Amines characterization

Lithium dialkylamide. Four catalysts, namely lithium dimethylamide, lithium diethylamide, lithium di-n-butylamide and lithium di-i-propylamide, have been prepared by the reaction of ji-butyllithium and the corresponding amines. Characterization of these amides was performed by G.C.-Mass Spectroscopy after D O quenching of the amides. Further analysis for the total alkalinity was performed by a titration... 

Primary aromatic amines characterized by high mobility of hydrogen atoms may be thiomethylated using formaldehyde and hydrogen sulfide (Equation 17) <2003RCB1817>. 

A set of 126 primary, secondary, and tertiary amines characterized by seven property descriptors afforded two significant principal components which described 85% of the total variance. For details, see [63]. A preliminary study of 29 amines was used for the selection of co-substrates in studies on the Willgerodt-Kindler reaction [21]. 

It is used as a catalyst in esterification, dehydration, polymerization and alkylation reactions. Converted by e.g., ihionyl chloride, to melhanesulphonyl chloride (mesyl chloride) which is useful for characterizing alcohols, amines, etc. as melhanesulphonyl (mesyl) derivatives. 

Elimination unimolecular (El) mechanism (Section 5 17) Mechanism for elimination characterized by the slow for mation of a carbocation intermediate followed by rapid loss of a proton from the carbocation to form the alkene Enamine (Section 17 11) Product of the reaction of a second ary amine and an aldehyde or a ketone Enamines are char actenzed by the general structure... 

Three generations of latices as characterized by the type of surfactant used in manufacture have been defined (53). The first generation includes latices made with conventional (/) anionic surfactants like fatty acid soaps, alkyl carboxylates, alkyl sulfates, and alkyl sulfonates (54) (2) nonionic surfactants like poly(ethylene oxide) or poly(vinyl alcohol) used to improve freeze—thaw and shear stabiUty and (J) cationic surfactants like amines, nitriles, and other nitrogen bases, rarely used because of incompatibiUty problems. Portiand cement latex modifiers are one example where cationic surfactants are used. Anionic surfactants yield smaller particles than nonionic surfactants (55). Often a combination of anionic surfactants or anionic and nonionic surfactants are used to provide improved stabiUty. The stabilizing abiUty of anionic fatty acid soaps diminishes at lower pH as the soaps revert to their acids. First-generation latices also suffer from the presence of soap on the polymer particles at the end of the polymerization. Steam and vacuum stripping methods are often used to remove the soap and unreacted monomer from the final product (56). 

The functional group ia collectors for nonsulfide minerals is characterized by the presence of either a N (amines) or an O (carboxyUc acids, sulfonates, etc) as the donor atoms. In addition to these, straight hydrocarbons, such as fuel oil, diesel, kerosene, etc, are also used extensively either as auxiUary or secondary collectors, or as primary collectors for coal and molybdenite flotation. The chain length of the hydrocarbon group is generally short (2—8 C) for the sulfide collectors, and long (10—20 C) for nonsulfide collectors, because sulfides are generally more hydrophobic than most nonsulfide minerals (10). 

The pigments are manufactured either by reaction of the dianhydride with an amine or N,N -diaLkylation of the diimide. They are characterized by high tinctorial strength, excellent solvent stabiUty, very good weatherfastness, moderate brightness, and range in color from red to violet. An exception is the dianhydride which is not stable to alkah. 

Like mthenium, amines coordinated to osmium in higher oxidation states such as Os(IV) ate readily deprotonated, as in [Os(en) (NHCH2CH2NH2)] [111614-75-6], This complex is subject to oxidative dehydrogenation to form an imine complex (105). An unusual Os(IV) hydride, [OsH2(en)2] [57345-94-5] has been isolated and characterized. The complexes of aromatic heterocycHc amines such as pyridine, bipytidine, phenanthroline, and terpyridine ate similar to those of mthenium. Examples include [Os(bipy )3 [23648-06-8], [Os(bipy)2acac] [47691-08-7],... 

