Ammonium, quaternary bonded phase

Some other very important events in the historic development of asymmetric organocatalysis appeared between 1980 and the late 1990s, such as the development of the enantioselective alkylation of enolates using cinchona-alkaloid-based quaternary ammonium salts under phase-transfer conditions or the use of chiral Bronsted acids by Inoue or Jacobsen for the asymmetric hydro-cyanation of aldehydes and imines respectively. These initial reports acted as the launching point for a very rich chemistry that was extensively developed in the following years, such as the enantioselective catalysis by H-bonding activation or the asymmetric phase-transfer catalysis. The same would apply to the development of enantioselective versions of the Morita-Baylis-Hillman reaction,to the use of polyamino acids for the epoxidation of enones, also known as the Julia epoxidation or to the chemistry by Denmark in the phosphor-amide-catalyzed aldol reaction. ... 

Ion-exchange chromatography (lEC). Stationary phases for the separation of mixtures of ionic solutes, such as inorganic cations and anions, amino acids and proteins, are based either on microparticulate ion-exchange resins, which are crosslinked co-polymers of st)U ene and divinyl benzene, or on bonded phase silicas. Both types have either sulfonic acid cation-exchange sites (-SO3 H ) or quaternary ammonium anion-exchange sites (-N RjOH") incorporated into their structures. 

The asymmetric Darzens condensation, which involves both carbon-carbon and carbon-oxygen bond constructions, was realized by use of the chiral azacrown ether 75als2,s ,ss and the quaternary ammonium salts derived from cinchona alka-loids159"621 under phase transfer catalyzed conditions. The a,p-epoxy ketone 80 (R=Ph) was obtained with reasonable enantioselectivity by the reaction of... 

The hydration number (the number of water molecules intimately associated with the salt) of the quaternary ammonium salt is very dependent upon the anion. The change in the order of reactivity is thus believed to be due to the hydration of the anion the highly hydrated chloride and cyanide ions are less reactive than expected, and the poorly hydrated iodide fares better under phase transfer conditions than in homogeneous reactions. Methanol may specifically solvate the anions via hydrogen bonding, and this effect is responsible for the low reactivity of more polar nucleophiles in that solvent. 

The synthesis of polyhalide salts, R4NX , used in electrophilic substitution reactions, are described in Chapter 2 and H-bonded complexed salts with the free acid, R4NHX2, which are used for example in acid-catalysed cleavage reactions and in electrophilic addition reactions with alkenes, are often produced in situ [33], although the fluorides are obtained by modification of method I.I.I.B. [19, 34], The in situ formation of such salts can inhibit normal nucleophilic reactions [35, 36]. Quaternary ammonium chlorometallates have been synthesized from quaternary ammonium chlorides and transition metal chlorides, such as IrClj and PtCl4, and are highly efficient catalysts for phase-transfer reactions and for metal complex promoted reactions [37]. 

The ability of quaternary ammonium halides to form weakly H-bonded complex ion-pairs with acids is well established, as illustrated by the stability of quaternary ammonium hydrogen difluoride and dihydrogen trifluorides [e.g. 60] and the extractability of halogen acids [61]. It has also been shown that weaker acids, such as hypochlorous acid, carboxylic acids, phenols, alcohols and hydrogen peroxide [61-64] also form complex ion-pairs. Such ion-pairs can often be beneficial in phase-transfer reactions, but the lipophilic nature of H-bonded complex ion-pairs with oxy acids, e.g. [Q+X HOAr] or [Q+X HO.CO.R], inhibits O-alkylation reactions necessitating the maintenance of the aqueous phase at pH > 7.0 with sodium or potassium carbonate to ensure effective formation of ethers or esterification [49,64]. 

It is noteworthy that benzyltriethylammonium chloride is a slightly better catalyst than the more lipophilic Aliquat or tetra-n-butylammonium salts (Table 5.2). These observations obviously point to a mechanism in which deprotonation of the amine is not a key catalysed step. As an extension of the known ability of quaternary ammonium halides to form complex ion-pairs with halogen acids in dichloromethane [8], it has been proposed that a hydrogen-bonded ion-pair is formed between the catalyst and the amine of the type [Q+X—H-NRAr] [5]. Subsequent alkylation of this ion-pair, followed by release of the cationic alkylated species, ArRR NH4, from the ion-pair and its deprotonation at the phase boundary is compatible with all of the observed facts. 

