Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Van der Waals force, measurements

In accordance with equation (Bl.20.1). one can plot the so-called surface force parameter, P = F(D) / 2 i R, versus D. This allows comparison of different direct force measurements in temis of intemiolecular potentials fV(D), i.e. independent of a particular contact geometry. Figure B 1.20.2 shows an example of the attractive van der Waals force measured between two curved mica surfaces of radius i 10 nun. [Pg.1732]

For measurements between crossed mica cylinders coated with phospholipid bilayers in water, see J. Marra andj. Israelachvili, "Direct measurements of forces between phosphatidylcholine and phosphatidylethanolamine bilayers in aqueous electrolyte solutions," Biochemistry, 24, 4608-18 (1985). Interpretation in terms of expressions for layered structures and the connection to direct measurements between bilayers in water is given in V. A. Parsegian, "Reconciliation of van der Waals force measurements between phosphatidylcholine bilayers in water and between bilayer-coated mica surfaces," Langmuir, 9, 3625-8 (1993). The bilayer-bilayer interactions are reported in E. A. Evans and M. Metcalfe, "Free energy potential for aggregation of giant, neutral lipid bilayer vesicles by van der Waals attraction," Biophys. J., 46, 423-6 (1984). [Pg.351]

V. A. Parsegian, "Reconciliation of van der Waals force measurements between phosphatidylcholine bilayer in water and between bilayer-coated mica surfaces," Langmuir, 9, 3625-8 (1993). [Pg.353]

Much of chemistry is concerned with the short-range wave-mechanical force responsible for the chemical bond. Our emphasis here is on the less chemically specific attractions, often called van der Waals forces, that cause condensation of a vapor to a liquid. An important component of such forces is the dispersion force, another wave-mechanical force acting between both polar and nonpolar materials. Recent developments in this area include the ability to measure... [Pg.225]

Mutter J L and Bechhoefer J 1994 Measurement and manipulation of van der Waals forces in atomic-force microscopy J. Vac. Sc/. Technol. B 12 2251... [Pg.1724]

Tabor D and Winterton R H S 1969 The direct measurement of normal and retarded van der Waals forces Proc. R. Soc. London A 312 435-50... [Pg.1746]

These forces are electrical m nature and m order to vaporize a substance enough energy must be added to overcome them Most alkanes have no measurable dipole moment and therefore the only van der Waals force to be considered is the induced dipole/mduced dipole attractive force... [Pg.81]

The well-known DLVO theory of coUoid stabiUty (10) attributes the state of flocculation to the balance between the van der Waals attractive forces and the repulsive electric double-layer forces at the Hquid—soHd interface. The potential at the double layer, called the zeta potential, is measured indirectly by electrophoretic mobiUty or streaming potential. The bridging flocculation by which polymer molecules are adsorbed on more than one particle results from charge effects, van der Waals forces, or hydrogen bonding (see Colloids). [Pg.318]

Pigglomerates are undispersed clusters of aggregates held together by van der Waals forces or by biaders. The term stmcture is used to describe both the extent and the complexity with which the particles are iatercoimected ia aggregates. Primary measures of stmcture focus on the internal space within the aggregate. [Pg.541]

All this being said, perhaps the most definitive study of the relative roles of electrostatic and van der Waals forces was performed by Gady et al. [86,101,102]. In their studies, they attached a spherical polystyrene particle, having a radius between 3 and 6 p.m, to the cantilever of an atomic force microscope. They then conducted three distinct measurements that allowed them to distinguish between electrostatic and van der Waals forces that attracted the particle to various conducting, smooth substrates. [Pg.176]

Gady found that, depending on the charge of the particle, van der Waals forces dominated over the forces associated with electrostatically charged patches when the particle-to-substrate separation was between 3 and 10 nm, depending on the particle charge. In addition, he found that the distance at which the snap-together occurred required that van der Waals forces dominate over electrostatic. In all his measurements, however, a component of the total attractive force, even at close separations, was observed to be electrostatic in nature. [Pg.177]

All the elements have stable electronic configurations (Is or ns np ) and, under normal circumstances are colourless, odourless and tasteless monatomic gases. The non-polar, spherical nature of the atoms which this implies, leads to physical properties which vary regularly with atomic number. The only interatomic interactions are weak van der Waals forces. These increase in magnitude as the polarizabilities of the atoms increase and the ionization energies decrease, the effect of both factors therefore being to increase the interactions as the sizes of the atoms increase. This is shown most directly by the enthalpy of vaporization, which is a measure of the energy required to overcome the... [Pg.891]

Refinements in the theory of interparticle long-range van der Waals forces (the Landau-Lifshitz theory) are within reach. New techniques are now available for measuring the complex dielectric constants of various media required for the implementation of that theory. [Pg.178]

The surface force apparatus (SFA) is a device that detects the variations of normal and tangential forces resulting from the molecule interactions, as a function of normal distance between two curved surfaces in relative motion. SFA has been successfully used over the past years for investigating various surface phenomena, such as adhesion, rheology of confined liquid and polymers, colloid stability, and boundary friction. The first SFA was invented in 1969 by Tabor and Winterton [23] and was further developed in 1972 by Israela-chivili and Tabor [24]. The device was employed for direct measurement of the van der Waals forces in the air or vacuum between molecularly smooth mica surfaces in the distance range of 1.5-130 nm. The results confirmed the prediction of the Lifshitz theory on van der Waals interactions down to the separations as small as 1.5 nm. [Pg.14]


See other pages where Van der Waals force, measurements is mentioned: [Pg.61]    [Pg.373]    [Pg.61]    [Pg.373]    [Pg.1]    [Pg.237]    [Pg.242]    [Pg.591]    [Pg.1692]    [Pg.1724]    [Pg.273]    [Pg.274]    [Pg.147]    [Pg.15]    [Pg.220]    [Pg.224]    [Pg.401]    [Pg.530]    [Pg.162]    [Pg.172]    [Pg.175]    [Pg.177]    [Pg.67]    [Pg.482]    [Pg.5]    [Pg.14]    [Pg.33]    [Pg.34]    [Pg.37]    [Pg.80]    [Pg.34]    [Pg.37]    [Pg.55]    [Pg.27]    [Pg.120]   
See also in sourсe #XX -- [ Pg.242 ]




SEARCH



Force measurement

Measurement of Van der Waals Forces

Van der Waal forces

Van der Waals forces

Van forces

© 2024 chempedia.info