1.3- Dicarbonyl compounds, oxidative

Triple and quadruple cyclizations. A wide variety of triple and even quadruple [49, 50] cyclizations can be carried out with multiply unsaturated 1,3-dicarbonyl compounds. Oxidative triple cyclization of 82 affords 70% of 83 since the cyclo-pentanemethyl radical is oxidized to a double bond by Cu(II) (Scheme 26) [47]. Similar cyclization of 84 provides 43% of 85 (Scheme 27) [49]. Oxidative cyclization... 

The most general methods for the syntheses of 1,2-difunctional molecules are based on the oxidation of carbon-carbon multiple bonds (p. 117) and the opening of oxiranes by hetero atoms (p. 123fl.). There exist, however, also a few useful reactions in which an a - and a d -synthon or two r -synthons are combined. The classical polar reaction is the addition of cyanide anion to carbonyl groups, which leads to a-hydroxynitriles (cyanohydrins). It is used, for example, in Strecker s synthesis of amino acids and in the homologization of monosaccharides. The ff-hydroxy group of a nitrile can be easily substituted by various nucleophiles, the nitrile can be solvolyzed or reduced. Therefore a large variety of terminal difunctional molecules with one additional carbon atom can be made. Equally versatile are a-methylsulfinyl ketones (H.G. Hauthal, 1971 T. Durst, 1979 O. DeLucchi, 1991), which are available from acid chlorides or esters and the dimsyl anion. Carbanions of these compounds can also be used for the synthesis of 1,4-dicarbonyl compounds (p. 65f.). 

Treatment of O-silyl enols with silver oxide leads to radical coupling via silver enolates. If the carbon atom bears no substituents, two such r -synthons recombine to symmetrical 1,4-dicarbonyl compounds in good vield (Y. Ito, 1975). 

Cyclohexene derivatives can be oxidatively cleaved under mild conditions to give 1,6-dicarbonyl compounds. The synthetic importance of the Diels-Alder reaction described above originates to some extent from this fact, and therefore this oxidation reaction is discussed in this part of the book. 

Pyrroles from 1,4-dicarbonyl compounds and ammonia isoxazolines from olefins and nitrile oxides. 

Several 1,4-dicarbonyl compounds are prepared based on this oxidation. Typically, the 1,4-diketone 10 or the 1,4-keto aldehyde 12 can be prepared by the allylation of a ketone[24] or aldehyde[61,62], followed by oxidation. The reaction is a good annulation method for cyclopentenones (11 and 13). Syntheses of pentalenene[78], laurenene[67], descarboxyquadrone[79], muscone (14 R = Me)[80]) and the coriolin intermediate 15[71] have been carried out by using allyl group as the masked methyl ketone (facing page). 

Cyclic diols give dicarbonyl compounds The reactions are faster when the hydroxyl groups are cis than when they are trans but both stereoisomers are oxidized by periodic acid... 

The conversion of furans by oxidative acetylation or methoxylation to 2,5-diacetoxy- or 2,5-dimethoxy-2,5-dihydrofurans respectively, and their subsequent hydrogenation to the corresponding tetrahydrofurans, provides a useful source of protected 1,4-dicarbonyl compounds capable of conversion inter alia into the other five-membered heterocycles [Pg.142]

The Hantzsch pyridine synthesis involves the condensation of two equivalents of a 3-dicarbonyl compound, one equivalent of an aldehyde and one equivalent of ammonia. The immediate result from this three-component coupling, 1,4-dihydropyridine 1, is easily oxidized to fully substituted pyridine 2. Saponification and decarboxylation of the 3,5-ester substituents leads to 2,4,6-trisubstituted pyridine 3. 

Alkenes with at least one vinjdic hydrogen undergo oxidative cleavage when treated with ozone, yielding aldehydes (Section 7.9). If the ozonolysis reaction is carried out on a cyclic alkene, a dicarbonyl compound results. 

The rapid synthesis of heteroaromatic Hantzsch pyridines can be achieved by aromatization of the corresponding 1,4-DHP derivative under microwave-assisted conditions [51]. However, the domino synthesis of these derivatives has been reported in a domestic microwave oven [58,59] using bentonite clay and ammoniiun nitrate, the latter serving as both the source of ammonia and the oxidant, hi spite of some contradictory findings [51,58,59], this approach has been employed in the automated high-throughput parallel synthesis of pyridine libraries in a 96-well plate [59]. In each well, a mixture of an aldehyde, ethyl acetoacetate and a second 1,3-dicarbonyl compound was irradiated for 5 min in the presence of bentonite/ammonium nitrate. For some reactions, depending upon the specific 1,3-dicarbonyl compound used. 

