Hydrolytic rate, positive

S.3 ATP Hydrolytic Rate Exhibits Positive Cooperativity as Each Additional Bound ATP Facilitates Hydrophobic Dissociation of y-Rotor from the Inner Wallof(aP)s... 

Prediction 5 There is a positive cooperativity of increased ATP occupancy of catalytic sites with rate of hydrolysis (rotation). Positive cooperativity of ATP occupancy with hydrolytic rate has the same basis as the role of the three a-ATPs of Prediction 3. As more sites become occupied by the very polar ATP molecule, progressively less viscoelastic drag occurs between rotor and housing. Less drag allows a faster rotation of the rotor on which the rate of hydrolysis depends. 

The usual order found with halogenonitrobenzenes is F > Cl Br I, the order of Cl and Br being variable, just as in heteroaromatic reactivity. The position of fluorine is of interest the available data indicate that it is usually the same as for nitrobenzene derivatives. Thus, in acid hydrolysis the order F > Cl for 2-halogeno-quinolines can be deduced beyond doubt since the fluoro derivative appears to react in the non-protonated form and the chloro derivative to resist hydrolytic attack even in the protonated form under appropriate conditions (Section II,D, l,d). Furthermore, in the benzo-thiazole ring, fluorine is displaced by the CHgO reagent at a rate 10 times that for chlorine. ... 

In these equations, Dmax is the larger of the summed values of STERIMOL parameters, Bj, for the opposite pair 68). It expresses the maximum total width of substituents. The coefficients of the ct° terms in Eqs. 37 to 39 were virtually equal to that in Eq. 40. This means that the a° terms essentially represent the hydrolytic reactivity of an ester itself and are virtually independent of cyclodextrin catalysis. The catalytic effect of cyclodextrin is only involved in the Dmax term. Interestingly, the coefficient of Draax was negative in Eq. 37 and positive in Eq. 38. This fact indicates that bulky substituents at the meta position are favorable, while those at the para position unfavorable, for the rate acceleration in the (S-cyclodextrin catalysis. Similar results have been obtained for a-cyclodextrin catalysis, but not for (S-cyclodextrin catalysis, by Silipo and Hansch described above. Equation 39 suggests the existence of an optimum diameter for the proper fit of m-substituents in the cavity of a-cyclodextrin. The optimum Dmax value was estimated from Eq. 39 as 4.4 A, which is approximately equivalent to the diameter of the a-cyclodextrin cavity. The situation is shown in Fig. 8. A similar parabolic relationship would be obtained for (5-cyclodextrin catalysis, too, if the correlation analysis involved phenyl acetates with such bulky substituents that they cannot be included within the (5-cyclodextrin cavity. 

The metabolism of fluorobenzoates has been examined over many years. Early studies using Nocardia erythropoUs (Cain et al. 1968) and Pseudomonas fluorescens (Hughes 1965) showed that although the rates of whole-cell oxidation of fluorobenzoates were less than for benzoate, they were comparable to, and greater than for, the chlorinated analogs. As for their chlorinated analogs, both dioxygenation and hydrolytic pathways may be involved, and studies have revealed that the different pathways depended on the positions of the fluorine substituents. 

Deamination, the hydrolytic loss of exocyclic amino groups on the DNA bases, is typically a very slow reaction. For example, deamination of cytosine residues in dnplex DNA occnrs with a half-life of about 30,000 years under physiological conditions, and the deamination of adenine residues is still more sluggish. " Alkylation at the N3-position of cytosine (Scheme 8.5) greatly increases the rate of deamination (ty2 = 406 h). Deamination of 3-methyl-2 -deoxycytidine proceeds 4000 times faster than the same reaction in the unalkylated nucleoside. Alkylation of the N3-position in cytosine residues also facilitates deglycosylation (Jy2 = 7700 h, lower pathway in Scheme 8.5), but the deamination reaction is 20 times faster and, therefore, predominates. ... 

Extraordinary selectivity has been accomplished with the parathion-type of insecticide by incorporating Q or CH3 groups in the meta position of the aryl ring. These groups interact sterically with acetylcholinesterase (AChE), increasing the affinity for the insect enzyme and decreasing it with the mammalian enzyme. Selectivity also is enhanced by differences in the rates of microsomal oxidation of P=S to P=0 and in hydrolytic detoxication between insects and mammals. The compounds, fenitrothion, fenthion, ronnel, bromophos, iodofenfos, chlorpyrifos—methyl, and pirimiphos —methyl, and dicapthon are used widely in public health, household, and agricultural pest control. 

The modulation of the coordination to the transition metal has not necessarily positive implications on the reactivity. For instance, we observed [50] that the copper(II) complex (8) of tetramethyl-l,2-diaminoethane catalyzes the hydrolysis of the phosphoric acid triester PNPDPP via an electrophilic mechanism which involves the pseudointramolecular attack of deprotonated water, as illustrated in (9). The electrophilic mechanism contribution to the hydrolytic process totally disappears in micellar aggregates made of the amphiphilic complex (10). Clearly, micellization does not allow the P O group of the substrate to interact with the metal ion. This could be a result of steric constraint of the substrate when bound to the micelle and/or the formation of binuclear dihydroxy complexes, like (11), in the aggregate. So, in spite of the quite large rate accelerations observed [51] in the cleavage of PNPDPP in metallomicelles made of the amphiphilic complex (10), the second-order rate constant [allowing for the difference in pXa of the H2O molecules bound to copper(II) in micelles and monomers] is higher for (8) than for (10) (k > 250). 

---