Uranium nuclear power from

This paper is concerned primarily with the application of chemistry to the control of radioactive waste products from the use of nuclear energy. As far as immediate effects are concerned, nuclear power from uranium is a particularly clean energy source (1). The radioactive waste prpducts are well contained within the used fuel bundles. Since some constituents of the radioactive wastes take almost a thousand years to decay to an innocuous level and a few persist for many millennia, e.g. we have to ensure... 

The metal is a source of nuclear power. There is probably more energy available for use from thorium in the minerals of the earth s crust than from both uranium and fossil fuels. Any sizable demand from thorium as a nuclear fuel is still several years in the future. Work has been done in developing thorium cycle converter-reactor systems. Several prototypes, including the HTGR (high-temperature gas-cooled reactor) and MSRE (molten salt converter reactor experiment), have operated. While the HTGR reactors are efficient, they are not expected to become important commercially for many years because of certain operating difficulties. 

Krypton and Xenon from Huclear Power Plants. Both xenon and krypton are products of the fission of uranium and plutonium. These gases are present in the spent fuel rods from nuclear power plants in the ratio 1 Kr 4 Xe. Recovered krypton contains ca 6% of the radioactive isotope Kr-85, with a 10.7 year half-life, but all radioactive xenon isotopes have short half-Hves. 

Lightwater reactors, the primary type of nuclear power reactor operated throughout the world, are fueled with uranium dioxide [1344-57-6] UO2 miched from the naturally occurring concentration of 0.71% uranium-235 [15117-96-17, to approximately 3% (1). As of this writing all civiUan nuclear... 

Spent fuel can be stored or disposed of intact, in a once-through mode of operation, practiced by the U.S. commercial nuclear power industry. Alternatively, spent fuel can be reprocessed, ie, treated to separate the uranium, plutonium, and fission products, for re-use of the fuels (see Nuclear REACTORS, CHEMICAL reprocessing). In the United States reprocessing is carried out only for fuel from naval reactors. In the nuclear programs of some other countries, especially France and Japan, reprocessing is routine. 

Natural gas is the fuel of choice wherever it is available because of its clean burning and its competitive pricing as seen in Figure 1-30. Prices for Uranium, the fuel of nuclear power stations, and coal, the fuel of the steam power plants, have been stable over the years and have been the lowest. Environmental, safety concerns, high initial cost, and the long time from planning to production has hurt the nuclear and steam power industries. Whenever oil or natural gas is the fuel of choice, gas turbines and combined cycle plants are the power plant of choice as they convert the fuel into electricity very... 

Uranium is used as the primai-y source of nuclear energy in a nuclear reactor, although one-third to one-half of the power will be produced from plutonium before the power plant is refueled. Plutonium is created during the uranium fission cycle, and after being created will also fission, contributing heat to make steam in the nuclear power plant. These two nuclear fuels are discussed separately in order to explore their similarities and differences. Mixed oxide fuel, a combination of uranium and recovered plutonium, also has limited application in nuclear fuel, and will be briefly discussed. 

Nuclear power is now the only substantial use for uranium. But before uranium can be used in a nuclear reactor, it must undergo several processes. After uranium is mined from geological mineral deposits, it is purified and converted into uranium hexafluoride (UF,). The UF, is next enriched, increasing the concentration of U-235 by separating out UF,5 made with U-238 atoms. The enriched UF, is then converted into uranium dioxide (UO,), and pressed into fuel pellets for use in the nuclear reactor. 

Plutonium-239 is a fissile element, and vvill split into fragments when struck by a neutron in the nuclear reactor. This makes Pu-239 similar to U-235, able to produce heat and sustain a controlled nuclear reaction inside the nuclear reactor. Nuclear power plants derive over one-third of their power output from the fission of Pu-239. Most of the uranium inside nuclear fuel is U-238. Only a small fraction is the fissile U-235. Over the life cycle of the nuclear fuel, the U-238 changes into Pu-239, which continues to provide nuclear energy to generate electricity. 

One of the many problems of nuclear power is the availability of fuel uranium-235 reserves are only about 0.7% those of the nonfissile uranium-238, and the separation of the isotopes is costly (Section 17.12). One solution is to synthesize fissile nuclides from other elements. In a breeder reactor, a reactor that is used to create nuclear fuel, the neutrons are not moderated. Their high speeds result in... 

The political problems with profound economic impact could include, for example, the significance of the continuing worldwide growth of nuclear power, with such issues as the use of Highly Enriched Uranium (HEU) and Plutonium obtained from tire dismantling of U.S. and former USSR nuclear weapons the urgency of nonproliferation the disposal of civilian and military nuclear waste nuclear power alternatives. 

While nuclear power plants use multiple layers of protection from the radioactive particles inside the reactor core, a serious accident can cause the release of radioactive material into the environment. It is not a nuclear explosion, because the uranium fuel used in a nuclear power plant does not contain a high enough concentration of U-235. For an explosion to occur, the uranium fuel inside the reactor would have to be enriched to about 90% U-235, but it is only enriched to about 3.5%. 

A recent and extremely important development lies in the application of the technique of liquid extraction to metallurgical processes. The successful development of methods for the purification of uranium fuel and for the recovery of spent fuel elements in the nuclear power industry by extraction methods, mainly based on packed, including pulsed, columns as discussed in Section 13.5 has led to their application to other metallurgical processes. Of these, the recovery of copper from acid leach liquors and subsequent electro-winning from these liquors is the most extensive, although further applications to nickel and other metals are being developed. In many of these processes, some form of chemical complex is formed between the solute and the solvent so that the kinetics of the process become important. The extraction operation may be either a physical operation, as discussed previously, or a chemical operation. Chemical operations have been classified by Hanson(1) as follows ... 

After the oil crisis in 1973, the need for large enrichment capacities for supply of fuel to the nuclear power plants became obvious and several European countries (Belgium, France, Italy and Spain) decided to build the huge Eurodif gas diffusion plant. This plant is located in France, in the Rhone valley, a few kilometers away from the Pierrelatte plant. Simultaneously, England, West Germany and the Netherlands (the Troika) chose to jointly develop the centrifugation process for uranium enrichment, which does not use membranes. 

---