Arenes isomerization

Mechanisms of C8 arene isomerization have been reviewed. ... 

Large annulenes tend to undergo conformational distortion, cis-trans isomerizations, and sig-matropic rearrangements (p. 40 and p. 100). Methylene-bridged conjugated (4n + 2)-ic cyclopolyenes were synthesized with the expectation that these almost planar annulenes should represent stable HOckel arenes (E, Vogel, 1970, 1975). 

Tnfluoroacetic anhydnde in a mixture with sulfuric acid is an efficient reagent for the sulfonylation of aromatic compounds [44] The reaction of benzene with this system in nitromethane at room temperature gives diphenyl sulfone in 61% yield Alkyl and alkoxy benzenes under similar conditions form the corresponding diaryl sulfones in almost quantitative yield, whereas yields of sulfones from deactivated arenes such as chlorobenzene are substantially lower [44] The same reagent (tnfluoroacetic anhydride-sulfunc acid) reacts with adamantane and its derivatives with formation of isomeric adamantanols, adamantanones, and cyclic sultones [45]... 

Dihydro-9,10-epoxyphenanthrene and related arene oxides are of considerable interest as carcinogens formed by polycyclic aromatic hydrocarbons in vivo.45 Phenanthrene oxide does not isomerize to the corresponding dibenzoxepin under thermal conditions. Photolysis of... 

Vol. E19b, p 1866f).190 191 Bulky substituents in the 2- and 7-positions, sueh as /erf-butyl groups, prevent the isomerization to arene oxides.191... 

Thiepin, as a seven-membered conjugated system with sulfur as heteroatom, is a member of the 8 7t-electron heteroannulenes which are antiaroinatic according to Hiickel s rule. In contrast to oxepin, thiepin is not stable at room temperature and no valence isomerism with an arene sulfide has been observed. Stable thiepins are obtained only when two bulky substituents, e.g. /ert-butyl, are introduced into positions 2 and 7. In benzothiepins the annellation effect of the aromatic rings contributes decisively to the stability of these compounds stability increases with an increasing number of fused benzene rings. 

Bis-arene iron dications [20] are easily accessible from arenes, A1C13 and FeCl3 (for C6Me6, FeCl2 must be used). It is advisable to use tris-sublimated A1C13 to avoid problems of isomerization [23], With toluene, this isomerization due to the re/ro-Friedel-Crafts mechanism [24] is too extensive to give any clean complex. 

The synthesis and characterization of the monomeric amidinato-indium(I) and thallium(I) complexes [Bu C(NAr)2]M[But(NAr(NHAr)] (M = In, Tl Ar = 2,6-Pr2CgH3) have been reported. Both compounds were isolated as pale yellow crystals in 72-74% yield. These complexes, in which the metal center is chelated by the amidinate ligand in an N, j -arene-fashion (Scheme 33), can be considered as isomers of four-membered Group 13 metal(I) carbene analogs. Theoretical studies have compared the relative energies of both isomeric forms of a model compound, In[HC(NPh)2]. ... 

Data for a series of [Ru(ri6-arene)Cl(en)](PF6) complexes with the isomeric p-, o-, and m-terphenyls mirrored these observations (74). The complex with the most extended arene (p-terphenyl, 14) was the most potent, with potency similar to cisplatin, but is not cross-resistant, and has a much higher activity than its isomeric complexes. Again, no cross-resistance with cisplatin was observed for these complexes (74). 

DNA-binding studies on the series of isomeric [Ru(rj6-arene) Cl(en)]+ compounds with o-, m-, or p-terphenyl as the arene further illustrate the importance of the hydrophobicity and... 

Histidine residues are, however, generally regarded as major possible binding sites for ruthenium-arene complexes in proteins. To model this interaction, we also studied the reaction of [RuCl(en)(rj6-bip)]+ (10) with L-histidine at 310 K in aqueous solution (91). The reaction was quite sluggish and did not reach equilibrium until 24 h at 310 K, by which time only about 22% of the complex had reacted. Two isomeric imidazole-bound histidine adducts could be discerned, with more or less equal binding of Ne... 

Denmark pursued intramolecular alkyne hydrosilylation in the context of generating stereodefined vinylsilanes for cross-coupling chemistry (Scheme 21). Cyclic siloxanes from platinum-catalyzed hydrosilylation were used in a coupling reaction, affording good yields with a variety of aryl iodides.84 The three steps are mutually compatible and can be carried out as a one-pot hydro-arylation of propargylic alcohols. The isomeric trans-exo-dig addition was also achieved. Despite the fact that many catalysts for terminal alkyne hydrosilylation react poorly with internal alkynes, the group found that ruthenium(n) chloride arene complexes—which provide complete selectivity for trans-... 

The isomerizations have also proven to be very useful in the synthesis of a series of 1,3-diarylallenes [49-55], even tolerating other functional groups such as aryl chlorides, aryl bromides [56-58] and vinyl bromides [59]. Mixed systems with an alkene on one side and an arene on the other could also be prepared [41, 60], as well as products with two olefinic substituents [61] or bisallenes [62-64],... 

Substrate 38 also nicely displays the selectivity accompanying the neighboring alkenes or arenes whereas with two alkyl chains on an alkyne two products would be formed, here a selective isomerization to the conjugated allene is observed. 

---