The simplest C-C bond formation reaction is the nucleophilic displacement of a halide ion from a haloalkane by the cyanide ion. This was one of the first reactions for which the kinetics under phase-transfer catalysed conditions was investigated and patented [l-3] and is widely used [e.g. 4-12], The reaction has been the subject of a large number of patents and it is frequently used as a standard reaction for the assessment of the effectiveness of the catalyst. Although the majority of reactions are conducted under liquiddiquid two-phase conditions, it has also been conducted under solidrliquid two-phase conditions [13] but, as with many other reactions carried out under such conditions, a trace of water is necessary for optimum success. Triphase catalysis [14] and use of the preformed quaternary ammonium cyanide [e.g. 15] have also been applied to the conversion of haloalkanes into the corresponding nitriles. Polymer-bound chloroalkanes react with sodium cyanide and cyanoalkanes under phase-transfer catalytic conditions [16],... 

Palladium-catalysed C-C bond formation under Heck reaction conditions, which normally requires anhydrous conditions and the presence of copper(I) salts, is aided by the addition of quaternary ammonium salts. It has been shown that it is frequently possible to dispense with the copper catalyst and use standard two-phase reactions conditions [e.g. 18, 19]. Tetra-/i-butylammonium salts catalyse the palladium-catalysed reaction of iodoarenes with alkynes to yield the arylethynes in high yield [20, 21], whereas the reaction with 3-methylbut-1 -yn-3-ol (Scheme 6.30) provides a route to diarylethynes [22]. Diarylethynes are also formed from the reaction of an iodoarene with trimethylsilylethyne [23], Iodoalkynes react with a,p-unsaturated ketones and esters to produce the conjugated yne-eneones [19],... 

The increase in the rate of reactions catalysed by quaternary ammonium salts is often proportional to the concentration of the catalyst used. When I started to collect data for their use in organic synthesis, it rapidly became obvious that it was difficult to make a clear distinction between purely catalytic reactions and those using stoichiometric amounts of the ammonium salt this was because the practical techniques often varied (e.g., liquidiliquid two-phase reactions vs liquid solid two-phase reactions). Consequently, I have presented a general practical overview of the use quaternary ammonium salts, categorised according to specific bond formations or reaction types. I have tried to be as comprehensive as possible, but in order to keep the text concise, some abstruse experimental variations have been omitted, as has a complete citation of the patent literature. 

Subsequent ion exchange of the metal cation with the quaternary ammonium ion catalyst provides a lipophilic ion pair (step 2), which either reacts with the requisite alkyl electrophile at the interface (step 3) or is partitioned into the electrophile-containing organic phase, whereupon alkylation occurs and the catalyst is reconstituted. Enantioselective PTC has found apphcation in a vast number of chemical transformations, including alkylations, conjugate additions, aldol reactions, oxidations, reductions, and C-X bond formations." ... 

Less rigorous reaction conditions are required to cleave the double bond to form ketones and carboxylic acids. Phase-transfer-assisted permanganate oxidations in the presence of quaternary ammonium salts,439 652-654 crown ethers,439,655 or polyethers566 usually ensure high yields. Terminal alkenes are transformed to carboxylic acids with one carbon atom less than the starting compound.653,654... 

Porous silica particles can be used to support alkylphenyl chains substituted by sulfonated groups or quaternary ammonium groups using covalent bonding (silica — R — NR3)+OH . This approach is similar to that used to obtain the bonded silica phases used in HPLC. Certain phases compound the particularities of each technique. In such cases, separation depends on ionic coefficients as well as the partition coefficient. 

Close proximity of the oppositely charged functional groups can be achieved in ion exchangers with covalently bonded zwitterionic molecules in which two or three methylene chains separate the carboxylate or sulfonate and quaternary ammonium groups [ 13-151. This arrangement results in the establishment of a combination of repulsion and attraction electrostatic forces and such stationary phases have been used for the separation of seven or eight anions and cations [13,141. 

Due to its ability to form inverted hexagonal phase, DOPE is believed to impart fusogenicity to lipoplexes, thus facilitating fusion followed by destabilization of the endosomal membrane, lipoplex escape from the endosomes, and eventually the DNA release. Indeed, inclusion of DOPE into lipoplexes was shown to enhance considerably the transfection activity of some of the cationic lipid carriers [35,120, 121]. For example, formulations of oxypropyl quaternary ammonium cationic lipids with 50 mol% DOPE have been reported to exhibit 2-5 times higher transfection activity in COS7 cells than formulations with pure cationic lipid (Fig. 29) [35]. Recently, a triple-bond dialkynoyl analog of DOPE has been... 

These TLC plates have cation- or anion-exchange resins bonded to their surfaces. The resins are materials such as styrene-divinylbenzene copolymers having either quaternary ammonium or sulphonic acid groupings for ion exchange. They are particularly usefril for substmices of high molecular weight and for amphoteric materials. Strong acids or alkalis are usually used as mobile phases. 

---