule can react to form an oligomeric side chain. Therefore, theoreticaUy, there is no limit to the moles of substituent that can be added to each D-glucopyranosyl unit. MS denotes the average number of moles of alkylene oxide that has reacted per D-glucopyranosyl unit. Because starch is usuaUy derivatized to a considerably lesser degree than is ceUulose, formation of substituent poly(alkylene oxide) chains does not usuaUy occur when starch is hydroxyalkylated and DS = MS. [Pg.489]

As chemists proceeded to synthesize more complicated stmctures, they developed more satisfactory protective groups and more effective methods for the formation and cleavage of protected compounds. At first a tetrahydropyranyl acetal was prepared, by an acid-catalyzed reaction with dihydropyran, to protect a hydroxyl group. The acetal is readily cleaved by mild acid hydrolysis, but formation of this acetal introduces a new stereogenic center. Formation of the 4-methoxytetrahy-dropyranyl ketal eliminates this problem. [Pg.2]

The same chemical mechanisms and driving forces presented for phenol-formaldehyde resins apply to resorcinol resins. Resorcinol reacts readily with formaldehyde to produce resins (Fig. 2) which harden at ambient temperatures if formaldehyde is added. The initial condensation reaction, in which A-stage liquid resins are formed, leads to the formation of linear condensates only when the resorcinol/formaldehyde molar ratio is approximately 1 1 [119]. This reflects the reactivity of the two main reactive sites (positions 4 and 6) of resorcinol [120]. However, reaction with the remaining reactive but sterically hindered site (2-positiori) between the hydroxyl functions also occurs [119]. In relation to the weights of resorcinol-formaldehyde condensates which are isolated and on a molar basis, the proportion of 4- plus 6-linkages relative to 2-linkages is 10.5 1. However, it must be noted that the first-mentioned pair represents two condensa-... [Pg.1060]

Nitrates have only been prepared from saturated equatorial 3-hydroxyl groups by reaction with concentrated nitric acid and acetic anhydride at low temperature.Electrophilic substitution at C-6 precludes the satisfactory formation of nitrates from A -3j5-ols. [Pg.403]

Hydrazinopyridazines such as hydralazine have a venerable history as anti hypertensive agents. It is of note that this biological activity is maintained in the face of major modifications in the heterocyclic nucleus. The key intermediate keto ester in principle can be obtained by alkylation of the anion of pi peri done 44 with ethyl bromo-acetate. The cyclic acylhydrazone formed on reaction with hydrazine (46) is then oxidized to give the aromatized compound 47. The hydroxyl group is then transformed to chloro by treatment with phosphorus oxychloride (48). Displacement of halogen with hydrazine leads to the formation of endralazine (49). ... [Pg.232]

As inert as the C-25 lactone carbonyl has been during the course of this synthesis, it can serve the role of electrophile in a reaction with a nucleophile. For example, addition of benzyloxymethyl-lithium29 to a cold (-78 °C) solution of 41 in THF, followed by treatment of the intermediate hemiketal with methyl orthoformate under acidic conditions, provides intermediate 42 in 80% overall yield. Reduction of the carbon-bromine bond in 42 with concomitant -elimination of the C-9 ether oxygen is achieved with Zn-Cu couple and sodium iodide at 60 °C in DMF. Under these reaction conditions, it is conceivable that the bromine substituent in 42 is replaced by iodine, after which event reductive elimination occurs. Silylation of the newly formed tertiary hydroxyl group at C-12 with triethylsilyl perchlorate, followed by oxidative cleavage of the olefin with ozone, results in the formation of key intermediate 3 in 85 % yield from 42. [Pg.245]


See other pages where Hydroxyl reaction with formate is mentioned: [Pg.214]    [Pg.66]    [Pg.112]    [Pg.66]    [Pg.182]    [Pg.158]    [Pg.70]    [Pg.1742]    [Pg.250]    [Pg.451]    [Pg.557]    [Pg.606]    [Pg.516]    [Pg.220]    [Pg.244]    [Pg.383]    [Pg.38]    [Pg.285]    [Pg.163]    [Pg.524]    [Pg.670]    [Pg.306]    [Pg.377]    [Pg.384]    [Pg.196]    [Pg.157]    [Pg.262]    [Pg.263]    [Pg.3]    [Pg.183]    [Pg.867]    [Pg.594]    [Pg.59]    [Pg.63]    [Pg.76]    [Pg.258]   
See also in sourсe #XX -- [ Pg.493 , Pg.525 , Pg.563 ]




SEARCH



Formate reaction with

Hydroxyl, reactions

Hydroxylation reaction

© 2024 chempedia.info