Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Vibrational spontaneous

Splitting (, ee Degemuate vibrations) Spontaneous transition coeflieicnt, 38 S([uare matrix, 299 Staggered model of ethane, 84 Stokes Raman lines, 3, 9, 48, 51 Stretching force constants, numerical values, J 75... [Pg.199]

The first mfonnation on the HE vibrational distribution was obtained in two landmark studies by Pimentel [39] and Polanyi [24] in 1969 both studies showed extensive vibrational excitation of the HE product. Pimental found that tire F + H2 reaction could pump an infrared chemical laser, i.e. the vibrational distribution was inverted, with the HF(u = 2) population higher than that for the HF(u = 1) level. A more complete picture was obtained by Polanyi by measuring and spectrally analysing tlie spontaneous emission from vibrationally excited HE produced by the reaction. This infrared chemiluminescence experiment yielded relative populations of 0.29, 1 and 0.47 for the HF(u =1,2 and 3)... [Pg.876]

Conventional spontaneous Raman scattering is the oldest and most widely used of the Raman based spectroscopic methods. It has served as a standard teclmique for the study of molecular vibrational and rotational levels in gases, and for both intra- and inter-molecular excitations in liquids and solids. (For example, a high resolution study of the vibrons and phonons at low temperatures in crystalline benzene has just appeared [38].)... [Pg.1197]

Raman scattering and (b) anti-Stokes Raman scattering. In Stokes scattering, tlie cluomophore is initially in the ground vibrational state, g, and oi > CO2. hr spontaneous anti-Stokes scattering, the cluomophore must be initially m an excited vibrational state,/ Also note that in (b), M2 is (arbitrarily) defined as being greater than... [Pg.1198]

For many reaction products and for the detection of molecules in their ground vibrational level, some laser-based spectroscopic method must be employed, rather than observation of spontaneous emission. The simplest spectroscopic method for detemiining concentrations of specified product internal states would involve the... [Pg.2060]

Diatomic molecules have only one vibrational mode, but VER mechanisms are paradoxically quite complex (see examples C3.5.6.1 and C3.5.6.2). Consequently there is an enonnous variability in VER lifetimes, which may range from 56 s (liquid N2 [18]) to 1 ps (e.g. XeF in Ar [25]), and a high level of sensitivity to environment. A remarkable feature of simpler systems is spontaneous concentration and localization of vibrational energy due to anhannonicity. Collisional up-pumping processes such as... [Pg.3034]

According to Eq. (11), the force constant for the normal vibration Q, can be identified with the term in braces and can be negative if the second term, which is positive, exceeds the first term. If the force constant is negative, the energy should be lowered by the nuclear deformation Qi, and the second-order distortion from the symmetrical nuclear arrangement would occur spontaneously. [Pg.9]

Table 4, Molecular spontaneous vibrational/rovibrational liferimes, Ty (s)... Table 4, Molecular spontaneous vibrational/rovibrational liferimes, Ty (s)...
A spontaneous Raman spectra is shown in Figure 2.8d in which the on- and off-resonant frequencies are indicated. The DNA bundles are observed at the resonant frequency, as shown in Figure 2.8a, while they cannot be seen at the off-resonant frequency in Figure 2.8b. This indicates that the observed contrast is dominated by the vibrationally resonant CARS signals. Figure 2.8c shows a cross-section of Figure 2.8a denoted by two solid arrows, which were acquired with a 5 nm step. The FWHM of... [Pg.29]

The wavenumbers of the observed bands are identical with those of the spontaneous Raman spectrum of the solution and oxazine solid [27]. The impulsive stimulated Raman transition may initiate coherent vibrations in the electronic excited state. However, there was no sign of the excited-state vibrations superimposed on the ground-state bands in the spectrum of Figure 6.3. [Pg.108]

Raman spectroscopy is primarily useful as a diagnostic, inasmuch as the vibrational Raman spectrum is directly related to molecular structure and bonding. The major development since 1965 in spontaneous, c.w. Raman spectroscopy has been the observation and exploitation by chemists of the resonance Raman effect. This advance, pioneered in chemical applications by Long and Loehr (15a) and by Spiro and Strekas (15b), overcomes the inherently feeble nature of normal (nonresonant) Raman scattering and allows observation of Raman spectra of dilute chemical systems. Because the observation of the resonance effect requires selection of a laser wavelength at or near an electronic transition of the sample, developments in resonance Raman spectroscopy have closely paralleled the increasing availability of widely tunable and line-selectable lasers. [Pg.466]


See other pages where Vibrational spontaneous is mentioned: [Pg.344]    [Pg.344]    [Pg.248]    [Pg.256]    [Pg.873]    [Pg.1203]    [Pg.1211]    [Pg.1214]    [Pg.2060]    [Pg.2085]    [Pg.2447]    [Pg.2475]    [Pg.3034]    [Pg.134]    [Pg.361]    [Pg.318]    [Pg.133]    [Pg.281]    [Pg.1029]    [Pg.164]    [Pg.387]    [Pg.802]    [Pg.176]    [Pg.325]    [Pg.109]    [Pg.76]    [Pg.209]    [Pg.132]    [Pg.1147]    [Pg.1719]    [Pg.112]    [Pg.190]    [Pg.25]    [Pg.151]    [Pg.83]    [Pg.118]    [Pg.73]    [Pg.174]    [Pg.48]    [Pg.401]   
See also in sourсe #XX -- [ Pg.259 ]




SEARCH



Spontaneous Raman scattering vibrational

© 2024 chempedia.info