Epoxide compounds intermediates

Hickinbottom and co-workere have recently published evident, casting doubt on earlier beliefs that epoxides were intermediates in 11nformation of carbonyl compounds during olefin oxidation by chroma add. For example, 2-methyl-l, 1 diphenyl 1 -propene (Eq. Ill) gave-good yiold of the corresponding epoxide in acetic anhydride along wii-1. 

Cyclic voltammetry, kinetic studies, and DFT calculations using a BP functional and the TZVP basis set showed that the major pathway of the non-regiospeciflc zinc-reduced titanocene-mediated ring opening of epoxides was initiated by a titanium dimer-epoxide compound that reacted in a rate-determining electron transfer mechanism 25 The calculations showed that the transition state is early so the stereoselectivity is determined by steric effects rather than by the stability of intermediate radicals. This was confirmed by studies with more sterically crowded catalysts. 

Furthermore, oxidation of fatty acids to vicinal diols, as well as their oxidative cleavage, are important industrial applications. Vicinal diols of unsaturated fatty compounds can be prepared by nucleophilic ring opening of the epoxides after epoxidation, but difficult technical conditions are necessary to achieve this ring opening [9]. The use of Re- [10], W- [11], or Mo [l]-based catalysts with hydrogen peroxide can give a jyn-diol via the epoxide as intermediate (eq. (2)). 

Even replacement of silicon by a humble halide can be important in complex syntheses. The epothilones, e.g. 201, are anti-cancer compounds of some promise. Chemose-lective epoxidation of intermediate 202 is possible and Shibasaki decided to disconnect at the obvious ester and the far less obvious diene requiring a C C bond to be made stereoselectively between two alkenes49 203 and 204. 

Epoxides - Organic compounds containing three-membered cyclic group(s) in which two carbon atoms are linked with an oxygen atom as in an ether. This group is called an epoxy group and is quite reactive, allowing the use of epoxides as intermediates in preparation of certain fluorocarbons and cellulose derivatives and as monomers in preparation of epoxy resins. 

Propylene oxide n. CH3CH(0)CH2 (1,2 -propylene oxide, 1,2 epoxypropane). A low boiling, liquid epoxide compound derived from the intermediate propylene chlorohy-drin, which is itself produced by reacting propylene with chlorine and water. Propylene oxide is an important intermediate for the manufacture of polyglycols used for polyurethane foams and resins, and polyester resins. 

Epoxies are a specific type of resin in which one of the components is an epoxide compound. A second component, typically an amine, reacts irreversibly with the epoxide functional group, causing its three-membered ring structure to open up. The intermediate form produced reacts in a chainlike manner with other epoxide molecules to form complex, three-dimensional polymeric molecules. 

Application of the UMP2 and G3 methods has revealed the complex mechanisms for reaction of O3 with 1-butene (CH3CH2CH=CH2), for both adiabatic and non-adiabatic reaction channels, and shown that the minimum energy crossing points play a key role. The site selectivity of the addition of O3 to either carbon atom of the double bond of 1-butene is unremarkable. The mechanisms of formation of butenols are also discussed and shown to occur not only by ketoenol tautomerization but also by a rearrangement and decomposition reaction involving the intermediate epoxide compound. ... 

Perfluoroepoxid.es were first prepared ia the late 1950s by Du Pont Co. Subsequent work on these compounds has taken place throughout the world and is the subject of a number of reviews (1 5). The main use of these epoxides is as intermediates in the preparation of other fluorinated monomers. Although the polymerisation of the epoxides has been described (6—12), the resulting homopolymers and their derivatives are not significant commercial products. Almost all the work on perfluoroepoxides has been with three compounds tetrafluoroethylene oxide (TFEO), hexafluoropropylene oxide (HFPO), and perfluoroisobutylene oxide (PIBO). Most of this work has dealt with HFPO, the most versatile and by far the most valuable of this class of materials (4). 

Nucleophilic Reactions. The strong electronegativity of fluorine results in the facile reaction of perfluoroepoxides with nucleophiles. These reactions comprise the majority of the reported reactions of this class of compounds. Nucleophilic attack on the epoxide ring takes place at the more highly substituted carbon atom to give ring-opened products. Fluorinated alkoxides are intermediates in these reactions and are in equiUbrium with fluoride ion and a perfluorocarbonyl compound. The process is illustrated by the reaction of methanol and HFPO to form methyl 2,3,3,3-tetrafluoro-2-methoxypropanoate (eq. 4). 

