Electronically conducting polymers redox processes

The concept of electrochemical intercalation/insertion of guest ions into the host material is further used in connection with redox processes in electronically conductive polymers (polyacetylene, polypyrrole, etc., see below). The product of the electrochemical insertion reaction should also be an electrical conductor. The latter condition is sometimes by-passed, in systems where the non-conducting host material (e.g. fluorographite) is finely mixed with a conductive binder. All the mentioned host materials (graphite, oxides, sulphides, polymers, fluorographite) are studied as prospective cathodic materials for Li batteries. 

Porosity effects during the charging process have long been considered in discussions of the faradaic and capacitive contributions to the current, especially in the case of electronically conducting polymers. For instance, the peaks of cyclic voltam-mograms were attributed to the faradaic process while the plateaus of the cmrent were considered to be an indication of the capacitive term [99,105,106,211-215]. However, this straightforward analogy to the metal/solution interface does not work in reality the obviously faradaic process of the redox transformation of the redox species in the surface layer does not lead to a direct current, unlike similar reactions for solute species. 

Chromatic changes caused by electrochemical processes were originally described in the literature in 1876 for the product of the anodic deposition of aniline [271]. However, the electrochromism was defined as an electrochemically induced phenomenon in 1969, when Deb observed its occurrence in films of some transition metal oxides [272]. Electrochromism in polypyrrole was first reported by Diaz et al. in 1981 [273]. Electrochromism is defined as the persistent change of optical properties of a material induced by reversible redox processes. Electronic conducting polymers have been known and studied as electrochromic materials since the initial systematic studies of their electronic properties. 

The type of analysis presented here has been applied to both redox-conducting and electronically conducting polymers. In both cases it is often assumed that the Dor value corresponds to the process of ion transport through the polymer. 

Polymers. Electronically conductive polymers may also be used as cathode materials in rechargeable lithium batteries. The most popular polymers are polyacetylene, polypyrrole, polyaniline, and polythiophene, which are made conductive by doping with suitable anions. The discharge-charge process is a redox reaction in the polymer. The low specific energy, high cost, and their instability, however, make these polymers less attractive. They have been used in small coin-type batteries with a lithium-aluminum alloy as the anode. 

On the other hand, Doblhofer218 has pointed out that since conducting polymer films are solvated and contain mobile ions, the potential drop occurs primarily at the metal/polymer interface. As with a redox polymer, electrons move across the film because of concentration gradients of oxidized and reduced sites, and redox processes involving solution species occur as bimolecular reactions with polymer redox sites at the polymer/solution interface. This model was found to be consistent with data for the reduction and oxidation of a variety of species at poly(7V-methylpyrrole). This polymer has a relatively low maximum conductivity (10-6 - 10 5 S cm"1) and was only partially oxidized in the mediation experiments, which may explain why it behaved more like a redox polymer than a typical conducting polymer. 

The above mechanistic aspect of electron transport in electroactive polymer films has been an active and chemically rich research topic (13-18) in polymer coated electrodes. We have called (19) the process "redox conduction", since it is a non-ohmic form of electrical conductivity that is intrinsically different from that in metals or semiconductors. Some of the special characteristics of redox conductivity are non-linear current-voltage relations and a narrow band of conductivity centered around electrode potentials that yield the necessary mixture of oxidized and reduced states of the redox sites in the polymer (mixed valent form). Electron hopping in redox conductivity is obviously also peculiar to polymers whose sites comprise spatially localized electronic states. 

---