Alkyl bromides, synthesis

Higher alkyl ethers are prepared by treating the sodium derivative of the phaiol (made by adding the phenol to a solution of sodium ethoxide in ethyl alcohol) with the alkyl iodide or bromide (Williamson synthesis), for example ... 

Hazardous Decomp. Prods. Heated to decomp, or reacted with water or steam, emits toxic and corrosive fumes of Br" and HBr NFPA Health 1, Flammability 4, Reactivity 4 Storage Light-sensitive protect from light Uses Analytical chemistry solvent for ore minerals mfg. of inorganic and some alkyl bromides source of bromide alkylation catalyst for soldering flux raw material for pure terephthalic acid, photographic chems., dyes, pharmaceuticals Manuf./Distrib. Advance Research Chems. Advanced Synthesis Tech. http.//WWW. advancedsynthesis. com, Al bemarle http //www.albemarle.com, Aldrich http //www.sigma-aldrich.com, Alfa Aesar http //WWW. aifa. com... 

A successful variation of the simple alkylation synthesis involves a protected, disguised amine, and is called the Gabriel synthesis (Siegmund Gabriel, 1851-1924). In this procedure, bromomalomc ester is first treated with potassium phthalimide in an Sn2 displacement of bromide ion (Fig. 23.11). 

Alkvl Azides from Alkyl Bromides and Sodium Azide General procedure for the synthesis of alkyl azides. In a typical experiment, benzyl bromide (360 mg, 2.1 mmol) in petroleum ether (3 mL) and sodium azide (180 mg, 2.76 mmol) in water (3 mL) are admixed in a round-bottomed flask. To this stirred solution, pillared clay (100 mg) is added and the reaction mixture is refluxed with constant stirring at 90-100 C until all the starting material is consumed, as obsen/ed by thin layer chromatographv using pure hexane as solvent. The reaction is quenched with water and the product extracted into ether. The ether extracts are washed with water and the organic layer dried over sodium sulfate. The removal of solvent under reduced pressure affords the pure alkyl azides as confirmed by the spectral analysis. ... 

Nickel-allyl complexes prepared from Ni(CO)4 and allyl bromides are useful for the ole-fination of alkyl bromides and iodides (E.J. Corey, 1967 B A.P. Kozikowski, 1976). The reaction has also been extended to the synthesis of macrocycles (E.J. Corey, 1967 C, 1972A). 

Out first example is 2-hydroxy-2-methyl-3-octanone. 3-Octanone can be purchased, but it would be difficult to differentiate the two activated methylene groups in alkylation and oxidation reactions. Usual syntheses of acyloins are based upon addition of terminal alkynes to ketones (disconnection 1 see p. 52). For syntheses of unsymmetrical 1,2-difunctional compounds it is often advisable to look also for reactive starting materials, which do already contain the right substitution pattern. In the present case it turns out that 3-hydroxy-3-methyl-2-butanone is an inexpensive commercial product. This molecule dictates disconnection 3. Another practical synthesis starts with acetone cyanohydrin and pentylmagnesium bromide (disconnection 2). Many 1,2-difunctional compounds are accessible via oxidation of C—C multiple bonds. In this case the target molecule may be obtained by simple permanganate oxidation of 2-methyl-2-octene, which may be synthesized by Wittig reaction (disconnection 1). 

Two synthetic bridged nitrogen heterocycles are also prepared on a commercial scale. The pentazocine synthesis consists of a reductive alkylation of a pyridinium ring, a remarkable and puzzling addition to the most hindered position, hydrogenation of an enamine, and acid-catalyzed substitution of a phenol derivative. The synthesis is an application of the reactivity rules discussed in the alkaloid section. The same applies for clidinium bromide. 