N—Fe(IV)Por complexes. Oxo iron(IV) porphyrin cation radical complexes, [O—Fe(IV)Por ], are important intermediates in oxygen atom transfer reactions. Compound I of the enzymes catalase and peroxidase have this formulation, as does the active intermediate in the catalytic cycle of cytochrome P Q. Similar intermediates are invoked in the extensively investigated hydroxylations and epoxidations of hydrocarbon substrates cataly2ed by iron porphyrins in the presence of such oxidizing agents as iodosylbenzene, NaOCl, peroxides, and air. 

Sulfitation and Bisulfitation of Unsaturated Hydrocarbons. Sulfites and bisulfites react with compounds such as olefins, epoxides, aldehydes, ketones, alkynes, a2iridines, and episulftdes to give aHphatic sulfonates or hydroxysulfonates. These compounds can be used as intermediates in the synthesis of a variety of organic compounds. 

Some instances of incomplete debromination of 5,6-dibromo compounds may be due to the presence of 5j5,6a-isomer of wrong stereochemistry for anti-coplanar elimination. The higher temperature afforded by replacing acetone with refluxing cyclohexanone has proved advantageous in some cases. There is evidence that both the zinc and lithium aluminum hydride reductions of vicinal dihalides also proceed faster with diaxial isomers (ref. 266, cf. ref. 215, p. 136, ref. 265). The chromous reduction of vicinal dihalides appears to involve free radical intermediates produced by one electron transfer, and is not stereospecific but favors tra 5-elimination in the case of vic-di-bromides. Chromous ion complexed with ethylene diamine is more reactive than the uncomplexed ion in reduction of -substituted halides and epoxides to olefins. ... 

Polyfluoroalkyl- andperfluoroalkyl-substituted CO and CN multiple bonds as dipolarophiles. Dmzo alkanes are well known to react with carbonyl compounds, usually under very mild conditions, to give oxiranes and ketones The reaction has been interpreted as a nucleophilic attack of the diazo alkane on the carbonyl group to yield diazonium betaines or 1,2,3 oxadiazol 2 ines as reaction intermediates, which generally are too unstable to be isolated Aromatic diazo compounds react readily with partially fluorinated and perfluorinated ketones to give l,3,4-oxadiazol-3-ines m high yield At 25 °C and above, the aryloxa-diazolines lose nitrogen to give epoxides [111]... 

The reactions of olefins with peracids to form epoxides allows for the selective oxidation of carbon-carbon double bonds in the presence of other functional groups which may be subject to oxidation (for example, hydroxyl groups). The epoxides that result are easily cleaved by strong acids to diols or half-esters of diols and are therefore useful intermediates in the synthesis of polyfunctional compounds. 

Ethylene oxide is a highly active intermediate. It reacts with all compounds that have a labile hydrogen such as water, alcohols, organic acids, and amines. The epoxide ring opens, and a new compound with a hydroxyethyl group is produced. The addition of a hydroxyethyl group increases the water solubility of the resulting compound. Eurther reaction of ethylene oxide produces polyethylene oxide derivatives with increased water solubility. 

In the third sequence, the diastereomer with a /i-epoxide at the C2-C3 site was targeted (compound 1, Scheme 6). As we have seen, intermediate 11 is not a viable starting substrate to achieve this objective because it rests comfortably in a conformation that enforces a peripheral attack by an oxidant to give the undesired C2-C3 epoxide (Scheme 4). If, on the other hand, the exocyclic methylene at C-5 was to be introduced before the oxidation reaction, then given the known preference for an s-trans diene conformation, conformer 18a (Scheme 6) would be more populated at equilibrium. The A2 3 olefin diastereoface that is interior and hindered in the context of 18b is exterior and accessible in 18a. Subjection of intermediate 11 to the established three-step olefination sequence gives intermediate 18 in 54% overall yield. On the basis of the rationale put forth above, 18 should exist mainly in conformation 18a. Selective epoxidation of the C2-C3 enone double bond with potassium tm-butylperoxide furnishes a 4 1 mixture of diastereomeric epoxides favoring the desired isomer 19 19 arises from a peripheral attack on the enone double bond by er/-butylper-oxide, and it is easily purified by crystallization. A second peripheral attack on the ketone function of 19 by dimethylsulfonium methylide gives intermediate 20 exclusively, in a yield of 69%. 

---