Ex Situ Oxidation

Fig. 7 Comparison of different electrochemical methods of estimating the partial free surface ex situ oxide capacitance, in situ electrochemical admittance, and corrosion current (determined from Rp). Differences between these values may be accounted for by the variation of surface morphology as shown in the schematic diagram. (From Ref [42].)...

As a furtlier example for tire meaning of ex situ investigations of emersed electrodes witli surface analytical teclmiques, results obtained for tire double layer on poly crystalline silver in alkaline solutions are presented in figure C2.10.3. This system is of scientific interest, since tliin silver oxide overlayers (tliickness up to about 5 nm) are fonned for sufficiently anodic potentials, which implies tliat tire adsorjDtion of anions, cations and water can be studied on tire clean metal as well as on an oxide covered surface [55, 56]. For tire latter situation, a changed... 

Based on electrochemical experiments combined with ex situ analysis by AES, LEED, and RHEED, Wang et al. (2001) suggested the formation of a (2 x 2) (2CO + O) adlayer on Ru(OOOl) at = 0.2 V in CO-samrated HCIO4, similar to the phase formed in UHV after CO adsorption on a (2 x 2)0-covered surface [Schiffer et al., 1997]. Erom the total charge density transferred after a potential step to 1.05 V in a CO-free electrolyte, they concluded that only 60% of the CO content in such an adlayer can be oxidized under these conditions [Wang et al., 2001]. 

Because they can be chemically oxidized or biologically degraded, chemical oxidation and biodegradation technologies (both in situ and ex situ) can be effective in the treatment of oxygenates. 

Groundwater extraction Ex situ hydrogen peroxide, or permanganate into die subsurface to oxidize contaminants Extraction of contaminated... 

Although not the subject of this article, double layer studies are briefly discussed in this paragraph in order to demonstrate that ex situ XPS studies indeed provide information about the state of the electrode exposed to an electrochemical environment at a defined potential. A crucial step in any ex situ experiment is the emersion of the electrode. Here the question arises whether the electrochemical double layer or part of it is preserved at the interface after emersion and transfer. Winograd et al. [10,11] first demonstrated that the electrode under UHV conditions still remembers the electrode potential applied at the time of emersion. These authors investigated oxide formation on Pt and the underpotential deposition of Cu and Ag on Pt by means of XPS and proved that the electrochemically formed oxide layer and... 

X-ray photoelectron spectroscopy (XPS) of electrodes was first applied to the oxidation of noble metal electrodes. Kim and Winograd investigated in 1971 the electrochemical formation of anodic oxides on Pt [10] and later on Au electrodes [60]. The electrochemical parameters of oxide formation on these noble metal electrodes were well characterized and enabled a direct correlation between ex situ XPS and in situ electrochemical analysis. 

More than a decade ago, Hamond and Winograd used XPS for the study of UPD Ag and Cu on polycrystalline platinum electrodes [11,12]. This study revealed a clear correlation between the amount of UPD metal on the electrode surface after emersion and in the electrolyte under controlled potential before emersion. Thereby, it was demonstrated that ex situ measurements on electrode surfaces provide relevant information about the electrochemical interface, (see Section 2.7). In view of the importance of UPD for electrocatalysis and metal deposition [132,133], knowledge of the oxidation state of the adatom in terms of chemical shifts, of the influence of the adatom on local work functions and knowledge of the distribution of electronic states in the valence band is highly desirable. The results of XPS and UPS studies on UPD metal layers will be discussed in the following chapter. Finally the poisoning effect of UPD on the H2 evolution reaction will be briefly mentioned. 

---