TAPPING MODE ATOMIC

Zong Q, inniss D, K]oiier K and Eiings V B 1993 Fractured poiymer/siiica fiber surface studied by tapping mode atomic force microscopy Surf. Sc/. Lett. 290 L688... 

Flansma P K ef a/1994 Tapping mode atomic force microscopy in iiquids Appl. Phys. Lett. 64 1738... 

Bar, G., Delineau, L., Hafele, A. and Whangbo, M.H., Investigation of the stiffness change in, the indentation force and the hydrophobic recovery of plasma-oxidized polydimethyl-siloxane surfaces by tapping mode atomic force microscopy. Polymer, 42(8), 3627-3632 (2001). 

FIGURE 12.10 Tapping mode atomic force microscopy (AFM) images of the section analyzes of ethylene-propylene-diene monomer (EPDM) rubber-melamine fiber composites. A, composite containing no dry bonding system B, composite containing resorcinol, hexamine, and silica in the concentrations 5, 3, and 15 phr, respectively. 

Zhong, Q., Innis, D., Kjoller, K., and Elings, V., Fractured polymer/silica fiber surface studied by tapping mode atomic force microscopy. Surf. Sci. Lett., 290, 688, 1993. 

Cleveland, J.P., Anczykowski, B., Schmid, A.E., and Elings, V.B., Energy dissipation in tapping-mode atomic force microscopy, Appl. Phys. Lett., 12, 2613, 1998. 

Ebenstein, Y., Nahum, E., and Banin, U., Tapping mode atomic force microscopy for nanoparticle sizing Tip-sample interaction effects, Nano Lett., 2, 945, 2002. 

Magonov, S.N., Elings, V., Cleveland, J., Denley, D., and Whangbo, M.-H., Tapping-mode atomic force microscopy study of the near-surface composition of a styrene-butadiene-styrene triblock copolymer film, Surf. Sci., 389, 201, 1997. 

FIGURE 21.20 Tapping-mode atomic force microscopic (AFM) height image left) and phase image right) of NRIO sample. The stmctures indicated hy circles are considered to he carhon hlack (CB) fillers. 

Resch, R. Friedbacher, G. Grasserbauer, M. Kanniainen, T. Lindroos, S. Leskela, M. Niinisto, L. 1997. In situ investigations on the SILAR-growth of ZnS films as studied by tapping mode atomic force microscopy (TM-AFM). Fresenius J. Anal. Chem. 358 80-84. 

Tapered module design, 15 835 Tapholes, blast furnace, 14 505-507, 509 Taphonomy, 5 752 Tapioca/cassava starch, 4 724t Tapping mode, in atomic force microscopy, 77 63 Tapping-mode AFM, 24 84 Tapping mode atomic force microscopy (TMAFM), 14 465, 16 501 Taq polymerase, 72 513 Taquidil... 

Figure 28. Solid-state dc electrical measurements of polyphenylene oxide in an ITO PPO Gain sandwich. The thickness of the polymer was measured by tapping-mode atomic force microscopy. (Reprinted with permission from ref 23. Copyright 2004 American Chemical Society.)...

Tapping-mode atomic force microscopy studies showed that as these hyperbranched PAA films became somewhat less smooth as they increased in thickness through successive grafting stages [24]. For example, a very smooth initial single-crystal Au(lll) surface with a root mean square (RMS) roughness of 0.2 nm (over a 2 xm x 2 im area) had its roughness increased to... 

TMAFM Tapping Mode Atomic Force Microscope... 

Vandamme N, Snauwaert J, Janssens E, Vandeweert E, Lievens P, Van Haesendonck C (2004) Visualization of gold clusters deposited on a dithiol self-assembled monolayer by tapping mode atomic force microscopy. Surf Sci 558 57-64... 

TCLP TDB TDF THC TBP TEM TLM TM-AFM TOC TRLFS TRU TSP TST TVS Toxicity characteristics leaching procedure Thermodynamic database Tyre-derived fuel Total hydrocarbon Tri-n-butyl phosphate Transmission electron microscopy Triple layer model Tapping mode atomic force microscopy Total organic carbon Time-resolved laser fluorescence spectroscopy Transuranic Total suspended particles Transition state theory Transportable vitrification system... 

Stark, R. W. and Heckl, W. M. (2000). Fourier transformed atomic force microscopy tapping mode atomic force microscopy beyond the Hookian approximation. Surface Science 457,219-28. [319]... 

However, this subject continued to be a controversial matter. Some authors used atomic force microscopy (AFM) in tapping mode to prove the existence of a two-phase structure in epoxy networks this structures comprises a hard microgel phase and a dispersed phase of soft partially reacted material (Vanlandingham et al., 1999). However, the interpretation of this kind of experimental result seems still to depend very much on what one wants to find. 

Sullivan, E. J., Hunter, D. B., and Bowman, R. S. (1997). Topological and thermal properties of surfactant-modified clinoptilolite studied by tapping-mode atomic force microscopy and high-resolution thermogravimetric analysis. Clays Clay Miner., 45(1), 42-53. 

---