Barrier, laboratory gloves

Handling of retrieved implants and tissues may pose safety concerns for laboratory personnel. As a precautionary measure, retrieved implants should be sterilized and disinfected carefully. In cases where implants cannot be sterilized prior to analysis due to protocol requirements, extreme care should be taken to use an aseptic technique. Barrier clothing, gloves and biosafety cabinets should be used. A detailed discussion of precautions to be used in handling of human tissues can be found in ISO 12891-1. 

Care should be taken to ensure that protective equipment is worn correctly, and that no exposed skin is visible gloves and laboratory coats are worn to ensure that dermal contact is minimized and to provide a continuous protective barrier to the skin from powder contact. Disposable sleeve covers are also suggested if arms are inserted far enough that laboratory coats could be covered with hazard. 

Skin, too, has add-ons that increase its effectiveness as a barrier. In a biochemistry laboratory you often have to wear gloves to protect yourself from the material you re handling, but sometimes you have to wear gloves to protect the material from you. People who work with RNA wear gloves because human skin excretes an enzyme that chops up RNA. Why It turns out that many viruses are made from RNA. To such a virus, the enzyme is like razor wire on the skin any RNA that tries to breach the barrier gets lacerated. 

Permeation time This means the time required for a chemical to break through a glove material after direct contact. It gives an indication of the duration of the protective barrier. A breakthrough has happened when, in a laboratory test according to EN 374-3, the permeation rate exceeds 1 pL cm min . ... 

Work with explosive (or potentially explosive) materials generally requires the use of special protective apparel (e.g., face shields, gloves, and laboratory coats) and protective devices such as explosion shields, barriers, or even enclosed barricades or an isolated room with a blowout roof or window (see Chapter 6, sections 6.F.1 and 6.F.2). Before work with a potentially explosive material is begun, the experiment should be discussed with a supervisor or an experienced co-worker, and/or the relevant literature consulted (see Chapter 3, sections 3.B.2, 3.B.5, and 3.B.6). A risk assessment should be carried out. 

---