Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Bearing pads

The unit loading on the pad ean be varied by either adjusting the are length or the axial length of the bearing pad. [Pg.484]

A pre-load of 0.5-1.0 provides for stable operation beeause a eonverging wedge is produeed between the bearing journal and the bearing pads. [Pg.484]

Figure Thrust bearing pad with a temperature sensor installed. (Courtesy of Turbocare, A Division of Demag Delavaf Tuibomat inery Corp., Houston facing... Figure Thrust bearing pad with a temperature sensor installed. (Courtesy of Turbocare, A Division of Demag Delavaf Tuibomat inery Corp., Houston facing...
Short, longitudional bearing pads attached to the heated rod at a number of positions. [Pg.272]

With the 18-in. wrap, and with the bearing pads, there was a tendency for the burn-out flux to increase slightly at low mass velocities otherwise there was no significant effect. [Pg.273]

Because of its very low friction coefficient, PTFE is used for bearings, ball- and roller-bearing components, and sliding bearing pads in static and dynamic load supports.11 Piston rings of filled PTFE in nonlubricated compressors permit operation at lower power consumption or at increased capacities.12... [Pg.72]

ZIRCALOYSTROCTOfiAL END PLATE ZIRCALOY END CAP ZIRCALOY BEARING PADS URANIUM DIOXIDE PELLETS ZIRCALOY FUEL SHEATH ZIRCALOY SPACERS GRAPHITE COATING... [Pg.558]

Use Antivibration components, transmission seals, hoses, bushings, automotive weatherstrip, solid tires, storage tanks, and bridge bearing pads. [Pg.1239]

The principal applications for ETFE are found in such products as gaskets, packings, and seals (O-rings, lip and X-rings) in areas where corrosion is a problem. The material is also used for sleeve, split cmled, and thrust bearings, and for bearing pads for pipe and equipment support where expansion and contraction or movement may occiu-. [Pg.541]

It is used for bearings required to operate without lubricant and as static bearing pads for bridge expansion joints. [Pg.226]

C. If the above protective measures fail, the high torque produced by the motor will cause a slow breakdown of the bearings and not a rapid shaft seizure. Industry experience indicates that the babbitt bearing surfaces wear away and the bearing pads and sleeves will be badly worn but the shaft will continue to rotate. [Pg.135]

Soleplates (also called bearing pads, leveling plates or embedments)... [Pg.661]

ZnCALOY BEARING PADS CANLUB QRAPHrrE INTERUYER URANIUM DIOXIDE PELLETS... [Pg.182]

Zircaloy bearing pads Canlub graphite interlayer Uranium dioxide pellets... [Pg.476]

See other pages where Bearing pads is mentioned: [Pg.351]    [Pg.943]    [Pg.1853]    [Pg.478]    [Pg.69]    [Pg.69]    [Pg.66]    [Pg.70]    [Pg.101]    [Pg.101]    [Pg.91]    [Pg.1656]    [Pg.351]    [Pg.766]    [Pg.1612]    [Pg.63]    [Pg.1099]    [Pg.1103]    [Pg.6]    [Pg.23]    [Pg.522]    [Pg.543]    [Pg.1102]    [Pg.1106]    [Pg.947]    [Pg.1857]    [Pg.686]    [Pg.687]    [Pg.199]    [Pg.16]    [Pg.243]    [Pg.72]    [Pg.393]    [Pg.103]   
See also in sourсe #XX -- [ Pg.6 ]

See also in sourсe #XX -- [ Pg.16 , Pg.243 , Pg.254 ]

See also in sourсe #XX -- [ Pg.102 ]

See also in sourсe #XX -- [ Pg.537 ]



SEARCH



Bridge bearing pads

PAD

Padding

© 2024 chempedia.info