Acoustic wave-based detection

Sheikh S, Blaszykowski C, Thompson M (2008) Acoustic wave-based detection in bioanalytical chemistry competition for surface plasmon resonance Anal Lett 41 2525-2538... 

Vivancos JL, Racz Z, Cole M, Gardner JW (2012) Surface acoustic wave based analytical system for the detection of liquid detergents. Sensor Actuator B 171 469-477... 

A new chemical sensor based on surface transverse device has been developed (99) (see Sensors). It resembles a surface acoustic wave sensor with the addition of a metal grating between the tranducer and a different crystal orientation. This sensor operates at 250 mH2 and is ideally suited to measurements of surface-attached mass under fluid immersion. By immohi1i2ing atra2ine to the surface of the sensor device, the detection of atra2ine in the range of 0.06 ppb to 10 ppm was demonstrated. 

Several other approaches for detecting nucleic acids are reported in the literature, based, for example, on the light-addressable potentiometric sensor (LAPS) (Kung et al. 1990) or on acoustic wave devices (Su et al. 1996). 

Acoustic wave sensors are also used to detect nerve and blister agents. The surface acoustic wave chemical agent detector (SAW Mini-CAD) is a commercially available, pocket-sized instrument that can monitor for trace levels of toxic vapors of sulfur-based mustard agents (e.g., distilled mustard) and G nerve agents (e.g., tabun, sarin, soman) with a high degree of specificity. Colorimetric tubes are the... 

There is increasing interest in the use of specific sensor or biosensor detection systems with the FIA technique (Galensa, 1998). Tsafack et al. (2000) described an electrochemiluminescence-based fibre optic biosensor for choline with flow-injection analysis and Su et al. (1998) reported a flow-injection determination of sulphite in wines and fruit juices using a bulk acoustic wave impedance sensor coupled to a membrane separation technique. Prodromidis et al. (1997) also coupled a biosensor with an FIA system for analysis of citric acid in juices, fruits and sports beverages and Okawa et al. (1998) reported a procedure for the simultaneous determination of ascorbic acid and glucose in soft drinks with an electrochemical filter/biosensor FIA system. 

A very common heating sensing technique used in condensed matter is photoacoustic (PA) spectroscopy, which is based on detection of the acoustic waves that are generated after a pulse of light is absorbed by a luminescent system. These acoustic waves are produced in the whole solid sample and in the coupling medium adjacent to the sample as a result of the heat delivered by multiphonon relaxation processes. 

Mercury binding leads to an increase of mass of the gold layer which can be detected by electro-acoustic transducers based on quartz microbalance (QMB the abbreviation QCM = quartz crystal microbalance is also widely used), surface acoustic waves (SAW)—devices [20] or microcantilevers [21,22], Adsorption of mercury vapour increases resonance frequency of shear vibrations of piezoelectric quartz crystals (Fig. 12.2). This process can be described by Sauerbrey equation [23]. For typical AT-cut quartz, this equation is... 

A quartz crystal sensor chip was bonded with a microfluidic glass chip for acoustic wave detection (see Figure 7.46). The sensor was operated in the thickness-shear mode (TSM). This has allowed rat heart muscle cell contraction to be studied based on the measurement of the resonant frequency changes [133]. 

Part II of the book deals with lesser known aspects of US for the analytical chemists such as its use as an energy source for detection purposes. Thus, ultrasound-based detection techniques viz. US spectrometry in its various modes including ultrasound attenuation, ultrasonic velocity, resonant ultrasound, laser-generated, ultrasound reflection and acoustic wave impedance spectroscopies) are dealt with in Chapter 9. Finally, Chapter 10 is devoted to seleoted applioations of US spectrometry — mostly non-analytical applications from whioh, however, analytical chemists can derive new, interesting analytical uses for ultrasound-based deteotion techniques. 

Another state-of-the-art detection system contains a surface acoustic wave (SAW) device, which is based on a piezoelectric crystal whose resonant frequency is sensitive to tiny changes in its mass—it can sense a change of 10-1° g/cm2. In one use of this device as a detector it was coated with a thin film of zeolite, a silicate mineral. Zeolite has intricate passages of a very uniform size. Thus it can act as a molecular sieve, allowing only molecules of a certain size to pass through onto the detector, where their accumulation changes the mass and therefore alters the detector frequency. This sensor has been used to detect amounts of methyl alcohol (CH3OH) as low as 10 9 g. 

Biosensors presently being developed for the detection of DNA hybridization are mostly based on optical, surface acoustic wave and electrochemical transducers. The detection of specific DNA sequences, using... 

---