Aryl aldehydes hydrogenation

When the Gattermann aldehyde synthesis (hydrogen cyanide-zinc chloride) is applied to some benzyl alkyl or aryl ketones, isoquinolines are formed [2268]. Application of the Schmidt reaction to tra/u-dibenzoylstilbene at a temperature slightly above that of the surroundings converts it into a 4-benzoylquinoline [2216]. Care should be exercised with the use of hydrazoic acid. The acetal... 

From Other Rings. Instead of preparing 5-aryl-2-hydroxythiophens (32) by allowing 4-aryl-4-oxobutanoic acid to react with PaSs, it is considered better to prepare first the butenolide (31) by treatment of the acid with acetic anhydride followed by sodium hydrosulphide. The crude (32) can be transformed into (33) in a one-pot procedure by its reaction with an aromatic aldehyde and hydrogen chloride. A patent describes the synthesis of more... 

Aldehydes. Aryl, heterocyclic, and vinylic halides react at 80-150° under about 1000 psi of carbon monoxide and hydrogen (1 1) in the presence of these palladium complexes as catalysts and a tertiary amine (1 eq.) to give aldehydes, usually in good yields. The reaction is actually believed to involve a series of... 

The alcohol loses hydrogen, which takes the place of the diazonium group, and is thereby converted into an aldehyde. Whether hydrogen or an alkoxyl group enters into combination with the aryl radical is determined by the nature of the diazonium compound and alcohol, and by the conditions under which decomposition takes place, such as the temperature and the pressure. 

When allylic alcohols are used as an alkene component in the reaction with aryl halides, elimination of /3-hydrogen takes place from the oxygen-bearing carbon, and aldehydes or ketones are obtained, rather than y-arylated allylic alcohoIs[87,88]. The reaction of allyl alcohol with bromobenzene affords dihydrocinnamaldehyde. The reaction of methallyl alcohol (96) with aryl halides is a good synthetic method for dihydro-2-methylcinnamaldehyde (97). 

Sulfur tetrafluoride [7783-60-0] SF, replaces halogen in haloalkanes, haloalkenes, and aryl chlorides, but is only effective (even at elevated temperatures) in the presence of a Lewis acid catalyst. The reagent is most often used in the replacement of carbonyl oxygen with fluorine (15,16). Aldehydes and ketones react readily, particularly if no alpha-hydrogen atoms are present (eg, benzal fluoride [455-31-2] from benzaldehyde), but acids, esters, acid chlorides, and anhydrides are very sluggish. However, these reactions can be catalyzed by Lewis acids (HP, BF, etc). 

Synthesis and Properties. Polyquinolines are formed by the step-growth polymerization of o-aminophenyl (aryl) ketone monomers and ketone monomers with alpha hydrogens (mosdy acetophenone derivatives). Both AA—BB and AB-type polyquinolines are known as well as a number of copolymers. Polyquinolines have often been prepared by the Friedlander reaction (88), which involves either an acid- or a base-catalyzed condensation of an (9-amino aromatic aldehyde or ketone with a ketomethylene compound, producing quinoline. Surveys of monomers and their syntheses and properties have beenpubhshed (89—91). 

Aromatic Aldehydes. Carbon monoxide reacts with aromatic hydrocarbons or aryl haHdes to yield aromatic aldehydes (see Aldehydes). The reaction of equation 24 proceeds with yields of 89% when carried out at 273 K and 0.4 MPa (4 atm) using a boron trifluoride—hydrogen fluoride catalyst (72), whereas conversion of aryl haHdes to aldehydes in 84% yield by reaction with CO + H2 requires conditions of 423 K and 7 MPa (70 atm) with a homogeneous palladium catalyst (73) and also produces HCl. 

Reductive amination (Section 22.10) Reaction of ammonia or an amine with an aldehyde or a ketone in the presence of a reducing agent is an effective method for the preparation of primary, secondary, or tertiary amines. The reducing agent may be either hydrogen in the presence of a metal catalyst or sodium cyanoborohy-dride. R, R, and R" may be either alkyl or aryl. 

