Mass spectrometry acetates

A liquid chromatography-mass spectrometry (LC-MS) method that can quantitatively analyze urinar y normal and modified nucleosides in less than 30 min with a good resolution and sufficient sensitivity has been developed. Nineteen kinds of normal and modified nucleosides were determined in urine samples from 10 healthy persons and 18 breast cancer patients. Compounds were separ ated on a reverse phase Kromasil C18 column (2.1 mm I.D.) by isocratic elution mode using 20 mg/1 ammonium acetate - acetonitrile (97 3 % v/v) at 200 p.l/min. A higher sensitivity was obtained in positive atmospheric pressure chemical ionization mode APCI(-i-). 

DNA sequencing and. 1113 Electrospray ionization (ESI) mass spectrometry, 417-418 Electrostatic potential map, 37 acetaldehyde, 688 acetamide, 791,922 acetate ion. 43. 53, 56, 757 acetic acid. 53. 55 acetic acid dimer, 755 acetic anhydride, 791 acetone, 55, 56. 78 acetone anion, 56 acetyl azide, 830 acetyl chloride, 791 acetylene. 262 acetylide anion, 271 acid anhydride, 791 acid chloride, 791 acyl cation, 558 adenine, 1104 alanine, 1017 alanine zwitterion, 1017 alcohol. 75 alkene, 74, 147 alkyl halide, 75 alkyne. 74... 

The luciferin produces a blue oxidation product during its purification process. In the DEAE chromatography of luciferin, this blue compound is eluted before the fractions of luciferin. The fractions of the blue compound were combined and purified by HPLC on a column of Hamilton PRP-1 (7 x 300 mm) using methanol-water (8 2) containing 0.1% ammonium acetate. The purified blue compound showed absorption peaks at 234, 254, 315, 370, 410, 590 (shoulder) and 633 nm. High-resolution FAB mass spectrometry of this compound indicated a molecular formula of C l C Nai m/z 609.2672 (M - Na + 2H)+, and mlz 631.2524 (M + H)+]. These data, together with the HNMR spectral data, indicated the structure of the blue compound to be 8. 

Properties of panal (Nakamura etal., 1988a). Purified panal is a colorless, amorphous solid, soluble in alcohols, water, ethyl acetate, and chloroform. The absorption spectrum (Fig. 9.3) shows a single peak (A.max 217nm, e 15,300). Optical rotation [a]D —17° (c 0.9, methanol). Mass spectrometry and NMR analysis showed that panal is a sesquiterpene aldehyde, C15H18O5 (Mr 278.30), with the structure shown below. 

Both PS-A and PS-B have a tendency to hydrate like panal, and they also form adducts with methylamine. The adducts, PS-A/MA and PS-B/MA, are prepared by incubating PS-A or PS-B in 75 % methanol containing an excess amount of methylamine hydrochloride plus some sodium acetate to neutralize the HC1, at 45°C for 30 min. The adducts can be purified by HPLC on a PRP-1 column (80% acetonitrile containing 0.05% acetic acid). Their chemical structures have been determined by NMR and mass spectrometry as shown in Fig. 9.8 (p. 288). Both adducts are colorless and show an absorption maximum at 218 nm. 

ESI mass spectrometry ive mass spectrometry ESR spectroscopy set EPR spectroscopy ethyl acetate, chain transfer to 295 ethyl acrylate (EA) polymerizalion, transfer constants, to macromonomers 307 ethyl methacrylate (EMA) polymerization combination v.v disproportionation 255, 262 kinetic parameters 219 tacticity, solvent effects 428 thermodynamics 215 ethyl radicals... 

Identification of a characteristic set of isomers with differently branched nonyl substitutions of poorly biodegradable nonylphenoxyacetic acid and nonylphen-oxyethoxy acetic acid in sewage effluents was identified with high-resolution gas chromatography/mass spectrometry (HRGS-MS) and quantitative determination was done with HPLC [245]. 

Reference has been made to the problems associated with the presence of highly involatile analytes. Many buffers used in HPLC are inorganic and thus involatile and these tend to compromise the use of the interface, in particular with respect to snagging of the belt in the tunnel seals. The problem of inorganic buffers is not one confined to the moving-belt interface and, unless post-column extraction is to be used, those developing HPLC methods for use with mass spectrometry are advised to utilize relatively volatile buffers, such as ammonium acetate, if at all possible. 

Dichlorodibenzo- -dioxin. 2-Bromo-4-chlorophenol (31 grams, 0.15 mole) and solid potassium hydroxide (8.4 grams, 0.13 mole) were dissolved in methanol and evaporated to dryness under reduced pressure. The residue was mixed with 50 ml of bEEE, 0.5 ml of ethylene diacetate, and 200 mg of copper catalyst. The turbid mixture was stirred and heated at 200°C for 15 hours. Cooling produced a thick slurry which was transferred into the 500-ml reservoir of a liquid chromatographic column (1.5 X 25 cm) packed with acetate ion exchange resin (Bio-Rad, AG1-X2, 200-400 mesh). The product was eluted from the column with 3 liters of chloroform. After evaporation, the residue was heated at 170°C/2 mm for 14 hours in a 300-cc Nestor-Faust sublimer. The identity of the sublimed product (14 grams, 74% yield) was confirmed by mass spectrometry and x-ray diffraction. Product purity was estimated at 99- -% by GLC (electron capture detector). 

To identify the volatile components, gas chromatography-mass spectrometry (GC-MS) is still the method of choice. A comparison of the GC fingerprints of B. carter a and B. serrata reveals the different composition of the volatile fractions (Figure 16.1). Common monoterpenes, aliphatic, and aromatic compounds of olibanum are, e g., pinene, limonene, 1,8-cineole, bomyl acetate, and methyleugenol (Figure 16.2). 

---