Acetonitrile acidity measurements

Despite the favorable properties of acetonitrile as a solvent, its use for equilibrium acidity measurements has its definite limitations. The pK range that is tolerable is limited at the high end by onset of solvent deprotonation, and at the low end by substrate autodissociation, as has been implicated for HCo(CO)4 [14a] and TpCr(CO)3H [22b]. These limitations can be overcome by the choice of a less polar solvent, e.g. 1,2-dichloroethane (DCE), dichloromethane, or THE. To make reliable, quantitative comparisons of thermodynamic data obtained in different solvents, it is necessary to link the acidity scales and electrode potential references in the different solvents. This has all too often proven to be a far from trivial task. Although, in principle, 1 1 relationship between the acidity scales in different solvents never exists, pK differences between closely related compounds are often almost constant when compared in different solvents. This is because their solvation properties are similar, because of similarities in size and charge distribution. In less... 

Nitrenium ions have been observed following flash photolysis of 4-ethoxy- and 4-methoxyphenyl azides in aqueous solution and a series of polyfluorinated phenyl azides in acidic media, such as acetonitrile containing sulfuric acid. Measured lifetimes of the phenylnitrenium ions varied from 1 ps up to milliseconds. 

Yi D, Zhang H, Deng Z (2010) H and N chemical shifts of adsorbed acetonitrile as measures to probe the Brpnsted acid strength of solid acids a DFT study. J Mol Catal A Chem 326 88-93... 

A sample of the protein, horse heart myoglobin, was dissolved in acidified aqueous acetonitrile (1% formic acid in HjO/CHjCN, 1 1 v/v) at a concentration of 20 pmol/1. This sample was injected into a flow of the same solvent passing at 5 pl/min into the electrospray source to give the mass spectrum of protonated molecular ions [M + nH] shown in (a). The measured ra/z values are given in the table (b), along with the number of protons (charges n) associated with each. The mean relative molecular mass (RMM) is 16,951,09 0.3 Da. Finally, the transformed spectrum, corresponding to the true relative molecular mass, is shown in (c) the observed value is close to that calculated (16,951.4), an error of only 0.002%. 

Valko et al. [37] developed a fast-gradient RP-HPLC method for the determination of a chromatographic hydrophobicity index (CHI). An octadecylsilane (ODS) column and 50 mM aqueous ammonium acetate (pH 7.4) mobile phase with acetonitrile as an organic modifier (0-100%) were used. The system calibration and quality control were performed periodically by measuring retention for 10 standards unionized at pH 7.4. The CHI could then be used as an independent measure of hydrophobicity. In addition, its correlation with linear free-energy parameters explained some molecular descriptors, including H-bond basicity/ acidity and dipolarity/polarizability. It is noted [27] that there are significant differences between CHI values and octanol-water log D values. 

Subsequently 36 strains of aerobic endospore-forming bacteria, consisting of six Bacillus species and one Brevibacillus species could be discriminated using cluster analysis of ESMS spectra acquired in the positive ion mode (m/z 200-2000).57 The analysis was carried out on harvested, washed bacterial cells suspended in aqueous acidic acetonitrile. The cell suspensions were infused directly into the ionization chamber of the mass spectrometer (LCT, Micromass) using a syringe pump. Replicates of the experiment were performed over a period of six months to randomize variations in the measurements due to possible confounding factors such as instrumental drift. Principal components analysis (PCA) was used to reduce the dimensionality of the data, fol-... 

Khashaba et al. [34] suggested the use of sample spectrophotometric and spectrofluorimetric methods for the determination of miconazole and other antifungal drugs in different pharmaceutical formulations. The spectrophotometric method depend on the interaction between imidazole antifungal drugs as -electron donor with the pi-acceptor 2,3-dichloro-5,6-dicyano-l,4-benzoquinone, in methanol or with p-chloranilic acid in acetonitrile. The produced chromogens obey Beer s law at Amax 460 and 520 nm in the concentration range 22.5-200 and 7.9-280 pg/mL for 2,3-dichloro-5,6-dicyano-l,4-benzoquinone and p-chloranilic acid, respectively. Spectrofluorimetric method is based on the measurement of the native fluorescence of ketoconazole at 375 nm with excitation at 288 nm and/or fluorescence intensity versus concentration is linear for ketoconazole at 49.7-800 ng/mL. The methods... 

The solubility of (S) 3,5-dichloro-2-hydroxy-[[2-[[[3-hydroxy-5[l, 4,5,6-tetrahy-dro-5-hydroxypyrimidin-2-yl-amino]phenyl]carbonyl]amino]acetyl]amino]-benzene-propanoic acid and its monohydrate was measured at several temperatures in different aqueous acetonitrile solvent systems [7]. The data were fitted to a frame-... 

The 2 pi of the concentrated peptide solution was mixed with 4 pi of 2,5-dihydroxybenzoic acid [ 7 mg in 500 pi of the mixture of acetonitrile/0.1% trifluoroacetic acid, 1/2 (v/v)]. The resulting mixture was applied to the MALDI steel plate and left to crystallise. Afterwards, the MALDI-TOF mass spectra were measured by a BIFLEX IV instrument (Bruker, Germany) under appropriate conditions (potential 19 kV on the plate and 15.05 kV on the deflector, positive reflector mode potential 20 kV, laser intensity 50 or 60%). The range of detected masses was from 600 to 3000 Da. For the external calibration the standard mixture of peptides M-Pep was used. 

Retention volumes of monosubstituted benzenes, benzoic acid, phenols, and anilines have been measured in RPLC [76]. Buffered acetonitrile/water and tetrahydrofuran/water eluents were used with an octadecylsilica adsorbent. From the net retention volumes, a substituent interaction effect was calculated and described with the linear free energy relationship developed by Taft. The data was interpreted in terms of hydrogen bonding between the solutes and the eluent. 

Hydrogen bond donor solvents are simply those containing a hydrogen atom bound to an electronegative atom. These are often referred to as protic solvents, and the class includes water, carboxylic acids, alcohols and amines. For chemical reactions that involve the use of easily hydrolysed or solvolysed compounds, such as AICI3, it is important to avoid protic solvents. Hydrogen bond acceptors are solvents that have a lone pair available for donation, and include acetonitrile, pyridine and acetone. Kamlet-Taft a and ft parameters are solvatochromic measurements of the HBD and HBA properties of solvents, i.e. acidity and basicity, respectively [24], These measurements use the solvatochromic probe molecules V, V-die lliy I -4-n i in tan iline, which acts as a HBA, and 4-nitroaniline, which is a HBA and a HBD (Figure 1.17). 

Several compounds have been proposed for the measurement of the void volume, including sodium nitrate solution, water, deuterium oxide, fructose, acetonitrile, tetrahydrofuran (THF), meso-erythritol, gluconolactone, and 2,4-dinitronaphthol. The elution volume of a number of these compounds has been measured in 10-90% aqueous acetonitrile and acidic-aqueous acetonitrile. The results are given in Figure 3.9 where the volumes in A and B were measured in aqueous acetonitrile and in C and D were measured in aqueous acetonitrile containing 50 mM phosphoric acid. Methanol (a) and deuterium oxide (g) showed two peaks when monitored by a refractive index detector (Figure 3.9C). 

Figure 6.2 Comparison of measured and predicted retention factors of aromatic acids from Rekker s log P values. Column, 10 fim polystyrene gel, Hitachi 3011, 15 cm x 4.6 mm i.d. eluent, 30% aqueous acetonitrile containing 50 mM phosphoric acid at 55 °C. Numbers beside symbols see Table 6.4.

---