Cation commercial type

The term mica includes a whole family of aluminum silicates. Commercial grades differ in the ratio of aluminum to magnesium found (with potassium) in the cationic portion of the mineral crystal. The two prevalent commercial types are... 

A second type of uv curing chemistry is used, employing cationic curing as opposed to free-radical polymerization. This technology uses vinyl ethers and epoxy resins for the oligomers, reactive resins, and monomers. The initiators form Lewis acids upon absorption of the uv energy and the acid causes cationic polymerization. Although this chemistry has improved adhesion and flexibility and offers lower viscosity compared to the typical acrylate system, the cationic chemistry is very sensitive to humidity conditions and amine contamination. Both chemistries are used commercially. 

Strong" Acid Cation Excha.ngers. AH strong acid-type resins are made from styrene—DVB copolymers, with the exception of a minor quantity of phenoHc resin. Batch sulfonation using commercial strength sulfuric acid [8014-95-1] is common. 

Molecular weights of polymers that function as bridging agents between particles are ca 10 —10. Ionic copolymers of acrylamide are the most significant commercially (see Acrylamide POLYMERS). Cationic comonomers include (2-methacryloyloxyethyl)trimethylammonium salts, diethyl aminoethyl methacrylate [105-16-8], and dimethyldiallylammonium chloride [7398-69-8], anionic comonomers include acryUc acid [79-10-7] and its salts. Both types of polyacrylamides, but especially the anionic, can be more effective in the presence of alum (10,11). Polyetbylenimine and vinylpyridine polymers, eg, po1y(1,2-dimethy1-5-viny1pyridiniiim methyl sulfa te) [27056-62-8] are effective but are used less frequentiy. 

The higher aUphatic amine oxides are commercially important because of their surfactant properties and are used extensively in detergents. Amine oxides that have surface-acting properties can be further categorized as nonionic surfactants however, because under acidic conditions they become protonated and show cationic properties, they have also been called cationic surfactants. Typical commercial amine oxides include the types shown in Table 1. 

This chapter describes the use of three commercially available SEC column types for the characterization of nonionic, anionic, and cationic, synthetic water-soluble polymers. These include TSK-PW, Synchropak, and CATSEC columns. Specific examples and experimental procedures are discussed for each type of column. Elowever, the major emphasis is on the use of TSK-PW columns due to their broad applicability for a variety of water-soluble polymers. 

Serizawa and Akashi [95] analyzed the monolayer adsorption of polystyrene latex particles with cationic polyvinylamine grafted on their surface, while Serizawa et al. [96,97] used commercial anionic latex particles. Both types of particles were adsorbed on polyelectrolyte-coated substrates previously prepared by alternating adsorption of cationic and anionic polyelectrolytes such as polyallylamine hydrochloride (PAH) and polystyrene sulfonate sodium salt (PSS) according to the method described by Decher [164]. Using... 

This i>aper describes two broad types of intercalation conpomds which are based on graphite on the one hand and sheet aluminosilicate (clay) hosts on the other. Taken together these provide a rich veiriety of examples of heterogeneously catalysed reactions. Appropriately cation exchanged clays, for example, act as efficient catalysts for a number of commercially important proton catalysed reactions (10-13) (see Table I). Graphite intercalates, whilst also capable of... 

---