Chiral methanol

Mobile phases used with this stationary phase are typically 0.01 N perchloric acid with small amounts of methanol or acetonitrile. One significant advantage of these phases is that both configurations of the chiral stationary phase are commercially available and can be obtained from J. T. Baker Inc. and Chiral Technologies, Inc. (Crownpak CR). 

Appllca.tlons. MCA is used for the resolution of many classes of chiral dmgs. Polar compounds such as amines, amides, imides, esters, and ketones can be resolved (34). A phenyl or a cycloalkyl group near the chiral center seems to improve chiral selectivity. Nonpolar racemates have also been resolved, but charged or dissociating compounds are not retained on MCA. Mobile phases used with MCA columns include ethanol and methanol. 

Design of chiral catalysis and asymmetric autocatalysis for diphenyl-(l-methyl-pyrrolidin-2-yl) methanol-catalyzed enantioselective additions of organozinc reagents 97YGK994. 

In 1994 Yamamoto et al. developed a novel catalyst which they termed a "Brmsted acid-assisted chiral Lewis acid" (BLA) [10] (Scheme 1.14, Table 1.3). The catalyst 7 was prepared from (R)-3,3 -dihydroxyphenyl)-2,2 -dihydroxy-l,l -binaphthyl by reaction with B(OMe)3 and removal of methanol [10a, dj. The Brmsted acid is essential for both the high reactivity of the Lewis acid and the high enantioselectivity - the... 

However, it was not until the beginning of 1994 that a rapid (<1.5 h) total resolution of two pairs of racemic amino acid derivatives with a CPC device was published [124]. The chiral selector was A-dodecanoyl-L-proline-3,5-dimethylanilide (1) and the system of solvents used was constituted by a mixture of heptane/ethyl acetate/methanol/water (3 1 3 1). Although the amounts of sample resolved were small (2 ml of a 10 inM solution of the amino acid derivatives), this separation demonstrated the feasibility and the potential of the technique for chiral separations. Thus, a number of publications appeared subsequently. Firstly, the same chiral selector was utilized for the resolution of 1 g of ( )-A-(3,5-dinitrobenzoyl)leucine with a modified system of solvents, where the substitution of water by an acidified solution... 

The analytical capability of these matrices has been demonstrated for chiral amines [12, 13]. The procedure is illustrated in Fig. 8-4 for the separation of NapEtNH " CIO . Concentrated methanol/dichloromethane solutions of the racemic mixture were placed on a column containing the chiral macrocycle host. The enantiomers of the ammonium salts were resolved chromatographically with mixtures of methanol and dichloromethane as the mobile phase. The amounts of R and S salts in each fraction were determined by polarimetry. Because the chiral supported macrocycle interacts more strongly with S salts, the R salt passes through the column first and the S salt last, as seen in Fig. 8-4. 

The second system studied was the separation of the chiral epoxide enantiomers (la,2,7,7a-tetrahydro-3-methoxynaphth-(2,3b)-oxirane Sandoz Pharma) used as an intermediate in the enantioselective synthesis of optically active drugs. The SMB has been used to carry out this chiral separation [27, 34, 35]. The separation can be performed using microcrystalline cellulose triacetate as stationary phase with an average particle diameter greater than 45 )tm. The eluent used was pure methanol. A... 

A precursor in the synthesis of a promising calcium sensitizing agent from E. Merck [33], a chiral thiadiazin-2-one EMD 53986, 3,6-Dihydro-5-[l,2,3,4-tetrahy-dro-6-quinolyl]-6-methyl-2H-l,3,4-thiadiazin-2-one [26]. The study was performed using Celluspher , a CSP prepared from cellulose tri(p-methylbenzoate) according to a patent from Ciba-Geigy [34]. The spherical particles had a mean particle diameter of 20 3 pm and the mobile phase was pure methanol. 

Comparisons of LC and SFC have also been performed on naphthylethylcar-bamoylated-(3-cyclodextrin CSPs. These multimodal CSPs can be used in conjunction with normal phase, reversed phase, and polar organic eluents. Discrete sets of chiral compounds tend to be resolved in each of the three mobile phase modes in LC. As demonstrated by Williams et al., separations obtained in each of the different mobile phase modes in LC could be replicated with a simple CO,-methanol eluent in SFC [54]. Separation of tropicamide enantiomers on a Cyclobond I SN CSP with a modified CO, eluent is illustrated in Fig. 12-4. An aqueous-organic mobile phase was required for enantioresolution of the same compound on the Cyclobond I SN CSP in LC. In this case, SFC offered a means of simplifying method development for the derivatized cyclodextrin CSPs. Higher resolution was also achieved in SFC. 

Lipophilic ligands, e.g. 45-49 having chiral L-2-pyrrolidine-methanol moieties, have been prepared and examined for their catalytic activities in reactions with optically active esters (50-52). 

