Hydrogen production carbon dioxide removal

Process selectivity indicates the preference with which the process removes one acid gas component relative to or in preference to another. For example, some processes remove both hydrogen sulfide and carbon dioxide, whereas other processes are designed to remove hydrogen sulfide only. Thus it is important to consider the process selectivity for hydrogen sulfide removal compared to carbon dioxide removal, ie, the carbon dioxide-to-hydrogen sulfide ratio in the natural gas, in order to ensure minimal concentrations of these components in the product. 

Hydrogen production from carbonaceous feedstocks requires multiple catalytic reaction steps For the production of high-purity hydrogen, the reforming of fuels is followed by two water-gas shift reaction steps, a final carbon monoxide purification and carbon dioxide removal. Steam reforming, partial oxidation and autothermal reforming of methane are well-developed processes for the production of hydro-... 

In the commercial preparation of hydrogen, since carbon dioxide is more easily removed than the monoxide, the aim will clearly be to work at a low temperature and thus reduce the fraction pcolpco, to a minimum. For the production of water-gas, on the other hand, with a maximum combustible efficiency, the percentage of carbon dioxide must be reduced to a minimum, and high temperatures are essential. 

In an ammonia plant (Figure 4.2), the synthesis gas from the reformer furnace is fed into a secondary reformer vessel, where air is added through a burner to create outlet vessel temperatures of -1,800° F (980° C). The outlet of the secondary reformer vessel is cooled in a quench steam generator and sent to a shift converter this is followed by a carbon dioxide removal system such as the one in a hydrogen plant. The purified nitrogen from the air added in the secondary reformer vessel and hydrogen synthesis gas is fed to a methanator to convert residual oxides of carbon back to methane (which is inert in the ammonia conversion) the gas is then compressed to -3,000 psia (2,070 kPa). The compressed synthesis gas is fed to an ammonia converter vessel. As the synthesis gas passes over catalyst beds, ammonia is formed. The ammonia product is then cooled and refrigerated to separate out impurities. 

---