Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Cyclooctenes isomerization

The Cyclooctene Isomerization. A reaction that attracted some attention in recent years is the cis-trans isomerization of cyclooctene [84]. The cis isomer is much less strained than the trans, but the latter is readily fonned upon direct photolysis and also upon photosensitization. In this case, two enantiomeric trans isomers are formed. The appropriate loop is a variation of that shown in Figure 14, as shown in Figure 34. This is a phase inverting i -type loop, that... [Pg.367]

The isomerization takes place because the excited states, both 5i and T, of many alkenes have a perpendicular instead of a planar geometry (p. 311), so cis-trans isomerism disappears upon excitation. When the excited molecule drops back to the So state, either isomer can be formed. A useful example is the photochemical conversion of c/s-cyclooctene to the much less stable trans isomer." Another interesting example of this isomerization involves azo crown ethers. The crown ether (5), in which the N=N bond is anti, preferentially binds NH4, Li, and Na, but the syn isomer preferentially binds and Rb (see p. 105). Thus, ions can be selectively put in or taken out of solution merely by turning a light source on or off." ... [Pg.320]

Isomerization of ( /Z) isomers is another important transformation. Isomerization of ( ) and (Z-) conjugated amides is effected photochemically " (photo-isomerization " ). There is a rather high energy barrier for the excited state required for (E/Z) isomerization. Isomerization of the C=C units in dienes is also induced photochemically. " Isomerization of cyclic alkenes is more difficult but cyclooctene is isomerized photochemically. " Conjugated aldehydes have been isomerized... [Pg.991]

The unusually stable cross-ozonide 89 has been reported <06TA1780>, and a range of isomeric mono- and disulfoxides of the E-cyclooctene-derived 1,2,3-trithiolane 90 have been prepared <06T5441>. [Pg.283]

Cyclooctadiene isomers (i.e., 1,5-cod or 1,3-cod) are selectively hydrogenated by [Ru(/74-cod)(/76-C8H1o)] (51) to produce exclusively cyclooctene in THF, under ambient temperature (20 °C) and 1 bar H2 pressure [64]. Again, cyclooctane is only detected when the diene substrate is completely transformed to the monoene. The rate of hydrogenation is higher in case of the conjugated 1,3-cycloocta-diene substrate, whereas isomerization of the non-conjugated 1,5-cyclooctadiene... [Pg.400]

In a quest for a more environment-friendly process it has been found that reaction 8.4 can be catalyzed by Pd(II) complexes of various nitrogen-donor ligands (Scheme 8.1) under not too harsh conditions (100 °C, air) without the need of copper chlorides [10,11]. Of the investigated ligands, sulfonated batophenanthroline proved to be the best. Higher olefins, such as 1-hexene or cyclooctene were similarly transformed by this catalyst. Very importantly, there was no isomerization to internal olefins and 2-hexanone was formed with higher than 99 % selectivity. This outstanding selectivity is probably due to the absence of acid and Cu-chlorides. [Pg.212]

The RLi homochiral ligand complexes are seldom used for the base-promoted isomerization of oxiranes into allylic alcohols because their poor chemoselectivity lead to complex mixtures of products. As examples, the treatment of cyclohexene oxide by a 1 1 i-BuLi/(—)-sparteine mixture in ether at low temperature provides a mixture of three different products arising respectively from -deprotonation (75), a-deprotonation (76) and nucleophilic addition (77) (Scheme 32) . When exposed to similar conditions, the disubstituted cyclooctene oxide 78 affords a nearly 1 1 mixture of a- and -deprotonation products (79 and 80) with moderate ee (Scheme 32, entry 1). Further studies have demonstrated that the a//3 ratio depends strongly on the type of ligand used (Scheme 32, entry 1 vs. entry 2) . ... [Pg.1190]

Die Bestrahlung von cis- 1-Nitro-cycloocten liefert das /ra/u-Isomere, das mit Cyclopen-tadien uber Diels-Alder-Reaktion als trans-2-Nitro-trkydo[8.2.1.01,9 tridec-l 1-en abgefan-gen wird3,4 ... [Pg.253]

Since reactivity of alkenes increases with increasing alkyl substitution, hydration is best applied in the synthesis of tertiary alcohols. Of the isomeric alkenes, cis compounds are usually more reactive than the corresponding trans isomers, but strained cyclic isomeric olefins may exhibit opposite behavior. Thus, for example, frans-cyclooctene is hydrated 2500 times faster than cw-cyclooctene.6 Similar large reactivity differences were observed in the addition of alcohols to strained trans cycloalkenes compared with the cis isomers. frans-Cycloheptene, an extremely unstable compound, for instance, reacts with methanol 109 faster at —78°C than does the cis compound.7... [Pg.285]

Vic-diols can thus be easily converted to alkenes through their reaction with A, A -thiocarbonyldimidazule. The reported synthesis of trans-cyclooctene is illustrative of the method [219]. It should be noted that continuous elimination of rrans-cyclooctene by a stream of argon was necessary to avoid isomerization to the cis isomer. The conversion of cis-cyclooctene to ww-cyclooctene through a trithiocarbonate is described in the same paper. [Pg.35]

C chemical shifts of cycloalkenes given in Table 4.12 [229, 233, 238-241] again reflect the special bonding state of three-membered rings, characterized by the smallest shift values in the series. As shown for cyclooctene in Table 4.12, the relation 6x /) < Sx(E) can also be applied to distinguish ris-frans-isomeric cycloalkenes. [Pg.194]

Transfer hydrogenation of dienes to monoenes 1,5-Cyclooctadiene is selectively reduced to cyclooctene by transfer hydrogenation with isopropanol catalyzed by this metal carbonyl cluster. The first step is isomerization to conjugated diene isomers. 1,5-Hexadiene is reduced under these conditions to frms-3-hexene (19%), os-2-hexene (21%), trans-2-, and cw-3-hexene (56%). Ru3(CO)i2, Os3(CO)12, and Ir4(CO)i2 catalyze isomerization of 1,5-cyclooctadiene, but are less active than Rh6(CO)i6 for transfer hydrogenation. [Pg.288]


See other pages where Cyclooctenes isomerization is mentioned: [Pg.85]    [Pg.92]    [Pg.85]    [Pg.92]    [Pg.188]    [Pg.92]    [Pg.37]    [Pg.78]    [Pg.73]    [Pg.474]    [Pg.83]    [Pg.105]    [Pg.317]    [Pg.77]    [Pg.224]    [Pg.305]    [Pg.30]    [Pg.935]    [Pg.167]    [Pg.104]    [Pg.122]    [Pg.131]    [Pg.259]    [Pg.55]    [Pg.180]    [Pg.25]    [Pg.13]    [Pg.18]    [Pg.21]    [Pg.197]   
See also in sourсe #XX -- [ Pg.7 , Pg.13 , Pg.16 , Pg.17 , Pg.18 ]




SEARCH



Cycloocten

Cyclooctene

Cyclooctenes

Isomerization, alkenes photochemical, cyclooctene

Photochemistry cyclooctene isomerization

© 2024 chempedia.info