Amides can be titrated direcdy by perchloric acid ia a nonaqueous solvent (60,61) and by potentiometric titration (62), which gives the sum of amide and amine salts. Infrared spectroscopy has been used to characterize fatty acid amides (63). Mass spectroscopy has been able to iadicate the position of the unsaturation ia unsaturated fatty amides (64). Typical specifications of some primary fatty acid amides and properties of bisamides are shown ia Tables 5 and 6. 

The characterizations of MDA and PMDA are similar to those normally used for aromatic amines. In the manufacture of PMDA, the MDA isomer distribution and the formation of side products is deterrnined primarily by gas chromatography (48,49). The amine content is deterrnined by acid titration... 

Amines can also swell the polymer, lea ding to very rapid reactions. Pyridine, for example, would be a fairly good solvent for a VDC copolymer if it did not attack the polymer chemically. However, when pyridine is part of a solvent mixture that does not dissolve the polymer, pyridine does not penetrate into the polymer phase (108). Studies of single crystals indicate that pyridine removes hydrogen chloride only from the surface. Kinetic studies and product characterizations suggest that the reaction of two units in each chain-fold can easily take place further reaction is greatiy retarded either by the inabiUty of pyridine to diffuse into the crystal or by steric factors. 

Amine—borane adducts have the general formula R3N BX where R = H, alkyl, etc, and X = alkyl, H, halogen, etc. These compounds, characterized by a coordinate covalent bond between boron and nitrogen, form a class of reducing agents having a broad spectmm of reduction potentials (5). 

The reaction between a trinuclear metal carbonyl cluster and trimetbyl amine borane has been investigated (41) and here the cluster anion functions as a Lewis base toward the boron atom, forming a B—O covalent bond (see Carbonyls). Molecular orbital calculations, supported by stmctural characterization, show that coordination of the amine borane causes small changes in the trinuclear framework. 

Oxaziridines are powerful oxidizing agents. Free halogen is formed from hydrobromic acid (B-67MI50800). Reduction by iodide in acidic media generally yields a carbonyl compound, an amine and two equivalents of iodine from an oxaziridine (1). With 2-alkyl-, 2-acyl and with N-unsubstituted oxaziridines the reaction proceeds practically quantitatively and has been used in characterization. Owing to fast competing reactions, iodide reduction of 2-aryloxaziridines does not proceed quantitatively but may serve as a hint to their presence. 

On the basis of data obtained the possibility of substrates distribution and their D-values prediction using the regressions which consider the hydrophobicity and stmcture of amines was investigated. The hydrophobicity of amines was estimated by the distribution coefficient value in the water-octanole system (Ig P). The molecular structure of aromatic amines was characterized by the first-order molecular connectivity indexes ( x)- H was shown the independent and cooperative influence of the Ig P and parameters of amines on their distribution. Evidently, this fact demonstrates the host-guest phenomenon which is inherent to the organized media. The obtained in the research data were used for optimization of the conditions of micellar-extraction preconcentrating of metal ions with amines into the NS-rich phase with the following determination by atomic-absorption method. 

Enamine (Section 17.11) Product of the reaction of a secondary amine and an aldehyde or a ketone. Enamines are characterized by the general structure... 

The third class of compounds to be discussed in this chapter are those in which an RE group (E = S, Se, Te) is attached to a nitrogen centre. This category includes amines of the type (REfsN and the related radicals [(RE)2N] , as well as organochalcogen(ir) azides, REN3, and nitrenes REN (E = S, Se). Covalent azides of the type RTe(N3)3 and R2Te(N3)2, in which the chalcogen is in the +4 oxidation state, have also been characterized. 

For purposes of characterization of enamines the perchlorate salts are preferred, as they crystallize well, and the perchlorate anion has no tendency to add to the iminium cation. Other salts, including hexachlorostannates (13), hexachloroantimonates (13), chlorides, bromides, tetraphenylborates, and nitrates, have also been used. Recently a method for the preparation of iminium salts directly from aldehydes or ketones and the amine perchlorate has been reported (16). 

---