4-dihydronaphthalene

Both 1 2 dihydronaphthalene and 1 4 dihydronaphthalene may be selectively hydrogenated to 1 2 3 4 tetrahydronaphthalene... 

One of these isomers has a heat of hydrogenation of 101 kJ/mol (24 1 kcal/mol) and the heat of hydrogenation of the other is 113 kJ/mol (27 1 kcal/mol) Match the heat of hydrogenation with the appropriate dihydronaphthalene... 

MEYERS Asymmetric synthesis Chiral oxaioles in asymmetric synthesis of cartxixylic acids, aldehydes, chiral dihydronaphthalenes. 

Experimental studies have indicated that all of the isomers prepared to date are quite reactive, but whether the most stable isomer has been observed is uncertain. Two of the isomeric [lOJarmulenes, as well as other products, are formed by photolysis of c/s-9,10-dihydronaphthalene ... 

Neither compound exhibits properties that would suggest aromaticity. The NMR spectra are consistent with polyene structures. Both compounds are thermally unstable and revert back to dihydronaphthalenes ... 

Electrochemical oxidation of 1,2-dihydronaphthalene or an indene in acetoni-tnle containing triethylamine tris(hydrogen fluoride) provides a mixture of tereoisomeric difluorides and vicinal fluoroacetamides [201] (equation 38)... 

Peroxvaad oxidation of bridged 5,6,7,8-tetrafluoro 1 4-dihydronaphthalene-1,4 imines gives aromatic fluorohydrocarbons by elimination of the imine bridge [91] (equation 84) Almost the same yields are achieved by oxidation with 30% hydrogen peroxide m refluxing methanol [91]... 

The formation of an enamine from an a,a-disubstituted cyclopentanone and its reaction with methyl acrylate was used in a synthesis of clovene (JOS). In a synthetic route to aspidospermine, a cyclic enamine reacted with methyl acrylate to form an imonium salt, which regenerated a new cyclic enamine and allowed a subsequent internal enamine acylation reaction (309,310). The required cyclic enamine could not be obtained in this instance by base isomerization of the allylic amine precursor, but was obtained by mercuric acetate oxidation of its reduction product. Condensation of a dihydronaphthalene carboxylic ester with an enamine has also been reported (311). 

Dihydronaphthalene is often used as a model olefin in the study of epoxidation catalysts, and very often gives product epoxides in unusually high ee s. In 1994, Jacobsen discovered in his study on the epoxidation of 1,2-dihydronaphthalene that the ee of the epoxide increases at the expense of the minor enantiomeric epoxide.Further investigation led to the finding that certain epoxides, especially cyclic aromatically conjugated epoxides, undergo kinetic resolution via benzylic hydroxylation up to a krei of 28 (Scheme 1.4.9). 

Chiral oxazolines developed by Albert I. Meyers and coworkers have been employed as activating groups and/or chiral auxiliaries in nucleophilic addition and substitution reactions that lead to the asymmetric construction of carbon-carbon bonds. For example, metalation of chiral oxazoline 1 followed by alkylation and hydrolysis affords enantioenriched carboxylic acid 2. Enantioenriched dihydronaphthalenes are produced via addition of alkyllithium reagents to 1-naphthyloxazoline 3 followed by alkylation of the resulting anion with an alkyl halide to give 4, which is subjected to reductive cleavage of the oxazoline moiety to yield aldehyde 5. Chiral oxazolines have also found numerous applications as ligands in asymmetric catalysis these applications have been recently reviewed, and are not discussed in this chapter. ... 

The first use of chiral oxazolines as activating groups for nucleophilic additions to arenes was described by Meyers in 1984. " Reaction of naphthyloxazoline 3 with phenyllithium followed by alkylation of the resulting anion with iodomethane afforded dihydronaphthalene 10 in 99% yield as an 83 17 mixture of separable diastereomers. Reductive cleavage of 10 by sequential treatment with methyl fluorosulfonate, NaBKi, and aqueous oxalic acid afforded the corresponding enantiopure aldehyde 11 in 88% yield. 

