Hand-powered vacuum pump

A hand-powered vacuum pump used for obtaining flue gas and samples of gas under vacuum down to 25 inches of Hg. This is a 30 item purchased in an auto supply parts store. Its conventional use is to evacuate brake fluid lines. 

When first starting the filtration process, the vacuum will suck some of the product into the flask. The contents of the flask should then be re-filtered to ensure no product loss. The suction force is generated by a vacuum pump, which is commercially available in many styles and sizes hand driven pumps can be used as well. Note The suction force should not be too great. Placing your hand completely over the funnel until the suction grips your hand moderately indicates the proper suction. Never underestimate the power of a vacuum. 

Figure 3.13 shows the different behaviours of a vacuum pump, which was examined, on the one hand, with a conventional pump casing with inter casing and valve flaps and, on the other hand, with a fluidic optimised control cover. Equivalent suction capacities are to be established over wide ranges. However, the power requirement has decreased noticeably by the employment of the casing cover. 

Even when the time comes to make a purchasing decision, an energy-efficient motor purchase is not a certainty. Sometimes an energy-efficient motor will be the economically efficient choice at other times, not. The capital investment decision is based on the cost in relation to performance, efficiency and reliability. Moreover, the decision depends on the application and the amount of time the motor is in operation. It can be the major component of a product (drill or mixer), or a minor component (computer disk drive) it can be the major component cost of a product (fan), or it can be a minor component cost (stereo tape deck) it can run almost constantly (fan, pump, and machinery), or only a few minutes a day (vacuums and power tools). For example, contractors purchase circular saws almost solely based on performance and reliability. Time is money, and since the saw is operating only a few minutes a day and the contractor is often not responsible for the electricity costs to run the motor, energy efficiency is not a consideration performance and reliability are what matter most. On the other hand, an industrial user, who runs huge electric motors twenty-four hours a day to work pumps, machinery, and ventilation equipment, is very concerned tvitli energy efficiency as well as performance and reliability. 

---