Application weight

Average Time Period First Generic Applicant Second Generic Applicant Weighted Average... 

Mixture Cement, Sacks Sand. Cu. Yd. Stone. Cu. Yd. Application Weight, Tons per Cu. Yd. 

Usually, for good printing, the tip of the squeegee blade should be arranged opposite the centre of the counter-pressure roller—where contact is made with the screen. Its vertical adjustment should be checked carefully on both sides of the screen to ensure an even alignment across the width. If coating with PVC, so as to raise the application weight, the tip can be placed above the centre of the counter-pressure roller. 

Method TVpe of molecular weight average Applicable weight range ... 

The application of adsorbents can be classified according to the adsorbents themselves, the chemicals to be cleaned up, the type of spill (i.e. large or small scale) and whether the spill liquid can be pumped to containers for conventional treatment or the type of chemical/water interaction (Robinson, 1979). Chemicals that mix with water can be treated in conventional adsorption systems, or adsorbents can be spread onto the spill and mixing achieved by agitation. For chemicals that float, booms, blankets, fibers, or powders are available. Applying sorbents to chemicals that sink is the most difficult application. Weighted sorbent bags and sacks have been developed. For this purpose, in addition, the use of dense adsorbents... 

Obviously, in space applications, weight, and possibly volume, impose severe limitations. Consequently a brief outline of some basic aspects in the choice and design of such cooling systems may be in order here. 

Application Weight. The weight of vitreous enamel coating applied, per unit area covered. 

The cost savings offered by the applications will determine which method of lightweighting is applied in a specific case. While in certain applications weight savings of up to 70% achievable by machining may be sufficient, other applications may require lightweighting factors of 85% and more than can be obtained with fused mirrors. 

Polaqua 138 is a water-based primer specifically developed for water resistant bonds of polyethylene to aluminum foil by lamination or extrusion. It is applied by convmtitHial application methods (gravure, flexo, rod, roll, etc.) to the accepting substrate. The primer must be thoroughly and absolutely dry before introduction of the extrudate or lamination. Polaqua 138 should be applied as received using light application weights. 

Bond layer thickness the thickness of the set layer of adhesive in millimeters. It may be influenced by the application weight and the fixing pressure. In general, a thin (< 0.001 mm) and uniform bond layer leads to the highest bond strengths. 

Furniture Foil Adhesives. These adhesives consist primarily of ethylene-vinyl acetate copol)mer emulsions. Rigid PVC and melamine-paper foils, generally 0.2 - 0.4 mm thick, are applied to wood-based materials for decorative purposes. The adhesives must exhibit high tack and high resistance to heat and cold and must counteract the shrinkage of the film (application weight 60-100g/m ). 

Part Number Application Weight, kg Volume, L Voltage, V Current, A Capacity, Ah Energy density ... 

Individual tiedowns being used to secure cargo found in conditions outlined in the table are not out-of-service, only violations. If these tiedowns are reouired to meet the requirements for length and/or weight, the out-of-service condition(s) will be recorded under the applicable weight and/or length and/or the specific commodity. (393.104)... 

Cell size (g) Application Weight (cra ) Terminals raps Volume Voltage... 

---