Glass foam insulation

Mechanical Properties of Insulating Plastic Foams at Low Temperatures (4) 132 The Performance of Glass Fiber Insulation under High Vacuum (4) 141 A Vacuum Insulated Transfer Line for Liquefied Gases (4) 326 Economic and Design Considerations for a 650 Foot High Vacuum Insulated Transfer Line (4) 335... 

Polyurethane, PVC, and extruded polystyrene provide the bulk of the cellular plastics used for low and cryogenic temperature appHcations. In some cases, eg, the insulation of Hquid hydrogen tanks on space systems, foams have been reinforced with continuous glass fibers throughout the matrix. This improves strength without affecting thermal performance significantly. 

The avadabihty of PMDI also led to the development of polyurethane-modified isocyanurate (PUIR) foams by 1967. The PUIR foams have superior thermal stabiUty and combustibiUty characteristics, which extend the use temperature of insulation foams well above 150°C. The PUIR foams are used in pipe, vessel, and solar panel insulation glass-fiber-reinforced PUIR roofing panels having superior dimensional stabiUty have also been developed. More recently, inexpensive polyester polyols based on residues obtained in the production of dimethyl terephthalate (DMT) have been used in the formulation of rigid polyurethane and PUIR foams. 

Polyurethane. Polyurethanes (pu) are predominantly thermosets. The preparation processes for polyurethane foams have several steps (see Urethane polymers) and many variations that lead to products of widely differing properties. Polyurethane foams can have quite low thermal conductivity values, among the lowest of all types of thermal insulation, and have replaced polystyrene and glass fiber as insulation in refrigeration. The sprayed-on foam can be appHed to walls, roofs, tanks, and pipes, and between walls or surfacing materials directly. The slabs can be used as insulation in the usual ways. 

Container Insulation Tanks containing materials above atmospheric temperature may require insulation to reduce loss of heat. Almost any of the commonly used insulating materials can be employed. Calcium silicate, glass fiber, mineral wool, cellular glass, and plastic foams are among those used. Tanks exposed to weather must have jackets or protective coatings, usually asphalt, to keep water out of the insulation. 

Use special insulation materials such as foam glass or crimped aluminum sheeting... 

Glass-reinforced aluminum foil with either a bright polished or white lacquer surface is utilized with most types of insulant. Primarily it is used as a vapor control layer or as a means of upgrading the fire properties of plastic foams, but it does give a semi-decorative finish to the insulation. It is therefore often use where the insulation is open to view but located away from direct risk of mechanical damage. 

Glass-fiber tissue or non-woven fabrics are used for decorative purposes on many insulants. They also give improved strength to foam plastics and enhanced sound-absorption characteristics to mineral wools. 

In the special case of pipelines operating at relatively high temperatures such as for the transmission of heavy fuel oil at up to 85°C, heat insulation and electrical insulation are provided by up to 50 mm of foam-expanded polyurethane. As a further insurance against penetration of water, and to prevent mechanical damage, outer coatings of polyethylene (5 mm), butyl laminate tape (0-8 mm) or coal-tar enamel reinforced with glass fibre (2-5 mm) have been used. 

---