Acetic anhydride, production mechanism

Homogeneous catalysts. With a homogeneous catalyst, the reaction proceeds entirely in the vapor or liquid phase. The catalyst may modify the reaction mechanism by participation in the reaction but is regenerated in a subsequent step. The catalyst is then free to promote further reaction. An example of such a homogeneous catalytic reaction is the production of acetic anhydride. In the first stage of the process, acetic acid is pyrolyzed to ketene in the gas phase at TOO C ... 

Equip a I litre three-necked flask with a mechanical stirrer and a thermometer, and immerse the flask in a bath of ice and salt. Place 306 g. (283 ml.) of acetic anhydride, 300 g. (285 ml.) of glacial acetic acid and 25 g. of p-nitrotoluene in the flask, and add slowly, with stirring, 42 5 ml. of concentrated sulphuric acid. When the temperature has fallen to 5°, introduce 50 g. of A.R. chromic anhydride in small portions at such a rate that the temperature does not rise above 10° continue the stirring for 10 minutes after all the chromium trioxide has been added. Pour the contents of the flask into a 3 litre beaker two-thirds filled with crushed ice and almost fill the beaker with cold water. Filter the solid at the pump and wash it with cold water until the washings are colourless. Suspend the product in 250 ml. of cold 2 per cent, sodium carbonate solution and stir mechanically for 10-15 minutes filter (1), wash with cold water, and finally with 10 ml. of alcohol. Dry in a vacuum desiccator the yield of crude p-nitrobenzal diacetate is 26 g. (2),... 

Because of the chemical similarity between benzoyl nitrate and the acetyl nitrate which is formed in solutions of nitric acid in acetic anhydride, it is tempting to draw analogies between the mechanisms of nitration in such solutions and in solutions of benzoyl nitrate in carbon tetrachloride. Similarities do exist, such as the production by these reagents of higher proportions of o-substituted products from some substrates than are produced by nitronium ions, as already mentioned and further discussed below. Further, in solutions in carbon tetrachloride of acetyl nitrate or benzoyl nitrate, the addition of acetic anhydride and benzoic anhydride respectively reduces the rate of reaction, implying that dinitrogen pentoxide may also be involved in nitration in acetic anhydride. However, for solutions in which acetic anhydride is also the solvent, the analogy should be drawn with caution, for in many ways the conditions are not comparable. Thus, carbon tetrachloride is a non-polar solvent, in which, as has been shown above,... 

Scheme 6 depicts a typical penicillin sulfoxide rearrangement (69JA1401). The mechanism probably involves an initial thermal formation of a sulfenic acid which is trapped by the acetic anhydride as the mixed sulfenic-acetic anhydride. Nucleophilic attack by the double bond on the sulfur leads to an episulfonium ion which, depending on the site of acetate attack, can afford either the penam (19) or the cepham (20). Product ratios are dependent on reaction conditions. For example, in another related study acetic anhydride gave predominantly the penam product, while chloroacetic anhydride gave the cepham product (7lJCS(O3540). The rearrangement can also be effected by acid in this case the principal products are the cepham (21) and the cephem (22 Scheme 7). Since these early studies a wide variety of reagents have been found to catalyze the conversion of a penicillin sulfoxide to the cepham/cephem ring system (e.g. 77JOC2887).

In 1970, it was disclosed that it is possible to achieve the conversion of dimethylformamide cyclic acetals, prepared in one step from vicinal diols, into alkenes through thermolysis in the presence of acetic anhydride." In the context of 31, this two-step process performs admirably and furnishes the desired trans alkene 33 in an overall yield of 40 % from 29. In the event, when diol 31 is heated in the presence of V, V-dimethylforrnamide dimethyl acetal, cyclic dimethylformamide acetal 32 forms. When this substance is heated further in the presence of acetic anhydride, an elimination reaction takes place to give trans olefin 33. Although the mechanism for the elimination step was not established, it was demonstrated in the original report that acetic acid, yV, V-dimethylacetamide, and carbon dioxide are produced in addition to the alkene product."... 

B. 2-Acetyl-6,l-dimethoxy-l-methylene-l,2,3,4-tetrahydroisoquinoline [Isoquinoline, 2-acetyl-l,2, A,4-tetrahydro-6,7-dimethoxy-l-methylene-]. A 1-1., three-necked, round-bottomed flask equipped with a mechanical stirrer, a reflux condenser topped with a calcium chloride drying tube, and a thermometer is charged with 110 ml. of acetic anhydride, 110 ml. of pyridine, and 45.0 g. (0.22 mole) of the dihydroisoquinoline prepared in Part A. The reaction mixture is stirred and heated at 90-95° for 30 minutes, stored at room temperature overnight, and concentrated by distillation at 50° using a rotary evaporator. The residue is diluted with 20 ml. of ethyl acetate, and another evaporation under reduced pressure gives material that can be crystallized from 75 ml. of ethyl acetate to yield 38.5 41.0 g. (72-77%) of product, m.p. 106-107° (Note 11). 

