Amines absorption

The casein concentration of diets fed rats does not affect iron absorption (Amine and Hegsted, 1971, Carmichael et al., 1975) however, effect of protein source was not studied by these authors. Thus, the sources of carbohydrate and fat can markedly affect the utilization of dietary iron and should be considered as important variables in bioavailability experiments. The amount of protein, however, does not seem as critical. 

II This dual tilling permits the absorption of both acid smd basic vapours which may be evolved. Thus an amine hydrochloride, which has been recrystallised from concentrated hydrochloric acid, may be readily dried in such a desiccator. If concentrated sulphuric acid alone were used, so much hydrogen chloride would be liberated that tlie pressure inside the desiccator would rise considerably, smd the rate of drying would be reduced. With sodium hydroxide present, however, the hydrogen chloride is removed, smd tho water is absorbed in the normal manner by the reagents but largely by the acid. 

Unfortunately, addition of copper(II)nitrate to a solution of 4.42 in water did not result in the formation of a significant amount of complex, judging from the unchanged UV-vis absorption spectrum. Also after addition of Yb(OTf)3 or Eu(N03)3 no indications for coordination were observed. Apparently, formation of a six-membered chelate ring containing an amine and a ketone functionality is not feasible for these metal ions. Note that 4.13 features a similar arrangement and in aqueous solutions, likewise, does not coordinate significantly to all the Lewis acids that have been... 

The desired pyridylamine was obtained in 69 % overall yield by monomethylation of 2-(aminomethyl)pyridine following a literature procedure (Scheme 4.14). First amine 4.48 was converted into formamide 4.49, through reaction with the in situ prepared mixed anhydride of acetic acid and formic acid. Reduction of 4.49 with borane dimethyl sulfide complex produced diamine 4.50. This compound could be used successfully in the Mannich reaction with 4.39, affording crude 4.51 in 92 % yield (Scheme 4.15). Analogous to 4.44, 4.51 also coordinates to copper(II) in water, as indicated by a shift of the UV-absorption maximum from 296 nm to 308 nm. 

Infrared The absorptions of interest m the IR spectra of amines are those associated with N—H vibrations Primary alkyl and arylammes exhibit two peaks m the range 3000-3500 cm which are due to symmetric and antisymmetric N—H stretching modes... 

Solvents used for hydrogen sulfide absorption include aqueous solutions of ethanolamine (monoethano1 amine, MEA), diethanolamine (DEA), and diisopropanolarnine (DIPA) among others ... 

A second type of uv curing chemistry is used, employing cationic curing as opposed to free-radical polymerization. This technology uses vinyl ethers and epoxy resins for the oligomers, reactive resins, and monomers. The initiators form Lewis acids upon absorption of the uv energy and the acid causes cationic polymerization. Although this chemistry has improved adhesion and flexibility and offers lower viscosity compared to the typical acrylate system, the cationic chemistry is very sensitive to humidity conditions and amine contamination. Both chemistries are used commercially. 

Health and Safety Factors. Animal-feeding studies of DMPPO itself have shown it to be nontoxic on ingestion. The solvents, catalyst, and monomers that are used to prepare the polymers, however, should be handled with caution. Eor example, for the preparation of DMPPO, the amines used as part of the catalyst are flammable toxic on ingestion, absorption, and inhalation and are also severe skin and respiratory irritants (see Amines). Toluene, a solvent for DMPPO, is not a highly toxic material in inhalation testing the TLV (71) is set at 375 mg/m, and the lowest toxic concentration is reported to be 100—200 ppm (72). Toxicity of 2,6-dimethylphenol is typical of alkylphenols (qv), eg, for mice, the acute dermal toxicity is LD q, 4000 mg/kg, whereas the acute oral toxicity is LD q, 980 mg/kg (73). The Noryl blends of DMPPO and polystyrene have PDA approval for reuse food apphcations. 

Monoethan olamine and monoisopropan olamine may be moderately toxic by absorption through the skin. The other amines are low in toxicity by this route and are not likely to be absorbed in acutely toxic amounts. In the event of skin contact, clothing and shoes should be removed promptly, and the skin thoroughly washed with water. Contaminated clothing should be thoroughly cleaned before reuse shoes and leather products should be discarded. 

The N—O bond distances, found to be 0.133 to 0.139 nm for trimethyl amine oxide (1), are somewhat shorter than the single N—C bond distance of 0.147 nm ia methylamine. The N—C bond distance of 0.154 nm ia trimethyl amine oxide approaches that of the C—C bond. This is ia agreement with the respective absorptions ia the iafrared region valence vibrations of N—O bonds of aUphatic amine oxides are found between 970 920 cm (2). 

A number of processes have been developed using hot potassium carbonate plus an activator. The activator, which may be DEA, boric acid, or a hindered amine, serves to accelerate the rate of absorption, thus reducing absorber and regenerator sizes. Catacarb, Benefield, and Flexsorb HP are examples of proprietary processes of this type. 

SolubiHty of carbon dioxide in ethanolamines is affected by temperature, amine solution strength, and carbon dioxide partial pressure. Information on the performance of amines is available in the Hterature and from amine manufacturers. Values for the solubiHty of carbon dioxide and hydrogen sulfide mixtures in monoethanolamine and for the solubiHty of carbon dioxide in diethanolamine are given (36,37). SolubiHty of carbon dioxide in monoethanolamine is provided (38). The effects of catalysts have been studied to improve the activity of amines and provide absorption data for carbon dioxide in both mono- and diethanolamine solutions with and without sodium arsenite as a catalyst (39). Absorption kinetics over a range of contact times for carbon dioxide in monoethanolamine have also been investigated (40). 

The exterior durabiHty of relatively stable coatings can be enhanced by use of additives. Ultraviolet absorbers reduce the absorption of uv by the resins and hence decrease the rate of photodegradation. Eurther improvements can be gained by also adding free-radical trap antioxidants (qv) such as hindered phenols and especially hindered amine light stabilizers (HALS). A discussion of various types of additives is available (113). 

---