Crystalline Crystallised

Erode and Koleske [134] demonstrated that PCL forms compatible (miscible) blends with phenoxy. They melt-mixed the components and prepared plaques by compression moulding. Samples with more than about 50 wt % PCL (M = 44,000) exhibited PCL crystallinity crystallisation took place over a few days at room temperature during which period samples became hazy and the modulus increased. Quenched samples were used to determine the glass-transition temperature behaviour of amorphous blends. Samples showed a single composition-dependent Tg, indicating miscibility in the amorphous material values of... 

When crystallisation is complete, the mixture of crystals and crude mother-liquor is filtered at the pump, again using a Buchner funnel and flask as described on p. 10, and the crystals remaining in the funnel are then pressed well down with a spatula whilst continual suction of the pump is applied, in order to drain the mother-liquor from the crystals as effectively as possible. If it has been found in the preliminary tests that the crystalline material is almost insoluble in the cold solvent, the crystals in the... 

Acetamide is thus obtained as a colourless crystalline solid, which has a characteristic odour of mice, stated to be due to the presence of small quantities of methylacetamide, CH3CONHCH3. The acetamide can be purified and rendered odourless by re-crystallisation from acetone, and then has m.p. 82°, b.p. 223°. If this recrystallisation is contemplated, the distilled material should be collected directly into a small weighed beaker or conical flask, so that the solidified acetamide can be readily broken up and removed. 

Distil the filtered ethereal solution, using a 100 ml. flask fitted with a dropping-funnel and a side-arm for the condenser observe all the normal precautions for ether distillation (p. 162) and run the ethereal solution into the flask as fast as the ether distils over. When all the ether has distilled off, detach and cool the flask, when the oily colourless residue of saligenin will rapidly crystallise. Weight of product, 5-0 g. m.p. 75-82°. Recrystallise either from a mixture of benzene and petroleum (b.p. 60-80°), or from a minimum of water, allowing the stirred aqueous solution to cool to 65-70° before chilling. The dry crystalline saligenin has m.p. 85-86°. 

Method(B). Add3g. (3ml.)ofbenzonitrileto50ml.of lo-volumes hydrogen peroxide in a beaker, stir mechanically and add i ml. of 10% aqueous sodium hydroxide solution. Warm the stirred mixture at 40° until the oily suspension of the nitrile has been completely replaced by the crystalline benzamide (45-60 minutes). Cool the solution until crystallisation of the benzamide is complete, and then filter at the pump and recrystallise as above. One recrystallisation gives the pure benza-mide, m.p. 129-130° yield of purified material, 2-2-5 S ... 

Occasionally benzoyl chloride gives a product which does not crystallise well in such cases the difficulty may frequently be overcome by using p-nitrobenzoyl chloride, N02C,H4C0C1, or 3,5-dinitrobenzoyl chloride, (NOiljCjHjCOCl (p. 240), which usually give highly crystalline derivatives. 

Physical Properties. Colourless crystalline solid, soluble in boiling water, very sparingly soluble in cold water crystallises 2H2O. The strongly acidic — SO3H group suppresses the normal basic properties of the — NHj group the acid therefore dissolves readily in alkalis, but not in dilute mineral acids. 

Cool the remainder of the filtrate and extract three times with ether, using 20 - 30 ml. for each extraction. Dry the combined ethereal extracts over powdered anhydrous sodium sulphate. Filter into a small flask and distil off the ether on a water-bath. Pour the residual oil into a small dish or beaker crystallisation takes place almost immediately. The salicyl alcohol so obtained is almost pure, but it may, if so desired, be recrystallised from a small quantity of benzene. It is a colourless crystalline solid, m.p. 86 , readily soluble in water it gives a violet coloration with ferric chloride. 

Urease is one of the enzymes which have been obtained in the crystalline state. This has been done by stirring jack bean meal with 30°o aqueous acetone, filtering and allowing the filtrate to remain at o for several hours. The urease which crystallises out is separated by centrifuging and is then recrystallised. Like crystalline pepsin and trypsin, it is a protein. 

Solid organic compounds when isolated from organic reactions are seldom pure they are usually contaminated with small amounts of other compounds ( impurities ) which are produced along with the desired product. Tlie purification of impure crystalline compounds is usually effected by crystallisation from a suitable solvent or mixture of solvents. Attention must, however, be drawn to the fact that direct crystallisation of a crude reaction product is not always advisable as certain impurities may retard the rate of crystallisation and, in some cases, may even prevent the formation of crystals entirely furthermore, considerable loss of... 

If the solvent constituting the crystallisation medium has a compara tively high boiling point, it is advisable to wash the solid with a solvent of low boiling point in order that the ultimate crystalline product may be easily dried it need hardly be added that the crystals should be insoluble or only very sparingly soluble in the volatile solvent. The new solvent must be completely miscible with the first, and should not be applied until the crystals have been washed at least once with the original solvent. 

