Gas-phase reaction with

With higher alkenes, three kinds of products, namely alkenyl acetates, allylic acetates and dioxygenated products are obtained[142]. The reaction of propylene gives two propenyl acetates (119 and 120) and allyl acetate (121) by the nucleophilic substitution and allylic oxidation. The chemoselective formation of allyl acetate takes place by the gas-phase reaction with the supported Pd(II) and Cu(II) catalyst. Allyl acetate (121) is produced commercially by this method[143]. Methallyl acetate (122) and 2-methylene-1,3-diacetoxypropane (123) are obtained in good yields by the gas-phase oxidation of isobutylene with the supported Pd catalyst[144]. 

Saturated hydrocarbons such as neopentane, notbomane, and cyclooctane have been converted to the corresponding perfluoro derivatives in 10-20% yield by gas-phase reaction with fluorine gas diluted with helium at —78°C. Simple ethers can be completely fluorinated under similar conditions. Crown polyethers can be fluorinated by passing an Fa/He stream over a solid mixture of sodium fluoride and the crown ether. Liquid-phase fluorination of hydrocarbons has also been observed, but the reaction is believed to be ionic, rather than radical, in character. A variety of milder fluorination agents have been developed for synthetic purposes and will be discussed in Chapter 6 of Part B. 

Table 3.1 suggests that scaling in series could make sense for an adiabatic, gas-phase reaction with no change in the number of moles upon reaction. It would also make sense when the number of moles decreases upon reaction, since the high pressures caused by this form of scaleup will favor the forward reaction. Chapter 5 gives the design equations for nonisothermal reactions and discusses the thermal aspects of scaleup. 

For completeness, axial dilfusion and variable cross-section terms were included in Equations (8.74) and (8.75). They are usually dropped. Also, the variations in and X are usually small enough that they can be brought outside the derivatives. The primary utility of these equations, compared with Equations (8.12) and (8.52), is for gas-phase reactions with a signihcant pressure drop. 

For polychlorinated biphenyls (PCBs), rate constants were highly dependent on the number of chlorine atoms, and calculated atmospheric lifetimes varied from 2 d for 3-chlorobiphenyl to 34 d for 236-25 pentachlorobiphenyl (Anderson and Hites 1996). It was estimated that loss by hydroxy-lation in the atmosphere was a primary process for the removal of PCBs from the environment. It was later shown that the products were chlorinated benzoic acids produced by initial reaction with a hydroxyl radical at the 1-position followed by transannular dioxygenation at the 2- and 5-positions followed by ring fission (Brubaker and Hites 1998). Reactions of hydroxyl radicals with polychlorinated dibenzo[l,4]dioxins and dibenzofurans also play an important role for their removal from the atmosphere (Brubaker and Hites 1997). The gas phase and the particulate phase are in equilibrium, and the results show that gas-phase reactions with hydroxyl radicals are important for the... 

Considerable attention has been directed to the formation of nitroarenes that may be formed by several mechanisms (a) initial reaction with hydroxyl radicals followed by reactions with nitrate radicals or NO2 and (b) direct reaction with nitrate radicals. The first is important for arenes in the troposphere, whereas the second is a thermal reaction that occurs during combustion of arenes. The kinetics of formation of nitroarenes by gas-phase reaction with N2O5 has been examined for naphthalene (Pitts et al. 1985a) and methylnaphthalenes (Zielinska et al. 1989) biphenyl (Atkinson et al. 1987b,c) acephenanthrylene (Zielinska et al. 1988) and for adsorbed pyrene (Pitts et al. 1985b). Both... 

VARMOL - Gas-Phase Reaction with Molar Change... 

The HWCVD deposition process is more or less the same as for PECVD, and was described in Section 1.7. Important differences between the two is the absence of ions, and the limited number of different species present in the gas phase, in the former. At low pressure atomic Si is the main precursor. This yields void-rich material with a high microstructure factor. Increasing the pressure allows gas phase reactions with Si and H to create more mobile deposition precursors (SiH3), which improves the material quality. A further increase leads to the formation of higher silanes, and consequently to a less dense film. 

Fuel reforming is popular way for hydrogen production for fuel cell use. Hydrocarbons are used for the fuel resource. Methane (CH4) steam reforming process consists of the following two gas phase reactions with various catalysts. 