Pyridazines 160 were obtained by microwave-assisted reaction of 1,4-dicarbonyl compounds and hydrazine in AcOH and in the presence of DDQ as oxidant in order to obtain the aromatic compound in a one pot reaction [ 105]. The yields reported were relatively low although the method can be applied to the preparation of arrays of trisubstituted pyridazines with high molecular diversity (Scheme 57). 

In a process related to the Knorr pyrrole synthesis, condensation of p-amino alcohols 10 with p-dicarbonyl compounds 11 affords p-hydroxy enamines 12 which are then oxidized to the pyrroles 13 <96TL9203>. 

The obvious Vfittig disconnection gives stabilised ylid (5fi) and keto-aldehyde (57). We have used many such long-chain dicarbonyl compounds in this Chapter and they are mostly produced from available alkenes by oxidative cleavage (e.g. ozonolysis). In this case, cyclic alkene (58) is the right starting material, and this can be made from alcohol (59) by elimination,... 

The tvans alcohol (47) might be made by reduction of ketone (48). Oxidation of (45) would give (48), but an alternative is to add an activating group and disconnect as a 1,3-dicarbonyl compound - standard strategy ior a symmetrical ketone. 

Selenium dioxide can be used to oxidize ketones and aldehydes to a-dicarbonyl compounds. The reaction often gives high yields of products when there is a single type of CH2 group adjacent to the carbonyl group. In unsymmetrical ketones, oxidation usually occurs at the CH2 that is most readily enolized.255... 

A mixture of 1,4-dioxane and water is often used as the solvent for the conversion of aldehydes and ketones by H2Se03 to a-dicarbonyl compounds in one step (Eq. 8.117).331 Dehydrogenation of carbonyl compounds with selenium dioxide generates the a, (i-unsaturated carbonyl compounds in aqueous acetic acid.332 Using water as the reaction medium, ketones can be transformed into a-iodo ketones upon treatment with sodium iodide, hydrogen peroxide, and an acid.333 Interestingly, a-iodo ketones can be also obtained from secondary alcohol through a metal-free tandem oxidation-iodination approach. 

The pyranocoumarin 105 can be prepared via a three-component Diels-Alder reaction between 4-hydroxycoumarin, ethyl vinyl ether and an a-dicarbonyl compound. Similarly to the above, upon treatment of 105 with sulfuric acid in THF, hydrolysis and rearrangement occur to give the furofurochromenone 106. The hemiacetal functionality in 106 may then be oxidized with pyridinium chlorochromate (PCC) to give the lactone 107 <2001EJ03711> (Scheme 28). 

Because of the low oxidation state of the metal [M(II)] in the group 4B metallocene dicarbonyl compounds, all of them, perhaps with the exception of (17—C5Me5)2Ti(CO)2 (27), are very air sensitive and decompose rapidly on exposure to air, forming a yellow solid for the titanium compounds and cream-colored solids for the zirconium and hafnium analogs. While the dicarbonyl 27 is indeed air sensitive, its decomposition appears qualitatively to be much slower relative to the other related complexes. 

In other cases, oxidation of the rhodium or palladium ketocarbenoid to a 1,2-dicarbonyl compound is well established The Rh2(OAc)4-catalyzed decomposition... 

As depicted in the following scheme, in the presence of sodium iodate and pyridine, several 5,6-dihydroxylated benzofuran derivatives were synthesized via an oxidation-Michael addition of P-dicarbonyl compounds to catechols in a one-pot procedure <06TL2615 06JHC1673>. A novel additive Pummerer reaction of 2-benzo[fc]furan sulfilimines with carbon nucleophiles derived from P-dicarbonyl compounds was also employed to the synthesis of 2,3-disubstituted benzo[b]furans <06TL595>. 

The formation of quinoxaline heterocyclic systems is a well-known transformation of benzofuroxanes, which occurs in the presence of /3-dicarbonyl compounds <2001RJ0891, 2003BMC2149, 2003EJM791, 2005JME2019>. For example, the synthesis of quinoxaline 1,4-di-jV-oxides was carried out by reaction of the appropriate benzofuroxane 69 with the corresponding /3-ketoester, using triethylamine as the catalyst (Scheme 15) <2005JME2019>. 

The low yield in this reaction might be caused by a number of reasons. First, the overall reaction is only rapid for readily enolizable compounds. 1,3-Dicarbonyl compounds will therefore be a better choice as compared to acetic acid. Second, to prevent oxidation of radical 54, it is advantageous to work with excess diene and therefore speed up trapping of 54 through diene addition. Finally, lactone 55 can, as an enolizable compound itself, also be oxidized by manganese(III) acetate and form various oxidation products. Shorter reaction time and the use of understoichiometric amounts of oxidant might therefore benefit the overall result. All these factors have been taken into account in the synthesis of bicyclic /-lactone 56, which has been obtained from cyanoacetic acid and 1,3-cyclohexadiene in 78% yield within 15 min reaction time (equation 25)60,88. 

---