To a solution of dihydronaphthalene 41 (250 mg, 0.77 mmol) in CH2CI2 (5 mL) was added methyl trifluoromethanesulfonate (227 mg, 1.38 mmol). The mixture was stirred at rt until the starting material had been completely consumed as judged by TLC analysis (3 h). The mixture was cooled to 0°C and a solution of NaBHt (111 mg, 2.92 mmol) in 4 1 MeOH THF (3 mL) was slowly added. The mixture was warmed to rt then quenched with saturated aqueous ammonium chloride (50 mL). The resulting mixture was extracted with CH2CI2 (3 X 50 mL) and the combined organic extracts were dried over anhydrous sodium sulfate, filtered, and concentrated in vacuo. The resulting material was dissolved in 4 1 THF/H2O (5 mL) and oxalic acid (485 mg, 3.85 mmol) was added. The reaction... 

I, 4- and 3,4-Dihydroquinazolines are tautomeric but any attempts to prepare the former w ithout a 1-substituent have led to the latter. The greater stability to proto tropic change of 1,2-dihydronaphthalene over 1,4-dihydronaphthalene is also found in 3,4-dihydroquinazoline. Earlier claims to the preparation of l,4-dihydroquinazolines ° were erroneous and based on incomplete experimental data. The first 1,4-dihydroquinazoline was prepared as recently as 1961. 1-Methyl and l-benzyl-l,4-dihydroquinazolines were obtained from o-methylamino-and o-benzylamino-benzylamines (42) by formylation and ring closure. Attempts to remove the benzyl group gave 3,4-dihydroquinazoline. These 1,4-dihydro compounds are susceptible to oxidation, and attempts made to prepare 1,2-dimethyl-1,4-dihydroquinazoline from o-... 

Treatment of that intermediate with aluminum chloride leads to selective demethylation of that ether para to the carbonyl group (23). Cyclization by means of tosic acid gives the dihydronaphthalene nucleus (24). Alkylation of the phenol with N-(2-chloroethyl)pyrrolidine affords nafoxidine (25). ... 

The oxidation of 1,4-dihydronaphthalene with oxygen with irradiation gave l,2-dihydro-2-naphthyl hydroperoxide that decomposed thermally to 3-benzoxepin (3).189... 

The use of the ionic liquid [bmim][BF4] further improved the Burgess epoxidation system [70]. Chan and coworkers found that replacement of sodium bicarbonate for tetramethylammonium bicarbonate and performing the reaction in [hmim][BF4] allowed for efficient epoxidation of a number of different olefins, including substrates affording acid-labile epoxides (such as dihydronaphthalene (99% yield) and 1-phenylcyclohexene (80% yield)). 

Asymmetric epoxidation of olefins with ruthenium catalysts based either on chiral porphyrins or on pyridine-2,6-bisoxazoline (pybox) ligands has been reported (Scheme 6.21). Berkessel et al. reported that catalysts 27 and 28 were efficient catalysts for the enantioselective epoxidation of aryl-substituted olefins (Table 6.10) [139]. Enantioselectivities of up to 83% were obtained in the epoxidation of 1,2-dihydronaphthalene with catalyst 28 and 2,6-DCPNO. Simple olefins such as oct-l-ene reacted poorly and gave epoxides with low enantioselectivity. The use of pybox ligands in ruthenium-catalyzed asymmetric epoxidations was first reported by Nishiyama et al., who used catalyst 30 in combination with iodosyl benzene, bisacetoxyiodo benzene [PhI(OAc)2], or TBHP for the oxidation of trons-stilbene [140], In their best result, with PhI(OAc)2 as oxidant, they obtained trons-stilbene oxide in 80% yield and with 63% ee. More recently, Beller and coworkers have reexamined this catalytic system, finding that asymmetric epoxidations could be perfonned with ruthenium catalysts 29 and 30 and 30% aqueous hydrogen peroxide (Table 6.11) [141]. Development of the pybox ligand provided ruthenium complex 31, which turned out to be the most efficient catalyst for asymmetric... 

The reaction of butyllithium with 1-naphthaldehyde cyclohexylimine in the presence of (/C )-l,2-diphenylethane-1,2-diol dimethyl ether in toluene at —78 °C, followed by treatment with acetate buffer, gave 2-butyl-1,2-dihydronaphthalene-l-carbaldehyde, which was then reduced with sodium borohydride in methanol to afford (1 R,2.S)-2-butyl-1 -hydroxymcthyl-1,2-dihydronaphthalene in 80% overall yield with 91 % ee83. Similarly, the enantioselective conjugate addition of organolithium reagents to several a,/J-unsaturated aldimines took place in the presence of C2-symmetric chiral diethers, such as (/, / )-1,2-butanediol dimethyl ether and (/, / )- ,2-diphenylethane-1,2-diol dimethyl ether. 

---