Fatigue testing stress-life behavior

Low-Cycle Fatigue. For the low-cycle fatigue region (N< 10 cycles), tests are conducted wifii controlled cycles of elastic plus jdastic (total) strain range, rather than with controlled load or stress cycles. Under controlled-strain testing, fiitigue life behavior is rqite-... 

Exploratory creep tests were performed on tensile specimens of NT-154 silicon nitride at 1300 and 1370 C, These specimens were made from the same lot of the material, designated as CP-serles, used In the cyclic fatigue tests discussed In the last progress report, Creep strain was measured using the laser diffraction strain extensometer described elsewhere,2 Figure 7 shows the creep curves of specimens CP-28 and CP-10 tested at 1300 C under applied stress of 160 and 180 MPa, respectively. Both tests were shutdown Inadvertently due to equipment adjustments. The problems have been corrected since then. Therefore, the results of the tests do not represent the creep life of the specimens. However, there were sufficient data points to delineate the essential features of the creep behavior up to the steady-state phase which was clearly definable. Both curves showed a reversed Inflection at the transition between the primary and secondary creep phases, resulting In forming a bump In the otherwise smooth creep curves. 

Service lifetime prediction of polymers and/or polymer based materials may be undertaken from different types of tests, such as creep behavior tests (linear and non-linear creep, physical aging, time-dependent plasticity), fatigue behavior tests (stress transfer and normalized life prediction models, empirical fatigue theories, fracture mechanics theory and strength degradation) and standard accelerated aging tests (chemical resistance, thermal stability, liquid absorption) [32]. 

---