Hydrocarbon regeneration

Formation enthalpy of hydrogen of required amount for hydrocarbon regeneration... 

The 4-aminopyrazole (250) reacts under Skraup conditions to give a useful synthesis of the pyrazolo[4,3 6]pyridine (251 19%) (58JCS3259). 1,3-Diketones (252) react with 3-aminopyrazoles e.g. 253) to give simple pyrazolo[l,5-a]pyrimidines (254). If the two R groups are different, mixtures result, but these can be treated with AT-bromosuccinimide to give the 3-bromo derivatives, purified, and the hydrocarbons regenerated by reduction (75JMC460). 

Absorber oil units offer the advantage that Hquids can be removed at the expense of only a small (34—69 kPa (4.9—10.0 psi)) pressure loss in the absorption column. If the feed gas is available at pipeline pressure, then Httle if any recompression is required to introduce the processed natural gas into the transmission system. However, the absorption and subsequent absorber-oil regeneration process tends to be complex, favoring the simpler, more efficient expander plants. Separations using soHd desiccants are energy-intensive because of the bed regeneration requirements. This process option is generally considered only in special situations such as hydrocarbon dew point control in remote locations. 

Polymers. Hydrocarbons from petroleum and natural gas serve as the raw material for virtually all polymeric materials commonly found in commerce, with the notable exception of rayon which is derived from cellulose extracted from wood pulp. Even with rayon, however, the cellulose is treated with acetic acid (qv), much of which is manufactured from ethylene (see Fibers, regenerated cellulosics). 

The aqueous sodium naphthenate phase is decanted from the hydrocarbon phase and treated with acid to regenerate the cmde naphthenic acids. Sulfuric acid is used almost exclusively, for economic reasons. The wet cmde naphthenic acid phase separates and is decanted from the sodium sulfate brine. The volume of sodium sulfate brine produced from dilute sodium naphthenate solutions is significant, on the order of 10 L per L of cmde naphthenic acid. The brine contains some phenolic compounds and must be treated or disposed of in an environmentally sound manner. Sodium phenolates can be selectively neutralized using carbon dioxide and recovered before the sodium naphthenate is finally acidified with mineral acid (29). Recovery of naphthenic acid from aqueous sodium naphthenate solutions using ion-exchange resins has also been reported (30). 

Thus the ECCU always operates in complete heat balance at any desired hydrocarbon feed rate and reactor temperature this heat balance is achieved in units such as the one shown in Eigure 1 by varying the catalyst circulation rate. Catalyst flow is controlled by a sHde valve located in the catalyst transfer line from the regenerator to the reactor and in the catalyst return line from the reactor to the regenerator. In some older style units of the Exxon Model IV-type, where catalyst flow is controlled by pressure balance between the reactor and regenerator, the heat-balance control is more often achieved by changing the temperature of the hydrocarbon feed entering the riser. 

Coke on the catalyst is often referred to as delta coke (AC), the coke content of the spent catalyst minus the coke content of the regenerated catalyst. Delta coke directly influences the regenerator temperature and controls the catalyst circulation rate in the FCCU, thereby controlling the ratio of catalyst hydrocarbon feed (cat-to-od ratio, or C/O). The coke yield as a fraction of feed Cpis related to delta coke through the C/O ratio as ... 

The hydrocarbon feed rate to the reactor also affects the burning kinetics in the regenerator. Increasing the reactor feed rate increases the coke production rate, which in turn requires that the air rate to the regenerator increase. Because the regenerator bed level is generally held constant, the air residence time in the dense phase decreases. This decrease increases the O2 content in the dilute phase and increases afterbum (Fig. 5). 

---