Extensive research has been conducted into the atmospheric chemistry of organic chemicals because of air quality concerns. Recently, Atkinson and coworkers (1984, 1985, 1987, 1988, 1989, 1990, 1991), Altshuller (1980, 1991) and Sabljic and Glisten (1990) have reviewed the photochemistry of many organic chemicals of environmental interest for their gas phase reactions with hydroxyl radicals (OH), ozone (03) and nitrate radicals (N03) and have provided detailed information on reaction rate constants and experimental conditions, which allowed the estimation of atmospheric lifetimes. Klopffer (1991) has estimated the atmospheric lifetimes for the reaction with OH radicals to range from 1 hour to 130 years, based on these reaction rate constants and an assumed constant concentration of OH... 

Air half-life of 2.4-24 h based on photooxidation rate constant of 3.2 x 1012 cm3 mol1 s 3 for the gas-phase reaction with hydroxyl radical (Darnall et al. 1976) ... 

Oxidation rate constant k = 4.58 x 10-12 cm3 molecule-1 s-1 for the gas phase reaction with OH radical at room temp. (Ohta Ohyama 1985 Atkinson 1989) ... 

A common way of following the progress of a gas phase reaction with a change in the number of mols is to monitor the time variation of the total pressure, it. From this information and the stoichiometry, the partial pressures of the participants can be deduced, and a rate equation developed in those terms. Usually it is adequate to assume ideal gas behavior, but nonideal behavior can be taken into account with extra effort. Problem P3.03.06 is an example of nonideality. 

For gas phase reaction with a change in the number of mols, the material balance is made in terms of molal flows,... 

Table 3 shows the atmospheric lifetime for eleven PAH with respect to gas-phase reaction with OH and NO3 radicals, O3 and N2O5. This was calculated from the estimated and calculated rate constants. It is evident that most of the nitroarenes formed under ambient atmospheric conditions were produced by reaction of PAH with OH. The PAH reaction with NO3 radical was also considered as an important step because it resulted in the formation of nitroarenes from the N2O5 reaction with gas-phase PAH. 

TABLE 3. Calculated atmospheric lifetimes of PAH due to gas-phase reactions with OH and NO3 radicals, O3 and N2O547... 

Titanium dioxide suspended in an aqueous solution and irradiated with UV light X = 365 nm) converted benzene to carbon dioxide at a significant rate (Matthews, 1986). Irradiation of benzene in an aqueous solution yields mucondialdehyde. Photolysis of benzene vapor at 1849-2000 A yields ethylene, hydrogen, methane, ethane, toluene, and a polymer resembling cuprene. Other photolysis products reported under different conditions include fulvene, acetylene, substituted trienes (Howard, 1990), phenol, 2-nitrophenol, 4-nitrophenol, 2,4-dinitrophenol, 2,6-dinitro-phenol, nitrobenzene, formic acid, and peroxyacetyl nitrate (Calvert and Pitts, 1966). Under atmospheric conditions, the gas-phase reaction with OH radicals and nitrogen oxides resulted in the formation of phenol and nitrobenzene (Atkinson, 1990). Schwarz and Wasik (1976) reported a fluorescence quantum yield of 5.3 x 10" for benzene in water. 

Chemical/Physical. Products identified from the reaction of toluene with nitric oxide and OH radicals include benzaldehyde, benzyl alcohol, 3-nitrotoluene, p-methylbenzoquinone, and o, m, and p-cresol (Kenley et ah, 1978). Gaseous toluene reacted with nitrate radicals in purified air forming the following products benzaldehyde, benzyl alcohol, benzyl nitrate, and 2-, 3-, and 4-nitro-toluene (Chiodini et al., 1993). Under atmospheric conditions, the gas-phase reaction with OH radicals and nitrogen oxides resulted in the formation of benzaldehyde, benzyl nitrate, 3-nitrotoluene, and o-, m-, and p-cresol (Finlayson-Pitts and Pitts, 1986 Atkinson, 1990). 

Chemical/Physical. Under atmospheric conditions, the gas-phase reaction with OH radicals and nitrogen oxides resulted in the formation of p-tolualdehyde (Atkinson, 1990). Kanno et al. (1982) studied the aqueous reaction of p-xylene and other aromatic hydrocarbons (benzene, toluene, o-and /n-xylene, and naphthalene) with hypochlorous acid in the presence of ammonium ion. They reported that the aromatic ring was not chlorinated as expected but was cleaved by chloramine forming cyanogen chloride. The amount of cyanogen chloride formed increased at lower pHs (Kanno et al, 1982). Products identified from the OH radical-initiated reaction of p-xylene in the presence of nitrogen dioxide were 3-hexene-2,5-dione, p-tolualdehyde, and 2,5-dimethylphenol (Bethel et al., 2000). 

For all reactions in which the volume of reacting mixture changes proportionately with conversion, such as in single gas-phase reactions with significant density changes, Eq. 3 becomes... 

---