The synthesis of these disubstituied thioureas takes place in three steps. First the alkyl bromide is prepared by the action of hydrobromic acid on the corresponding alcohol (518). Then the dialkylcyanamide is obtained by treatment at 25°C with calcium cyanamide. The yields are of the order of 30 to 60%. Thioureas are obtained in a third step from the cyanamide by reaction at 40 C with HjS in the presence of pyridine. Yields ranged from 57 to 90% (518),... 

Both reactants m the Williamson ether synthesis usually originate m alcohol pre cursors Sodium and potassium alkoxides are prepared by reaction of an alcohol with the appropriate metal and alkyl halides are most commonly made from alcohols by reaction with a hydrogen halide (Section 4 7) thionyl chloride (Section 4 13) or phosphorus tri bromide (Section 4 13) Alternatively alkyl p toluenesulfonates may be used m place of alkyl halides alkyl p toluenesulfonates are also prepared from alcohols as their imme diate precursors (Section 8 14)... 

An asymmetric synthesis of estrone begins with an asymmetric Michael addition of lithium enolate (178) to the scalemic sulfoxide (179). Direct treatment of the cmde Michael adduct with y /i7-chloroperbenzoic acid to oxidize the sulfoxide to a sulfone, followed by reductive removal of the bromine affords (180, X = a and PH R = H) in over 90% yield. Similarly to the conversion of (175) to (176), base-catalyzed epimerization of (180) produces an 85% isolated yield of (181, X = /5H R = H). C8 and C14 of (181) have the same relative and absolute stereochemistry as that of the naturally occurring steroids. Methylation of (181) provides (182). A (CH2)2CuLi-induced reductive cleavage of sulfone (182) followed by stereoselective alkylation of the resultant enolate with an allyl bromide yields (183). Ozonolysis of (183) produces (184) (wherein the aldehydric oxygen is by isopropyUdene) in 68% yield. Compound (184) is the optically active form of Ziegler s intermediate (176), and is converted to (+)-estrone in 6.3% overall yield and >95% enantiomeric excess (200). 

A considerable amount of hydrobromic acid is consumed in the manufacture of inorganic bromides, as well as in the synthesis of alkyl bromides from alcohols. The acid can also be used to hydrobrominate olefins (qv). The addition can take place by an ionic mechanism, usually in a polar solvent, according to Markownikoff s rule to yield a secondary alkyl bromide. Under the influence of a free-radical catalyst, in aprotic, nonpolar solvents, dry hydrogen bromide reacts with an a-olefin to produce a primary alkyl bromide as the predominant product. Primary alkyl bromides are useful in synthesizing other compounds and are 40—60 times as reactive as the corresponding chlorides (6). 

Anhydrous HBr is available in cylinders (6.8-kg and 68-kg capacity) under its own vapour pressure (24 atm at 25°C) and in lecture bottles (450-g capacity). Its main industrial use is in the manufacture of inorganic bromides and the synthesis of alkyl bromides either from alcohols or by direct addition to alkenes. HBr also catalyses numerous organic reactions. Aqueous HBr (48% and 62%) is available as a corrosive pale-yellow liquid in drums or in large tank trailers (15 0001 and 38 0001). 

Chiral oxazolines have also been utilized for the synthesis of ehiral ketones bearing quaternary earbon stereoeenters. As shown below, reaetion of substituted oxazoline 30 with 2 equiv PhLi followed by treatment with benzyl bromide gives ketone 33 upon aeidie hydrolysis. This reaetion is believed to proeeed via addition of PhLi to keteneimine 31 to afford metalated enamine 32, whieh undergoes alkylation at the nueleophilie earbon to provide 33 after aqueous workup. ... 

Independent synthesis of IQ, eliminating the alkylating reaction step, involved the cyclizations of 7-R-5-amino-6-methylaminoquinolines with cyanogen bromide. When " C-labeled BrCN was used, the corresponding 2- " C-labeled analogues of IQ and MelQ were synthesized (83ACSI57). The diamines are available from 5-nitroderivatives, which in turn have been prepared by nitration of methylami-noderivatives (82CPB1857). 

---