Droplet sampling devices

Design of Droplet Sampling Devices for Measurements in Cooling Towers... 

Rotary sampling devices called Rotorods have also been widely used for sampling airborne sprays.These devices are similar to the rotary samplers described above, but do not use Teflon or magnesium oxide slides for spray collection. Rather, droplets... 

Cascade impactors. Cascade impactors provide information on particle or droplet size spectra within airborne sprays. The air is drawn through a series of chambers that allow sequential separation of different particle sizes based on their different velocities and masses. This type of collector is not as widely used as the sampling devices discussed previously because they are relatively difficult to operate and are expensive. Further information on this and other types of sampler for spray research can be found in the literature. ... 

Other observations of the reaction of hydrazine and nitrogen tetroxide substantiate the production of non-equilibrium combustion products. Non-equilibrium product concentrations were found in combustion gases extracted from a small rocket combustion chamber through a molecular beam sampling device with direct mass spec-trometric analysis (31) (39). Under oxidizer rich conditions excessive amounts of nitric oxide were found under fuel rich conditions excessive amounts of ammonia were found. A correlation between the experimentally observed characteristic velocity and nitric oxide concentration exists (40). Related kinetic effects are postulated to account for the two stage flame observed in the burning of hydrazine droplets in nitrogen dioxide atmospheres (41) (42). 

The nebulization concept has been known for many years and is commonly used in hair and paint spays and similar devices. Greater control is needed to introduce a sample to an ICP instrument. For example, if the highest sensitivities of detection are to be maintained, most of the sample solution should enter the flame and not be lost beforehand. The range of droplet sizes should be as small as possible, preferably on the order of a few micrometers in diameter. Large droplets contain a lot of solvent that, if evaporated inside the plasma itself, leads to instability in the flame, with concomitant variations in instrument sensitivity. Sometimes the flame can even be snuffed out by the amount of solvent present because of interference with the basic mechanism of flame propagation. For these reasons, nebulizers for use in ICP mass spectrometry usually combine a means of desolvating the initial spray of droplets so that they shrink to a smaller, more uniform size or sometimes even into small particles of solid matter (particulates). 

The thermospray device produces a wide dispersion of droplet sizes and transfers much of sample solution in unit time to the plasma flame. Therefore, it is essential to remove as great a proportion of the bigger droplets and solvent as possible to avoid compromising the flame performance. Consequently, the thermospray device usually requires both spray and desolvation chambers, especially for analyte solutions in organic solvents. 

A number of different types of ESI sources, known as nanospray sources, have been designed that can operate at lower sample flow rates (10-200 nL min ). These generate smaller droplets and improve the signal intensity of the protein-ligand noncovalent complexes further, with the added benefit of reducing protein consumption up to 100-fold compared to standard ESI flow rates. Nanospray has also been reported to be more tolerant to nonvolatile cations in solution [37]. Recently, an automated fabricated chip nanospray source has been developed. This chip-based device has improved the ease-of-use for nanospray, while the design eliminates carryover effects as the spray is produced directly from an orifice on each sample well of the chip [38]. 

Cloud Water and Precipitation Collectors. Several methods have been developed for collecting cloud water samples (24-26). Probably the device most commonly used in warm clouds is the slotted rod collector developed by the Atmospheric Science Research Center at the State University of New York (SUNY) at Albany. Commonly known as the ASRC collector (25), this collector consists of an array of rods constructed from Delrin (a form of nylon). Each rod is hollow and has a slot located at its forward stagnation line. The rod radius determines the collection efficiency as a function of particle size, the rods are sized to collect cloud droplets but not submicrometer aerosol particles, and the 50% cutoff is calculated to be at about 3 xm. 

---