Transport properties metals

Roland W. Oshe, ed.. Handbook of Thermodynamic and Transport Properties of Alkali Metals, lUPAC, Blackwell Scientific Publications, Oxford, U.K., 1985. 

In order to discuss electron transport properties we need to know about the electronic distribution. This means that, for the case of metals and semimetals, we must have a model for the Fermi surface and for the phonon spectrum. The electronic structure is discussed in Chap. 5. We also need to estimate or determine some characteristic lengths. 

Issi, J. -P., Transport properties of metal chloride acceptor graphite intercalation compounds. In Graphite Intercalation Compounds,... 

A certain crown ether having additional coordination sites for a trasition metal cation (71) changes the transport property for alkali metal cations when it complexes with the transition metal cation 76) (Fig. 13). The fact that a carrier can be developed which has a reversible complexation property for a transition metal cation strongly suggests that this type of ionophore can be applied to the active transport system. 

It would be preferable to incorporate both fluorescent and electron transport properties in the same material so as to dispense entirely with the need for electron-transport layers in LEDs. Raising the affinity of the polymer facilitates the use of metal electrodes other than calcium, thus avoiding the need to encapsulate the cathode. It has been shown computationally [76] that the presence of a cyano substituent on the aromatic ring or on the vinylene portion of PPV lowers both the HOMO and LUMO of the material. The barrier for electron injection in the material is lowered considerably as a result. However, the Wessling route is incompatible with strongly electron-withdrawing substituents, and an alternative synthetic route to this class of materials must be employed. The Knoevenagel condensation... 

MIM or SIM [82-84] diodes to the PPV/A1 interface provides a good qualitative understanding of the device operation in terms of Schottky diodes for high impurity densities (typically 2> 1017 cm-3) and rigid band diodes for low impurity densities (typically<1017 cm-3). Figure 15-14a and b schematically show the two models for the different impurity concentrations. However, these models do not allow a quantitative description of the open circuit voltage or the spectral resolved photocurrent spectrum. The transport properties of single-layer polymer diodes with asymmetric metal electrodes are well described by the double-carrier current flow equation (Eq. (15.4)) where the holes show a field dependent mobility and the electrons of the holes show a temperature-dependent trap distribution. 

It is difficult to measure metal/polymer Schottky energy barriers smaller than about 0.5 eV using internal pholoemission. Small Schotiky energy barriers lead to thermal emission currents produced by the absorption of light in the metal which are difficult to separate from true photocurrents 134]. If the structure is cooled to try to improve this contrast, it is often found that the significant decrease in the electrical transport properties of the polymer [27 [ makes it difficult to measure the internal photoemission current. To overcome this limitation, internal photoemission and built-in potential measurements are combined to measure small Schottky energy barriers, as described below. 

The electron transport properties described earlier markedly differ when the particles are organized on the substrate. When particles are isolated on the substrate, the well-known Coulomb blockade behavior is observed. When particles are arranged in a close-packed hexagonal network, the electron tunneling transport between two adjacent particles competes with that of particle-substrate. This is enhanced when the number of layers made of particles increases and they form a FCC structure. Then ohmic behavior dominates, with the number of neighbor particles increasing. In the FCC structure, a direct electron tunneling process from the tip to the substrate occurs via an electrical percolation process. Hence a micro-crystal made of nanoparticles acts as a metal. 

A critical review on the foundation and earlier results on metal intercalates of the transition metal dichalcogenides and related host materials can be found in the seminal paper of Whittingham [53]. The electrochemical and transport properties... 

The aim of this chapter is to acquaint the reader the physical principles of SE tunneling devices to be used in nanoelectronics. Based on this the charge transport properties of nanocluster assemblies in one, two and three dimensions will be discussed. By means of selected examples it will be demonstrated that ligand-stabilized nanoclusters of noble metals may be suitable building blocks for nanoelectronic devices. 

Lemmon, A. W Jr., H. W. Deem, E. H. Hall and J. F. Walling, 1964, The Thermodynamic and Transport Properties of Potassium, Proc. of High Temperature Liquid Metal Technology Meeting, Vol. 1, 88-114, USAEC Rep. ORNL-3605. (2)... 

---