Dimethyl determination

Takahashi Y, Daitoku H, Hirota K, Tamiya HJ, Yokoyama A, Kako K, Nagashima Y, Nakamura A, Shimada T, Watanabe S, Yamagata K, Yasuda K, Ishii N, Fukamizu A. Asymmetric arginine dimethylation determines life span in C. elegans by regulating forkhead transcription factor DAF-16. Cell Metab. 2011 13 505-16. 

Succinamide. Add 5 g. (4-8 ml.) of dimethyl succinate to 25 ml. of concentrated ammonia solution (sp. gr. 0-88) in a 100 ml. conical flask. Cork the flask and shake the contents for a few minutes aUow to stand for 24 hours with occasional shaking. Filter off the crystals of succinamide, and wash with a Uttle cold water. RecrystaUise from a little hot water. Dry in the steam oven and determine the m.p. The yield is 3-5 g. Pure succinamide melts at 254° with decomposition. 

Determination of structural features. The ultraviolet spectrum has been of value in the determination of the structure of several vitamins. Thus the presence of an a-naphthoquinone system in vitamin K was first detected by this means. Also the 4-methylthiazole and the 2 5-dimethyl-6-aminopyridine system was first identified in vitamin Bj (thiamine), a- and /3-Ionones can be distinguished since the former contains two conjugated chromophores and the latter three conjugated chromophores. 

The influence of a large number of oc-amino acids on the values of and k at have been determined. These a-amino acids included glycine, L-valine, L-leucine, L-phenylalanine, L-tyrosine, L-tryptophan, NOrmethyl-L-tryptophan (L-abrine), N-methyl-L-tyrosine, N,N-dimethyl-L-tyrosine and p -me thoxy-N-me thyl -L -phenyl al anine. 

Acrylonitrile reacts with the sodium salt of 4.5-dimethvl-A-4-thiazoline-2-thione (73J (R4 = R5 = Me) to yield 3-(2-cyanoethyl)-4.5-dimethyl-A-4-thiazoline-2-thione (74) (R4 = R, = Me) (Scheme 35 (160). Humphlett s studies of this reaction showed that the size of the R4 substituent is a determinant factor for the S versus N ratio (161. 162). If R4 == H, 100% of the N-substituted product (74) is obtained this drops to 50% when R4 = methyl, and only the S-substituted product (75) is obtained when R4 = phenyl. The same trend is observed with various CH2 = CH-X (X = C00CH3. COCH3) reagents (149). The S/N ratio also depends on the electrophilic center for CH2 = CH-X systems thus S-reaction occurs predominantly with acrylonitrile, whereas N-substitution predominates with methvlvinvlketone (149). 

The nature of the solvent is as important as the polymer in determining , as is apparent from the wide range of values for poly (dimethyl siloxane) in different solvents. 

The PODs obtained from aromatic dihydra2ides are partiy soluble in dimethyl-acetamide, DMSO, etc the others dissolve in these solvents. The thermal stabihties (up to 464°C in air and 476°C in nitrogen (10% weight loss)) of the polymers were determined by tga. 

Yields of excited states from 1,2-dioxetane decomposition have been determined by two methods. Using a photochemical method (17,18) excited acetone from TMD is trapped with /n j -l,2-dicyanoethylene (DCE). Triplet acetone gives i7j -l,2-dicyanoethylene with DCE, whereas singlet acetone gives 2,2-dimethyl-3,4-dicyanooxetane. By measuring the yields of these two products the yields of the two acetone excited states could be determined. The yields of triplet ketone (6) from dioxetanes are determined with a similar technique. 

The cmde dimethyl terephthalate is recovered and purified by distillation in most processes. Although distillation (qv) is generally a powerful separation technique, the mode of production of the terephthaHc acid determines its impurity content, which in turn may make purification by distillation difficult. Processes resulting in the alteration of the impurities by catalytic treatment have been developed so that distillation can perform the necessary purification. 

Other crystallization parameters have been determined for some of the polymers. The dependence of the melting temperature on the crystallization temperature for the orthorhombic form of POX (T = 323K) and both monoclinic (T = 348K) and orthorhombic (T = 329K) modifications of PDMOX has been determined (284). The enthalpy of fusion, Aff, for the same polymers has been determined by the polymer diluent method and by calorimetry at different levels of crystallinity (284). for POX was found to be 150.9 J/g (36.1 cal/g) for the dimethyl derivative, it ranged from 85.6 to 107.0 J/g (20.5—25.6 cal/g). Numerous crystal stmcture studies have been made (285—292). Isothermal crystallization rates of POX from the melt have been determined from 19 to —50 C (293,294). Similar studies have been made for PDMOX from 22 to 44°C (295,296). 

SolubiHty parameters of 19.3, 16.2, and 16.2 (f /cm ) (7.9 (cal/cm ) ) have been determined for polyoxetane, po1y(3,3-dimethyl oxetane), and poly(3,3-diethyloxetane), respectively, by measuring solution viscosities (302). Heat capacities have been determined for POX and compared to those of other polyethers and polyethylene (303,304). The thermal decomposition behavior of poly[3,3-bis(ethoxymethyl)oxetane] has been examined (305). 

