Analytical Detection of Acids and Derivatives

Carboxylic acids dissolve in Na,CO, thereby evolving CO,. The neutralization equivalent or equivalent weight of a carboxylic acid is determined by titration with standard base it is the number of grams of acid neutralized by one equivalent of base. If 40.00 mL of a O.IOON base is needed to 

The neutralization equivalent is found by dividing the weight of acid by the number of equivalents of base, i.e. 

Problem 16.51 A carboxylic acid has GMW= 118. and 169.6mL of LOGON KOH neutralizes 10.0g of the acid. When heated, 1 mol of this acid loses 1 mol of H,0 without loss of CO2. What is the acid  

The volume of base (0.1696L) multiplied by the normality of the base (I.OOOeq/L) gives 0.1696 as the number of equivalents of acid titrated. Since the weight of acid is 10.0 g. one equivalent of acid weighs 

Because the molecular weight of the acid (118) is twice this equivalent weight, there must be two equivalents per mole. The number of equivalents gives the number of ionizable hydrogens. This carboxylic acid has two COOH groups. 

The two COOH s weigh 90 g, leaving 118 g — 90 g = 28 g (two C s and four H s) as the weight of the rest of the molecule. Since no C02 is lost on heating, the COOH groups must be on separate C s. The compound is succinic acid, HOOC—CH2 —CH2 —COOH. 

---

The fermentation-derived food-grade product is sold in 50, 80, and 88% concentrations the other grades are available in 50 and 88% concentrations. The food-grade product meets the Vood Chemicals Codex III and the pharmaceutical grade meets the FCC and the United States Pharmacopoeia XK specifications (7). Other lactic acid derivatives such as salts and esters are also available in weU-estabhshed product specifications. Standard analytical methods such as titration and Hquid chromatography can be used to determine lactic acid, and other gravimetric and specific tests are used to detect impurities for the product specifications. A standard titration method neutralizes the acid with sodium hydroxide and then back-titrates the acid. An older standard quantitative method for determination of lactic acid was based on oxidation by potassium permanganate to acetaldehyde, which is absorbed in sodium bisulfite and titrated iodometricaHy. 

Gotti et al. [42] reported an analytical study of penicillamine in pharmaceuticals by capillary zone electrophoresis. Dispersions of the drug (0.4 mg/mL for the determination of (/q-penicillaminc in water containing 0.03% of the internal standard, S -met hy I - r-cystei ne, were injected at 5 kPa for 10 seconds into the capillary (48.5 cm x 50 pm i.d., 40 cm to detector). Electrophoresis was carried out at 15 °C and 30 kV, with a pH 2.5 buffer of 50 mM potassium phosphate and detection at 200 rnn. Calibration graphs were linear for 0.2-0.6 pg/mL (detection limit = 90 pM). For a more sensitive determination of penicillamine, or for the separation of its enantiomers, a derivative was prepared. Solutions (0.5 mL, final concentration 20 pg/mL) in 10 mM phosphate buffer (pH 8) were mixed with 1 mL of methanolic 0.015% 1,1 -[ethylidenebis-(sulfonyl)]bis-benzene and, after 2 min, with 0.5 mL of pH 2.5 phosphate buffer. An internal standard (0.03% tryptophan, 0.15 mL) was added and aliquots were injected. With the same pH 2.5 buffer and detection at 220 nm, calibration graphs were linear for 9.3-37.2 pg/mL, with a detection limit of 2.5 pM. For the determination of small amounts of (L)-penicillamine impurity, the final analyte concentration was 75 pg/mL, the pH 2.5 buffer contained 5 mM beta-cyclodextrin and 30 mM (+)-camphor-10-sulfonic acid, with a voltage of 20 kV, and detection at 220 nm. Calibration graphs were linear for 0.5-2% of the toxic (L)-enantiomer, with a detection limit of 0.3%. 

Chau and Terry [146] reported the formation of penta-fluorobenzyl derivatives of ten herbicidal acids including 4-chloro-2-methyl-phenoxy acetic acid [145]. They found that 5h was an optimum reaction time at room temperature with pentafluorobenzyl bromide in the presence of potassium carbonate solution. Agemian and Chau [147] studied the residue analysis of 4-chloro-2-methyl phenoxy acetic acid and 4-chloro-2-methyl phenoxy butyric acid from water samples by making the pentafluorobenzyl derivatives. Bromination [148], nitrification [149] and esterification with halogenated alcohol [145] have also been used to study the residue analysis of 4-chloro-2-methyl phenoxy acetic acid and 4-chloro-2-methyl phenoxybutyric acid. Recently pentafluorobenzyl derivatives of phenols and carboxylic acids were prepared for detection by electron capture at very low levels [150, 151]. Pentafluorobenzyl bromide has also been used for the analytical determination of organophosphorus pesticides [152],... 

---