The Pummerer reaction346 of conformationally rigid 4-aryl-substituted thiane oxides with acetic anhydride was either stereoselective or stereospecific, and the rearrangement is mainly intermolecular, while the rate-determining step appears to be the E2 1,2-elimination of acetic acid from the acetoxysulfonium intermediates formed in the initial acetylation of the sulfoxide. The thermodynamically controlled product is the axial acetoxy isomer, while the kinetically controlled product is the equatorial isomer that is preferentially formed due to the facile access of the acetate to the equatorial position347. The overall mechanism is illustrated in equation 129. 

Ion 21 can either lose a proton or combine with chloride ion. If it loses a proton, the product is an unsaturated ketone the mechanism is similar to the tetrahedral mechanism of Chapter 10, but with the charges reversed. If it combines with chloride, the product is a 3-halo ketone, which can be isolated, so that the result is addition to the double bond (see 15-45). On the other hand, the p-halo ketone may, under the conditions of the reaction, lose HCl to give the unsaturated ketone, this time by an addition-elimination mechanism. In the case of unsymmetrical alkenes, the attacking ion prefers the position at which there are more hydrogens, following Markovnikov s rule (p. 984). Anhydrides and carboxylic acids (the latter with a proton acid such as anhydrous HF, H2SO4, or polyphosphoric acid as a catalyst) are sometimes used instead of acyl halides. With some substrates and catalysts double-bond migrations are occasionally encountered so that, for example, when 1 -methylcyclohexene was acylated with acetic anhydride and zinc chloride, the major product was 6-acetyl-1-methylcyclohexene. ... 

In acetic acid, or aqueous acetone with subsequent treatment with acetic anhydride, the esters (196 R=4-Me0 or 4-MeS) give rise to the expected esters(197) or (198). For the 4-chlorophenyl derivative, a mixture of the unexpected products (199, 200 Ar=4-chlorophenyl) was obtained. The unsubstituted compound (196 R=H) gave only (199) in aqueous acetone, but (200) in acetic acid. The postulated mechanism tor such a rearrangement centres around pseudophosphonium and-or phosphorane... 

Among the wide variety of organic reactions in which zeolites have been employed as catalysts, may be emphasized the transformations of aromatic hydrocarbons of importance in petrochemistry, and in the synthesis of intermediates for pharmaceutical or fragrance products.5 In particular, Friede 1-Crafts acylation and alkylation over zeolites have been widely used for the synthesis of fine chemicals.6 Insights into the mechanism of aromatic acylation over zeolites have been disclosed.7 The production of ethylbenzene from benzene and ethylene, catalyzed by HZSM-5 zeolite and developed by the Mobil-Badger Company, was the first commercialized industrial process for aromatic alkylation over zeolites.8 Other typical examples of zeolite-mediated Friedel-Crafts reactions are the regioselective formation of p-xylene by alkylation of toluene with methanol over HZSM-5,9 or the regioselective p-acylation of toluene with acetic anhydride over HBEA zeolites.10 In both transformations, the p-isomers are obtained in nearly quantitative yield. 

Nucleophilic attack at sulfur is implicated in many reactions of 1,2,4-thiadiazoles <84CHEC-I(6)463> and in general soft nucleophiles attack at sulfur. For example, reaction of 3-hydroxy-5-phenyl-1,2,4-thiadiazole (23) with acetic anhydride in the presence of dbu at 130°C gives the thiazoles (31) and (32) <85JHC1497>. These products may be reasonably explained by the mechanism outlined in Scheme 9 in which the thiadiazole ring is opened by the acetic anhydride carbanion. There is some evidence that (32) may arise from attack of the carbanion on the A-acylated derivative (30a) (Scheme 9) <85JHC1497>. 

Any mechanistic scheme must account for this concurrent production of acetaldehyde and acetic anhydride. A possible mechanism for EDA formation is described in general terms by Scheme II for palladium. 

An alternative scheme to simultaneous formation of acetaldehyde and acetic anhydride could entail the carbonylation of methyl acetate to acetic anhydride which is subsequently reduced to acetaldehyde and acetic acid. The reaction of acetaldehyde with excess anhydride would form EDA. In fact, Fenton has described production of EDA by the reduction of acetic anhydride using both rhodium and palladium salts as catalysts when modified with triphenylphosphine (26). Two possible mechanisms for the reduction are postulated in equation 16. 

---