Extraction Solvent. Dimethyl sulfoxide is immiscible with alkanes but is a good solvent for most unsaturated and polar compounds. Thus, it can be used to separate olefins from paraffins (93). It is used in the Institute Fransais du Pntrole (IFF) process for extracting aromatic hydrocarbons from refinery streams (94). It is also used in the analytical procedure for determining polynuclear hydrocarbons in food additives (qv) of petroleum origin (95). 

These reactions iavolve mostly dimethyl and diethyl sulfate. CycHc sulfates are also reactive, and several have been compared by determining reaction rates with a substituted pyridine or with water (40). In both cases, 1,2-ethylene sulfate is more reactive than 1,3-propylene sulfate or dimethyl or diethyl sulfates. 

The phthalate esters are one of the most widely used classes of organic esters, and fortunately they exhibit low toxicity (82). Because of the ubiquitous nature of phthalates, many iavestigations have been conducted to determine their toxicides to marine life as well as ia mammals (83—85). Generally, phthalates are not absorbed through the skin and are not very potent when inhaled. The phthalates become less toxic as the alcohol group increases in molecular weight. For example, dimethyl phthalate has an oral LD q (mouse) of 7.2 g/kg, whereas di(2-ethylhexyl) phthalate shows an oral LD q (rat) of greater than 26 g/kg. 

Aminopteridine is the most sensitive to acid hydrolysis, and 6-amino- and 6-dimethyl-amino-pteridine are also hydrolyzed, even by cold 0.0IN hydrochloric acid, too rapidly for accurate determination of the cation form (52JCS1620). 2-Amino- and 4-amino-pteridine are not readily attacked by IN HCl at 20 °C but at 100 °C the former compound is destroyed and the latter converted into pteridin-4-one (5UCS474). 2,4-Diaminopteridine can be hydrolyzed by refluxing in 6N HCl for 30 minutes to 2-aminopteridin-4-one (pterin 2) and after... 

From the data reported in (63PMH(l)177) it was concluded that hydrophobic substituents reduce the solubility of pyrazole in water (at 20 °C pyrazole, 1 part in 2.5 3,5-dimethyl-pyrazole, 1 part in 52). Another determination gives the following values for the solubilities of pyrazole at 25 °C in water, benzene and cyclohexane (expressed as g/100 g of solvent) 130, 18 and 3 (66AHC(6)347). Indazole is soluble in hot water and most organic solvents, but less so in cold water. 

The enthalpy of combustion of isoxazole was only determined several years ago (78MI41615). For isoxazole, AH°c (298.15 K) =-(1649.85 0.50) kJ mol , from which the entropy of formation in the gas phase was derived as AH tig) = 78.50 0.54 kJ moF. The enthalpies of combustion of 3-amino-5-methylisoxazole and 5-amino-3,4-dimethyl-isoxazole have also been determined (73MI41606). 

An alternative view of these addition reactions is that the rate-determining step is halide-assisted proton transfer, followed by capture of the carbocation, with or without rearrangement Bromide ion accelerates addition of HBr to 1-, 2-, and 4-octene in 20% trifluoroacetic acid in CH2CI2. In the same system, 3,3-dimethyl-1-butene shows substantial rearrangement Even 1- and 2-octene show some evidence of rearrangement, as detected by hydride shifts. These results can all be accoimted for by a halide-assisted protonation. The key intermediate in this mechanism is an ion sandwich. An estimation of the fate of the 2-octyl cation under these conditions has been made ... 

It is generally assumed that the boat transition state is higher in,energy than the chair transition state. There have been several studies aimed at determining the energy difference between the two transition states. One study involved 1,1,1,8,8,8 eu/cno-4,5-dimethyl-2,6-octadienes. Different stereoisomeric products would be predicted for the chair and boat transition states ... 

Chaput, Jeminet and Juillard measured the association constants of several simple polyethylene glycols with Na", K", Cs", and Tl". Phase transfer catalytic processes and most biological processes are more likely to involve the first two cations rather than the latter two, so we will confine the discussion to these. Stability constants for the dimethyl ethers of tetra-, penta-, hexa-, and heptaethylene glycols were determined poten-tiometrically in anhydrous methanol solution and are shown in Table 7.1. In the third column of the table, the ratio of binding constants (Ks/K s) is calculated. Note that Simon and his coworkers have referred to this ratio as the selectivity constant. ... 

Other Techniques Continuous methods for monitoring sulfur dioxide include electrochemical cells and infrared techniques. Sulfur trioxide can be measured by FTIR techniques. The main components of the reduced-sulfur compounds emitted, for example, from the pulp and paper industry, are hydrogen sulfide, methyl mercaptane, dimethyl sulfide and dimethyl disulfide. These can be determined separately using FTIR and gas chromatographic techniques. 

---