Functionally graded materials design procedure

Chemical vapor deposition (CVD) of carbon from propane is the main reaction in the fabrication of the C/C composites [1,2] and the C-SiC functionally graded material [3,4,5]. The carbon deposition rate from propane is high compared with those from other aliphatic hydrocarbons [4]. Propane is rapidly decomposed in the gas phase and various hydrocarbons are formed independently of the film growth in the CVD reactor. The propane concentration distribution is determined by the gas-phase kinetics. The gas-phase reaction model, in addition to the film growth reaction model, is required for the numerical simulation of the CVD reactor for designing and controlling purposes. Therefore, a compact gas-phase reaction model is preferred. The authors proposed the procedure to reduce an elementary reaction model consisting of hundreds of reactions to a compact model objectively [6]. In this study, the procedure is applied to propane pyrolysis for carbon CVD and a compact gas-phase reaction model is built by the proposed procedure and the kinetic parameters are determined from the experimental results. 

A computational design procedure of a thermoelectric power device using Functionally Graded Materials (FGM) is presented. A model of thermoelectric materials is presented for transport properties of heavily doped semiconductors, electron and phonon transport coefficients are calculated using band theory. And, a procedure of an elastic thermal stress analysis is presented on a functionally graded thermoelectric device by two-dimensional finite element technique. First, temperature distributions are calculated by two-dimensional non-linear finite element method based on expressions of thermoelectric phenomenon. Next, using temperature distributions, thermal stress distributions are computed by two-dimensional elastic finite element analysis. 

A Design Procedure of Functionally Graded Thermoelectric Materials... 

Standardization— 1) The process of designing and altering products, parts, processes, and procedures to establish and use standard specifications for them and their components. 2) Reduction of total number of parts and materials used and products, models, or grades produced. 3) The function of bringing a raw ingredient into standard (acceptable) range per the specification before introduction to the main process. 

---