Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Turning tool

This Rest Moves Along wiih the Turning Tool on the Opposite Side of the Work... [Pg.84]

Nipple or co)w wrench a small turning tool for securing or loosening the nipple, to and from the barrel. [Pg.151]

The abundance of simulation tools and the need to evaluate their numerous characteristics have turned tool selection into a major issue. Based on the May 1998 HE Solutions Last Word reader survey on simulation (Garnett 1999), the capabilities of a simulation tool have been ranked in order of importance by 41 participants as follows ... [Pg.2452]

A good example of recent advances is a new cermet T1500A developed by Sumitomo Electric Hardmetal Corporation (Hirose et al. 2011). T1500A was developed for steel turning tool, which has been improved in stability of finishing and the balance wear resistance and toughness while utilizing the characteristics of the cermet materials. [Pg.155]

ISO 3685 (1993-11) Tool-life testing with single-point turning tools. Beuth Verlag, Berlin... [Pg.358]

Machinability of Aluminum and Magnesium Alloys, Fig. 3 Flank buildup on turning tools after a cutting length of 750 m (Toenshoff and Winkler 1997)... [Pg.773]

Vc = 900 m/min, f = 0.4 mm, and ap = 1.5 mm for a total cutting length of Ic = 750 m. Except for the diamond-coated tools, material buildup can be found on the flank faces of all turning tools. The largest material adhesion exists on the uncoated tools. [Pg.773]

Cutting tools for use in turning may be required to cut in two directions. Such tools must therefore be provided with a rake and clearance angle for each direction of feed movement. This is illustrated in Fig. 7.7 which shows a turning tool for facing and turning. [Pg.108]

Figure 7.7. Turning tool clearance and rake angles... Figure 7.7. Turning tool clearance and rake angles...
Lubricating of the turning tool is not necessary and sometimes not permissible. In either case, a carbide-tipped or diamond-tipped tool will increase production and tool life. Dust and shavings should be removed by an efficient dust collection system. [Pg.294]

Front and side clearances should be somewhat greater than those of standard turning tools. The tools should be honed or polished to reduce frictional drag where they contact the workpiece. [Pg.294]

B94.55M-1985(R1995) Tool Life Testing with Single-Point Turning Tools Order No. M00137 32.00... [Pg.931]

See other pages where Turning tool is mentioned: [Pg.107]    [Pg.457]    [Pg.459]    [Pg.463]    [Pg.156]    [Pg.355]    [Pg.790]    [Pg.795]    [Pg.143]    [Pg.106]    [Pg.137]    [Pg.181]    [Pg.421]    [Pg.421]    [Pg.307]    [Pg.326]   
See also in sourсe #XX -- [ Pg.421 ]



SEARCH



Turning

© 2024 chempedia.info