Electrostatic motor

Aificromotors Aificrovalves ificropumps Suitable for micromechanical system Can use available siUcon processing technology, such as electrostatic motor Can use any smart material... 

After patterning the Oxide2 layer with anchors and vias, the second layer of released structural polysilicon is deposited, annealed, and patterned following the procedures used for Polyl. Poly2 is 1.5pm thick and has a compressive residual stress of —10 MPa and a resistance of 20 O/D. A common use for this structural layer is to provide constraints for features defined in Polyl, such as a hub that constrains a rotor in an electrostatic motor [9], [10] or a staple that constrains a pin in a hinge [11], [12]. It is also possible to make a... 

In the past decade a technology known as micromachining has developed out of IC technology ll. It uses the same techniques, but instead of fabricating electronic circuits on a chip, three dimensional physical structures on a micrometer scale can be made. Intriguing devices such as 100 micrometer electrostatic motors, tweezers, bridges and oscillating beams, 10 nm filters, micropumps and valves have all l n made in silicon and other IC compatible materitds. 

In HT motors even electrostatic effects between the windings of the stator and the rotor due to stator voltage... 

The principal technological changes in the engineering control of air pollution were the perfection of the motor-driven fan, which allowed large-scale gas-treating systems to be built the invention of the electrostatic precipitator, which made particulate control in many processes feasible and the development of a chemical engineering capability for the design of process equipment, which made the control of gas and vapor effluents feasible. 

The fuel. skid. This could contain a gas compressor if the fuel gas pressure is low and a knockout drum for any liquid contamination that the gas may have. The requirement of fuel gas pressure is that it should be operated at a minimum of 50-70 psi (3.5-4.83 Bar) above the compressor discharge pressure. The compressor and its motor drive fall under the drive level hierarchy. In the case of liquid fuels, the skid may also contain a fuel treatment plant, which would have centrifuges, electrostatic precipitators, fuel additive pumps, and other equipment. These could be directly controlled by the D-CS system, which would then report its readiness to the gas turbine controller. 

Zhou, J., Lloyd, S. A., and Blair, D. A. (1998). Electrostatic interactions between rotor and stator in the bacterial flagellar motor. Proc. Natl. Acad. Sri. USA 95, 6436-6441. 

More than 18 classes of myosin have been identified in different organisms so far. Myosins of class V and class XI (the plant class V) are most akin to kinesin because they are dimeric, plus end (barbed end)-directed, processive motors used for membrane and particle transport along actin filaments. There is also a class of myosins with reversed motility (class VI). It is not yet clear whether these are monomeric or dimeric. Myosin-I, the first class of unconventional myosins to be identified, comprises monomeric motors with a basic tail that interacts by electrostatic interaction with the cargo. 

Electrical energy is considered to allow us to discuss batteries and electrochemical cells, as well as motors and resistance heating. If a charge Q is transferred to a system at an electrostatic potential (voltage) < ) with respect to the surroundings, the work done is Q ... 

Dust Explosion. Dusts, like solvent vapors, when in the presence of oxygen concentrations that will support combustion, represent potentially dangerous situations. Explosion and/or fire can be triggered by a spark, derived from an impact or friction or an electrostatic discharge or from hot spots (e.g., overheated motor bearings)... 

MOTOR FUEL (8006-61-9) Forms explosive mixture with air [flash point (73 octane) —45°F/-43°C (100 octane) —36°F/—38°C]. Violent reaction with oxidizers, fluorine. Incompatible with nitric acid. Flow or agitation of substance may generate electrostatic chtirges due to low conductivity. 

---