Cartridges, injection

Hybrid adhesives, comprised of a polymer adhesive and a synthetic cement, are also used in cartridge injection systems. These are generally fast-cure adhesives and may exhibit superior resistance to high temperatures. 

Unlike bucket-mixed or cementitious grouts, cartridge injection anchor systems are generally suitable for horizontal and, in some cases, overhead installation because of the use of thixotropic resin formulations. When installing adhesive anchors overhead, special measures must be taken to ensure that the resin remains in the hole and that the anchor rod does not displace downward during resin cure. Care must be taken to avoid skin and eye exposure to uncured resin. 

METHODS OF ADMINISTERING INSULIN. Several methods can be used to administer insulin. The most common method is the use of a needle and syringe Use of microfine needles has reduced the discomfort associated with an injection. Another method is the jet injection system, which uses pressure to deliver a fine stream of insulin below the skin. Another method uses a disposable needle and special syringe The syringe uses a cartridge that is prefilled with a specific type of insulin (eg, regular human insulin, isophane [NPH] insulin, or a mixture of isophane and regular insulin). 

Heat and reflux a 5-g portion of soil sample with 50 mL of methanol-phosphate buffer (pH 7)-water (15 7 28, v/v/v) solvent mixture in a round-bottom flask for 1 h. After cooling, transfer a 10-mL portion of the supernatant to a test-tube and mix with 11 mL of 0.02M H3PO4 solution. Load this solution on to a silica-based SPE cartridge (Analytichem International Clin-Elut 1020) at a flow rate of 1-2 drops per second. Discard this fraction. Elute the analytes with 30 mL of dichloromethane. Concentrate the eluate to dryness with air in a water-bath at a temperature of 40 °C (do not use vacuum). Dissolve the residues in 5mL of HPLC injection solution [900 mL of water - - 50 mL of phosphate buffer (pH 7) 4-50 mL of ACN 4-4 g of TBABr]. Pinal analysis is performed using liquid chromatography/ultraviolet detection (LC/UV) with a three-column switching system. 

Filter. A filter is used in some cases when coagulation and sedimentation do not completely separate the solids from the liquid waste in areas where sand and sandstone formations are susceptible to plugging. Filters with a series of metal screens coated with diatomaceous earth or cartridge filters are typically used.27 Where limestone formations with high solution porosity are used for injection, filtration is usually not required. 

In this design, on-column sample enrichment is incorporated into the sheathless interface (Janini et al., 2003). A miniaturized solid-phase extraction (mSPE) cartridge, made of reversed-phase material, was attached to the CE capillary near the injection end as shown in Fig. 16.1. 

Figure 6.7 depicts an autosampler employed in a jtPLC system. Figure 6.8 details the autosampler component. Samples are transferred from the desired well in the microtiter plate into the columns of the Brio cartridge. If a 384-well plate is employed, the autosampler will carry out 3 sets of 8 injections into the columns, for a total of 24 columns. The solvent (mobile phase) does not circulate in the cartridge but is diverted into a backpressure regulator located in the waste line (Figure 6.2). This process of injection is known as stop-flow injection. After all samples are placed into the injection pits of the 24 columns in the cartridge (Figure 6.5), a clamp containing a seal...

---