Asymmetric hydrogenolysis of epoxides has received relatively little attention despite the utility such processes might hold for the preparation of chiral secondary alcohol products. Chan et al. showed that epoxysuccinate disodium salt was reduced by use of a rhodium norbornadiene catalyst in methanol/water at room temperature to give the corresponding secondary alcohol in 62% ee (Scheme 7.31) [58]. Reduction with D2 afforded a labeled product consistent with direct epoxide C-O bond cleavage and no isomerization to the ketone or enol before reduction. 

One of the most intensively studied protic chiral ligands, which moreover allows enantioselectivities of up to 95% ee, is the proline-derived (25 )-l- [(25,)-l-methyl-2-pyrrolidinyl]methyl -2-pyrrolidine methanol (6)19-21. 

Thus, enantiomerically pure (S)35- or (R)36-acetoxysuccinimide derivatives of type 1, easily prepared from (S)- or (R)-malic acid, are diastereoselectively reduced with sodium borohydride in methanol at lower temperature to yield 85 % of an 11 1 mixture of diastereomeric hy-droxylactams of type 2, from which the enantiomerically pure chiral /V-acyliminium ions 3 are generated. 

The reaction of butyllithium with 1-naphthaldehyde cyclohexylimine in the presence of (/C )-l,2-diphenylethane-1,2-diol dimethyl ether in toluene at —78 °C, followed by treatment with acetate buffer, gave 2-butyl-1,2-dihydronaphthalene-l-carbaldehyde, which was then reduced with sodium borohydride in methanol to afford (1 R,2.S)-2-butyl-1 -hydroxymcthyl-1,2-dihydronaphthalene in 80% overall yield with 91 % ee83. Similarly, the enantioselective conjugate addition of organolithium reagents to several a,/J-unsaturated aldimines took place in the presence of C2-symmetric chiral diethers, such as (/, / )-1,2-butanediol dimethyl ether and (/, / )- ,2-diphenylethane-1,2-diol dimethyl ether. 

Popova and colleagues47 carried out TLC of oxidation products of 4,4 -dinitrodiphenyl sulphide (the sulphoxide and sulphone) on silica gel + a fluorescent indicator, using hexane-acetone-benzene-methanol(60 36 10 l) as solvent mixture. Morris130 performed GLC and TLC of dimethyl sulphoxide. For the latter, he applied a 6% solution of the sample in methanol to silica gel and developed with methanol-ammonia solution(200 3), visualizing with 2% aqueous Co11 thiocyanate-methanol(2 1). HPLC separations of chiral mixtures of sulphoxides have been carried out. Thus Pirkle and coworkers131-132 reported separations of alkyl 2,4-dinitrophenyl sulphoxides and some others on a silica-gel (Porosil)-bonded chiral fluoroalcoholic stationary phase, with the structure ... 

Hydroxy-L-prolin is converted into a 2-methoxypyrrolidine. This can be used as a valuable chiral building block to prepare optically active 2-substituted pyrrolidines (2-allyl, 2-cyano, 2-phosphono) with different nucleophiles and employing TiQ as Lewis acid (Eq. 21) [286]. Using these latent A -acylimmonium cations (Eq. 22) [287] (Table 9, No. 31), 2-(pyrimidin-l-yl)-2-amino acids [288], and 5-fluorouracil derivatives [289] have been prepared. For the synthesis of p-lactams a 4-acetoxyazetidinone, prepared by non-Kolbe electrolysis of the corresponding 4-carboxy derivative (Eq. 23) [290], proved to be a valuable intermediate. 0-Benzoylated a-hydroxyacetic acids are decarboxylated in methanol to mixed acylals [291]. By reaction of the intermediate cation, with the carboxylic acid used as precursor, esters are obtained in acetonitrile (Eq. 24) [292] and surprisingly also in methanol as solvent (Table 9, No. 32). Hydroxy compounds are formed by decarboxylation in water or in dimethyl sulfoxide (Table 9, Nos. 34, 35). 

Analogous results were obtained for enol ether bromination. The reaction of ring-substituted a-methoxy-styrenes (ref. 12) and ethoxyvinylethers (ref. 10), for example, leads to solvent-incorporated products in which only methanol attacks the carbon atom bearing the ether substituent. A nice application of these high regio-and chemoselectivities is found in the synthesis of optically active 2-alkylalkanoic acids (ref. 13). The key step of this asymmetric synthesis is the regioselective and chemoselective bromination of the enol ether 4 in which the chiral inductor is tartaric acid, one of the alcohol functions of which acts as an internal nucleophile (eqn. 2). 

Figs. 1.6 and 1.7). This type of CD spectrum is observed for certain heterooligomeric peptoid sequences with as few as 33% chiral aromatic residues, in both aqueous and polar organic solvent (acetonitrile, methanol). 

---