Reduction of unsaturated carbonyl compounds to the saturated carbonyl is achieved readily and in high yield. Over palladium the reduction will come to a near halt except under vigorous conditions (73). If an aryl carbonyl compound, or a vinylogous aryl carbonyl, such as in cinnamaldehyde is employed, some reduction of the carbonyl may occur as well. Carbonyl reduction can be diminished or stopped completely by addition of small amounts of potassium acetate (i5) to palladium catalysts. Other effective inhibitors are ferrous salts, such asferroussulfate, at a level of about one atom of iron per atom of palladium. The ferrous salt can be simply added to the hydrogenation solution (94). Homogeneous catalysts are not very effective in hydrogenation of unsaturated aldehydes because of the tendencies of these catalysts to promote decarbonylation. 

Aldehydes and ketones are similar in their response to hydrogenation catalysis, and an ordering of catalyst activities usually applies to both functions. But the difference between aliphatic and aromatic carbonyls is marked, and preferred catalysts differ. In hydrogenation of aliphatic carbonyls, hydrogenolysis seldom occurs, unless special structural features are present, but with aryl carbonyls either reduction to the alcohol or loss of the hydroxy group can be achieved at will. 

As shown in Schemes 10-44 and 10-45, two products may be formed in a Meerwein reaction Scheme 10-44 shows a simple aryl-de-hydrogenation of cinnamic aldehyde, whereas Scheme 10-45 shows an aryl-de-hydrogenation combined with the addition of HC1 to the double bond of the methyl ester of cinnamic acid. No systematic studies have been made as to which of the two products will be formed in a given reaction, what experimental conditions will favor one or the other product, and what substituents or other structural characteristics of the alkene influence the ratio of the two types of product. The addition product can, in most cases, easily be converted... 

Vinylic sulfides containing an a hydrogen can also be alkylated by alkyl halides or epoxides. This is a method for converting an alkyl halide RX to an a,P unsaturated aldehyde, which is the synthetic equivalent of the unknown HC=CH—CHO ion. Even simple alkyl aryl sulfides RCH2SAr and RR CHSAr have been alkylated a to the sulfur. ... 

The dimerization of ketones to 1,2-diols can also be accomplished photochemi-cally indeed, this is one of the most common photochemical reactions. The substrate, which is usually a diaryl or aryl alkyl ketone (though a few aromatic aldehydes and dialkyl ketones have been dimerized), is irradiated with UV light in the presence of a hydrogen donor such as isopropyl alcohol, toluene, or an amine. In the case of benzophenone, irradiated in the presence of 2-propanol, the ketone molecule initially undergoes n — k excitation, and the singlet species thus formed crosses to the T, state with a very high efficiency. 

Thus, [HRh(C0)(TPPTS)3]/H20/silica (TPPTS = sodium salt of tri(m-sulfophenyl)phopshine) catalyzes the hydroformylation of heavy and functionalized olefins,118-122 the selective hydrogenation of a,/3-unsaturated aldehydes,84 and the asymmetric hydrogenation of 2-(6 -methoxy-2 -naphthyl)acrylic add (a precursor of naproxen).123,124 More recently, this methodology was tested for the palladium-catalyzed Trost Tsuji (allylic substitution) and Heck (olefin arylation) reactions.125-127... 

The quantum yields for oxetane formation have not been determined in every case, and only a few relative rate constants are known. The reactivities of singlet and triplet states of alkyl ketones are very nearly equal in attack on electron rich olefins. 72> However, acetone singlets are about an order of magnitude more reactive in nucleophilic attack on electron-deficient olefins. 61 > Oxetane formation is competitive with a-cleavage, hydrogen abstraction and energy-transfer reactions 60 64> so the absolute rates must be reasonably high. Aryl aldehydes and ketones add to olefins with lower quantum yields, 66> and 3n-n states are particularly unreactive. 76>... 

---