Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Allylic halides coupling reactions

Allylic halides couple effectively with vinyltin reagents to provide the corresponding 1,4-dienes in high yields.2 Like nickel- and palladium-catalyzed Grignard reactions with allylic ethers, this reaction also proceeds with net inversion of configuration at the allylic center. Similarly, vinyl epoxides react... [Pg.232]

Lithiation at C2 can also be the starting point for 2-arylatioii or vinylation. The lithiated indoles can be converted to stannanes or zinc reagents which can undergo Pd-catalysed coupling with aryl, vinyl, benzyl and allyl halides or sulfonates. The mechanism of the coupling reaction involves formation of a disubstituted palladium intermediate by a combination of ligand exchange and oxidative addition. Phosphine catalysts and salts are often important reaction components. [Pg.98]

The copper species formed depends on the solvent, and three different species were detected by F NMR, although the structure of each species was not elucidated [245 This copper reagent undergoes a variety of coupling reactions with aryl, alkenyl, allyl, and acetylenic halides [244, 245 (equation 162)... [Pg.709]

Copper(I) halide-catalyzed coupling reactions of perfluoro Gngnard reagents with allyl and propargyl halides have been reported [256], The acetylenic copper compound may be an intermediate in these reactions. [Pg.713]

Palladium And/Or Copper-Mediated Cross-Coupling Reactions Between 1-Alkynes And Vinyl, Aryl, 1-Alkynyl, 1,2-Propadienyl, Propargyl And Allylic Halides Or Related Compounds. A Review, Rossi. R. Carpita, A. Beilina, F. Org. Prep. Proceed. Int., 1995, 27, 129... [Pg.22]

As complex 67 outperforms the Fe(0)-ate complexes in rate and yield, shown in the reaction of cyclooctenyl bromide with PhMgBr (full conversion complex 67 <20 min, 81% yield, 38 18 h, 39% yield), it was shown that both Fe(0)-ate and Fe (—2)-ate complexes should be intermediates in cross-coupling reactions, but the major contribution should be made by the route emanating from Fe(—2)-com-plexes. The superiority of Fe(—2)-ate complexes was also shown in the stoichiometric insertion of 67 into allylic halides, which proceeded much faster (<5 min) than with any higher valent iron complex (hours or days). [Pg.195]

Nickel carbonyl effects coupling of allylic halides when the reaction is carried out in very polar solvents such as DMF or DMSO. This coupling reaction has been used intramolecularly to bring about cyclization of to-allylic halides and was found useful in the preparation of large rings. [Pg.755]

The reductive coupling of allyl halides to 1,5-hexadiene at glassy C electrodes was catalyzed by tris(2, 2,-bipyridyl)cobalt(II) and tris(4,4 -dimethyl-2, 2/-bipyridyl)cobalt(II) in aqueous solutions of 0.1 M sodium dodecylsulfate (SDS) or 0.1 M cetyltrimethylammonium bromide (CTAB).48 An organocobalt(I) intermediate was observed by its separate voltammetric reduction peak in each system studied. This intermediate undergoes an internal redox reaction to form 1,5-hexadiene... [Pg.181]

There are many other transition-metal catalyzed coupling reactions that are based on organic halides in aqueous media. One example is the coupling of terminal alkyne with aryl halides, the Sonogashira coupling, which has been discussed in detail in the chapter on alkynes (Chapter 4). An example is the condensation of 2-propynyl or allyl halides with simple acetylenes in the presence of copper salts. [Pg.192]

In the Pd-catalyzed cross-coupling reactions of acylzirconocene chlorides with allylic halides and/or acetates (Section 5.4.4.4), the isolation of the expected p,y-unsaturated ketone is hampered by the formation of the a, P-un saturated ketone, which arises from isomerization of the p,y-double bond. This undesirable formation of the unsaturated ketone can be avoided by the use of a Cu(I) catalyst instead of a Pd catalyst [35], Most Cu(I) salts, with the exception of CuBr - SMe2, can be used as efficient catalysts Thus the reactions of acylzirconocene chlorides with allyl compounds (Table 5 8 and Scheme 5 30) or propargyl halides (Table 5.9) in the presence of a catalytic amount (10 mol%) of Cu(I) in DMF or THF are completed within 1 h at 0°C to give ffie acyl--allyl or acyl-allenyl coupled products, respectively, in good yields. ill... [Pg.170]

Table S.8. Cu(l)-catalyzed coupling reactions with allyl halides, a j 10mol%Cu(l) p... Table S.8. Cu(l)-catalyzed coupling reactions with allyl halides, a j 10mol%Cu(l) p...
These copper reagents do not react with epoxides, but they undergo SN2 reactions with allylic halides (equation II). These reagents also couple with acyl... [Pg.227]


See other pages where Allylic halides coupling reactions is mentioned: [Pg.44]    [Pg.44]    [Pg.284]    [Pg.297]    [Pg.238]    [Pg.240]    [Pg.349]    [Pg.349]    [Pg.36]    [Pg.452]    [Pg.254]    [Pg.535]    [Pg.540]    [Pg.540]    [Pg.541]    [Pg.541]    [Pg.542]    [Pg.563]    [Pg.653]    [Pg.805]    [Pg.187]    [Pg.195]    [Pg.288]    [Pg.705]    [Pg.731]    [Pg.1336]    [Pg.181]    [Pg.181]    [Pg.225]    [Pg.81]    [Pg.209]    [Pg.676]    [Pg.117]    [Pg.129]    [Pg.168]    [Pg.168]   


SEARCH



1.4- Dienes coupling reactions of allylic halides

Allyl halides

Allyl halides reactions

Allylic coupling

Allylic halides

Coupling Reaction of Allyl Halides

Coupling allylic halides

Coupling reactions allyl

Coupling reactions halide

Cross-coupling reaction with allylic halides

Halides allylation

© 2024 chempedia.info