Dissolve 2 5 g. of hydroxylamine hydrochloride and 4 g. of crystallised sodium acetate in 10 ml. of water in a small flask or in a test-tube. Warm the solution to about 40° and add 2 5 g. of cyclohexanone. Stopper the vessel securely with a cork and shake vigorously for a few minutes the oxime soon separates as a crystalline solid. Cool in ice, filter the crystals at the pump, and wash with a little cold water. RecrystaUise from light petroleum, b.p. 60-80°, and dry the crystals upon filter paper in the air. The yield of pure cycZohexanone oxime, m.p. 90°, is 2 -5 g. 

The benzoyl compounds frequently occlude traces of unchanged benzoyl chloride, which thus escape hydrolysis by the caustic alkali it is therefore advisable, wherever possible, to recrystaUise the benzoyl derivatives from methyl, or ethyl alcohol or methylated spirit, since these solvents will esterify the unchanged chloride and so remove the latter from the recrystalKsed material. Sometimes the benzoyl compound does not crystallise well this difficulty may frequently be overcome by the use of p-nitrobenzoyl chloride or 3 5-dinitro-benzoyl chloride, which usually give highly crystalline derivatives of high melting point (see Section IV,114j. 

The following alternative method may be used. Dissolve 0 01 mol of the phenol and 0 01 mol of a-naphthyl wo-cyanate in 20 ml. of light petroleum (b.p. 60-80°), add 2 drops of triethylamine (or, less satisfactorily, 2 drops of pyridine), reflux for 5 minutes, and allow to crystallise. Filter oflF the crystalline sohd through a sintered glass funnel. 

Hexamethylenetetramine. Pure hexamethylenetetramine [100-97-0] (also called hexamine and HMTA) is a colorless, odorless, crystalline sohd of adamantane-like stmcture (141). It sublimes with decomposition at >200° C but does not melt. Its solubiUty in water varies Htde with temperature, and at 25°C it is 46.5% in the saturated solution. It is a weak monobase aqueous solutions are in the pH 8—8.5 range (142). Hexamethylenetetramine is readily prepared by treating aqueous formaldehyde with ammonia followed by evaporation and crystallisation of the soHd product. The reaction is fast and essentially quantitative (142). 

Bisa.codyl, 4,4 -(2-PyridyLmethylene)bisphenol diacetate [603-50-9] (Dulcolax) (9) is a white to off-white crystalline powder ia which particles of 50 p.m dia predominate. It is very soluble ia water, freely soluble ia chloroform and alcohol, soluble ia methanol and ben2ene, and slightly soluble ia diethyl ether. Bisacodyl may be prepared from 2-pyridine-carboxaldehyde by condensation with phenol and the aid of a dehydrant such as sulfuric acid. The resulting 4,4 -(pyridyLmethylene)diphenol is esterified by treatment with acetic anhydride and anhydrous sodium acetate. Crystallisation is from ethanol. 

Hydrothermal crystallisation processes occur widely in nature and are responsible for the formation of many crystalline minerals. The most widely used commercial appHcation of hydrothermal crystallization is for the production of synthetic quartz (see Silica, synthetic quartz crystals). Piezoelectric quartz crystals weighing up to several pounds can be produced for use in electronic equipment. Hydrothermal crystallization takes place in near- or supercritical water solutions (see Supercritical fluids). Near and above the critical point of water, the viscosity (300-1400 mPa s(=cP) at 374°C) decreases significantly, allowing for relatively rapid diffusion and growth processes to occur. 

Nitrates. Iron(II) nitrate hexahydrate [14013-86-6], Fe(N03)2 6H20, is a green crystalline material prepared by dissolving iron in cold nitric acid that has a specific gravity of less than 1.034 g/cm. Use of denser, more concentrated acid leads to oxidation to iron(III). An alternative method of preparation is the reaction of iron(II) sulfate and barium or lead nitrate. The compound is very soluble in water. Crystallisation at temperatures below — 12°C affords an nonahydrate. Iron(II) nitrate is a useful reagent for the synthesis of other iron-containing compounds and is used as a catalyst for reduction reactions. 

In general, the chemistry of inorganic lead compounds is similar to that of the alkaline-earth elements. Thus the carbonate, nitrate, and sulfate of lead are isomorphous with the corresponding compounds of calcium, barium, and strontium. In addition, many inorganic lead compounds possess two or more crystalline forms having different properties. For example, the oxides and the sulfide of bivalent lead are frequendy colored as a result of their state of crystallisation. Pure, tetragonal a-PbO is red pure, orthorhombic P PbO is yeUow and crystals of lead sulfide, PbS, have a black, metallic luster. 

---