Calcium fluids

Translocation of calcium Fluid leakage from venules... 

Aseptic meningitis syndrome-The incidence of this syndrome was 6%. Fever, headache, meningismus, and photophobia were the most commonly reported symptoms a combination of these 4 symptoms occurred in 5% of patients. Headache - Headache is frequently seen after any of the first few doses and may occur in any of the aforementioned neurologic syndromes or by itself. Seizures - Seizures, some accompanied by loss of consciousness or cardiorespiratory arrest, or death, have occurred independently or in conjunction with any of the neurologic syndromes described below. Patients predisposed to seizures may include those with the following conditions Acute tubular necrosis/uremia fever infection a precipitous fall in serum calcium fluid overload hypertension hypoglycemia, history of seizures and electrolyte imbalances those who are taking a medication concomitantly that may, by itself, cause seizures. 

Condy s fluid A disinfectant solution of calcium and potassium permanganates. 

Cascara sagrada is used as a cathartic. It is most useful when prepared as a fluid extract, and tends to be a mild laxative causing Htfle discomfort. However, on prolonged use it may result in characteristic melanotic pigmentation of the rectal mucosa. The bitter taste can be lessened, owing to neutralization of the acid constituents, if the ground substance is moistened and mixed with magnesium or calcium hydroxide. This treatment may lessen the potency of the preparation. 

Secondary coolants frequently are called brines because such fluids originally were mixtures of salts and water. Common refrigeration brines are water solutions of calcium chloride or sodium chloride. These brines must be inhibited against corrosion. 

A typical slag (specific gravity 3.6) contains complex siUcates of iron, calcium, 2iac, magnesium, and aluminum oxides. The quantity of fluxes (compounds added to lower the melting poiat) added depends on the feed composition, and is calculated to ensure a fluid slag at the operating temperature. 

Maleic Anhydride. The ACGIH threshold limit value in air for maleic anhydride is 0.25 ppm and the OSHA permissible exposure level (PEL) is also 0.25 ppm (181). Maleic anhydride is a corrosive irritant to eyes, skin, and mucous membranes. Pulmonary edema (collection of fluid in the lungs) can result from airborne exposure. Skin contact should be avoided by the use of mbber gloves. Dust respirators should be used when maleic anhydride dust is present. Maleic anhydride is combustible when exposed to heat or flame and can react vigorously on contact with oxidizers. The material reacts exothermically with water or steam. Violent decompositions of maleic anhydride can be catalyzed at high temperature by strong bases (sodium hydroxide, potassium hydroxide, calcium hydroxide, alkaU metals, and amines). Precaution should be taken during the manufacture and use of maleic anhydride to minimize the presence of basic materials. 

Acrylate and acrylamide polymers have several uses in drilling fluids, one of which is for filtration control. Sodium polyacrylates [9003-04-7] having molecular weights near 250,000 are exceUent temperature-stable filtration control agents for both fresh- and salt water muds, provided the concentration of water-soluble calcium is <400 mg/L (83). The calcium ions are precipitated using a carbonate such as soda ash, before adding the polyacrylate at concentrations up to ca 6 kg/m (3 Ib/bbl). 

Ion Selective Electrodes Technique. Ion selective (ISE) methods, based on a direct potentiometric technique (7) (see Electroanalytical techniques), are routinely used in clinical chemistry to measure pH, sodium, potassium, carbon dioxide, calcium, lithium, and chloride levels in biological fluids. 

Oilfield Uses. Calcium chloride has two uses in the oilfield as a primary ingredient in completion fluids and as the brine phase in an invert emulsion oil mud. An excellent review of oil well drilling fluids is available (36) (see also Petroleum, drilling fluids). 

In the treatment of poisoning by lead or other metal ions, higher concentrations of chelant can be safely obtained in humans by administering Na2CaEDTA rather than Na EDTA. The metal ion is bound by displacing small amounts of Ca " that the body can tolerate. Use of Na EDTA would result in calcium chelation and thus serious depletion of calcium in the body fluids (44). Removal of iron in Cooley s anemia is accompHshed by using chelants that are relatively specific for iron (45). 

The formulation of calcium chelate materials is based upon the formation of a low-solubiUty chelate between calcium hydroxide and a sahcylate. Dycal utilizes the reaction product of a polyhydric compound and sahcyhc acid. Other sahcyhc acid esters can be similarly used. Vehicles used to carry the calcium hydroxide, extenders, and fillers may include mineral oil, A/-ethyl- -toluenesulfonamide [80-39-7] and polymeric fluids. The filler additions may include titanium dioxide [13463-67-7] zinc oxide, sihca [7631-86-9], calcium sulfate, and barium sulfate [7727-43-7]. Zinc oxide and barium sulfate are useflil as x-ray opacifying agents to ensure a density greater than that of normal tooth stmcture. Resins, rosin, limed rosins, and modified rosins may serve as modifiers of the physical characteristics in both the unset and set states. 

The calcium chelate cements are limited to the use of a cavity liner. They may be placed directly over an exposed tooth pulp to protect the pulp and stimulate the growth of secondary dentin, or used as a therapeutic insulating base under permanent restorations. The high alkalinity and high solubihty of these materials prohibits use in close proximity to soft tissues or in contact with oral fluids. 

---